A) If the resultant of the three forces A, B, and C is 3.6 kN and it acts along Y- axis, what is the angle theta in degrees? B) If the resultant of the three forces A, B, and C is 5.4 kN and it acts along Y-axis, what is the force C(KN) if the angle theta=45degrees? C) If the angle 0-60degrees and the force C=3kN, how much is the resultant pulling force on the eyebolt?

Q: The vertical reaction at support B is 6.53kN.  a) considering the reference at the left-hand side,…

A: Part a)Part b)

Q: 1-27, The magnitude of the vertical component of the force F of Fig. P1-27 is 160 lb. (a) Determine…

A:

Q: Determine the magnitude and orientation θ of FB sothat the resultant force is directed along the…

A: Consider the following free body diagram: Consider the resultant force to the right as follows:

Q: L. 3 kN F, F, 30°, Tom 4 m 2 m

A:

Q: Problem 2 BkN 5 kN/m A couple force acts on the beam. The couple moment at point E is found to be…

A:

Q: The two structural members, one of which is in tension and the other in compression, exert the…

A:

Q: Q.1) A bent beam is acted on by two forces and one couple moment. The 45 lb force is perpendicular…

A:

Q: SITUATION. The tower for a transmission line is modeled by the truss shown. The crossed members in…

A: Truss is formed by  members connected through smooth pin joint , members take axial load only

Q: Determine the magnitude and direction θ of FA sothat the resultant force is directed along the…

A: The free body diagram of force is shown below.

Q: | 5.14 Assuming that the reaction of the ground is uniformly dis- tributed, draw the shear and…

A: A beam with load arrangement is given as shown in the figure above and it has been asked to…

Moments

There are various practical applications of the concept of moments, like a rotation of the crank due to linear motion of the piston, the moment of inertia and its use in designing beams and columns, bending moment concept, torque, twisting moment, etc.