Answered: (a) How much heat transfer occurs to… | bartleby

Related questions

Question

(a) How much heat transfer occurs to the environment by an electrical power station that uses
1.25-10¹4 J of heat transfer into the engine with an efficiency of 44%?
|Qc|=|
J
(b) What is the ratio of heat transfer to the environment to work output?
|Qcl
W

Expert Solution

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

What is the coefficient of performance of an ideal heat pump that has heat transfer from a cold temperature of -23.0°C to a hot temperature of 42.0°C?
A heat engine operates under the following conditions: heat exchanged via exhaust Qc = -2500 J, work done W = -1000 J. What is the efficiency of the engine? %3D
5. For a system, the thermodynamic as)vn energy U is defined as a function of S, V, and n which is U(S,V,n) = kn3V 3e3nR %3D where S is the entropy, V is the volume, n is the number of moles, K is the constant, and R is the gas constant. Determine a. Based on the theory in Thermodynamics, (), T = Determine, b. Based on the theory in Thermodynamics, Pressure P = . S,n 5/8 Determine c. Determine ne d. Determine dU in dS, dV and dn
It says that this is wrong
The input power to operate a boiler comes from an electrical circuit with a voltage of 110 volts [ V ] and a resistance of 3 ohms [ Ω ]. The boiler produces 70 kilojoules of heat per minute [ k J m i n ] . What is the efficiency of the boiler, expressed as a percentage [ % ] ?
A certain coal-fired power plant has a rated power capacity of P = 850 MW. The output of this plant is W = 0.21QH, where QH is the energy input as heat from the hot reservoir. a) Which would increase the efficiency more, doubling QH or reducing QC by half? b) Calculate the maximum thermal efficiency of the power plant. c) Calculate the absolute value of the exhausted heat (QC) each second in MJ for the power plant. d) If the power plant operates for a full day at its rated capacity, how much energy QH in MJ is needed? e) If, on average, one ton of coal contains Q = 25 GJ of energy, how many tons nH of coal would the plant need to operate for a day at its rated capacity? f) How many tons nC of this coal is exhausted as wasted heat to QC in a single day?