A house painter uses the chair-and-pulley arrangement of (Figure 1) to lift himself up the side of a house. The painter's mass is 60 kg and the chair's mass is 10 kg.If the painter is at rest, what is the tension in the rope? The image depicts a person sitting on a simple pulley system. The person is seated on a platform connected to a rope that runs over a pulley fixed at the top. ### Explanation of the System:- **Pulley**: The pulley is mounted on a ceiling or beam, allowing the rope to move over it.- **Rope**: The rope passes over the pulley, allowing the person to pull one end and lift themselves with less effort.- **Platform**: The person is sitting on a platform or seat that is attached to the other end of the rope.### Functionality:This setup is an illustration of a simple machine, specifically a pulley system. It demonstrates the concept of mechanical advantage, where pulling down on the rope helps lift the person's weight more easily than lifting directly. This type of diagram is often used in physics and engineering education to teach principles of force, work, and mechanical advantage.

Answered: Image /qna-images/answer/66c2e57c-09b0-4744-bbe4-1ea2ede3989f.jpg

A house painter uses the chair-and-pulley arrangement of (Figure 1) to lift himself up the side of a house. The painter's mass is 60 kg and the chair's mass is 10 kg. If the painter is at rest, what is the tension in the rope?

A house painter uses the chair-and-pulley arrangement of (Figure 1) to lift himself up the side of a house. The painter's mass is 60 kg and the chair's mass is 10 kg. If the painter is at rest, what is the tension in the rope?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A stack of two crates is being accelerated upwards by two cables. The cables are directly attached to crate 1 and the tension in each cable is 3248 N. You may assume that the masses of the cables are negligible compared to the masses of the crates. The acceleration of the crates is? bottom crate crate 1 is 109 kg. the top crate is 248 kg.
The coefficient of kinetic friction between the 2.0 kg block in figure and the table is 0.35. What is the acceleration of the 2.0 kg block?
2B. Blocks A and B are connected by a cable that passes over a frictionless pulley as shown. If the weight of A is 200 N and the incline plane is smooth, (a) Draw the FBD of each block (b) what should be the mass of B to keep them at rest? (c) Find the magnitude and direction of the force exerted by the incline on the block
Block B hangs on a cable connected block A through a pulley as shown in the figurebelow. The two blocks are in equilibrium. Block B has a mass of 2.5 kg and the angle ofthe incline ? is 35o. A. What is the tension on the cable? (Ans: 24.5 N)B. What is the mass of block A? (Ans: 4.36 kg)
A student is hired to move an art piece. Before disconnecting the cable holding it up, you attach another such that the piece is suspended as shown in the diagram below. The weight of the piece is approximately 243 lb and the tension in cable B is 123 lb. What is the magnitude of the tension in the new cable (A) in lb?
Sneak E. Fox Scheme #2: Hoist an Acme brand anvil into the air and drop it onto the bird, using a rope over a steel shaft. The anvil is made of steel and weighs 250 lbs. How much force on the free end of the rope does it take to hold the anvil in place? how much force on the rope is required to lift the anvil into place? is the fox able to hold the anvil using the rope? Can the fox lift the anvil using the rope?
The tension T at each end of a chain has magnitude 25 N (see the figure). What is the weight of the chain?
As shown in the figure, a woman is straining to lift a large crate, but without success because it is too heavy. We denote the forces on the crate as follows: P is the magnitude of the upward force being exerted on the crate by the person, C is the magnitude of the vertical contact force on the crate by the floor, and W is the weight of the crate. How are the magnitudes of these forces related while the person is trying unsuccessfully to lift the crate? OA P=C OB.P+C>W OCP+C
Mr. Doyle is pulling his friend up a 25 degree hill in a sled. He is pulling with a force of 676N at an angle of 30 degrees to the incline. The sled starts from rest and has an acceleration of 1.24m/s squared. If the normal force is 328.8N, what is the mass of the sled? What is the coefficient of friction between the sled and the snow? How fast is the sled moving at the top of a 25.0m hill? How long does it take Mr. Doyle to transport his passengers to the top of the hill?
Two blocks of masses 20 kg and 8 kg are connected together by a light string and rest on a frictionless level surface. Attached to the 8-kg mass is another light string, which a person uses to pull both blocks horizontally. If the two-block system accelerates at 0.5 m/s 2 what is the tension in the connecting string between the blocks?
Please Answer the following question step-wise with detailed explanations. Thanks in advance? ❤️
What is the strength of the magnetic field at the center of a circular loop of wire of diameter 5.88 cm when a current of 3.48 A flows in the wire? (μ0 = 4π × 10-7 T ∙ m/A) (Use π = 3.14). Express answers in milliTeslas.