A horizontal water jet impinges against a vertical flat plate at 30 ft/s and splashes off the sides in the vertical plane. If a horizontal force of 500 lbf is required to hold the plate against the water stream, determine the volume flow rate of the water.

Q: In a U-shape pipe, water steadily flows into section 1 and discharges at section 2 and 3. The pipe…

A:

Q: Water (ρ=1000 kg/m3) flows through a pipeline with inlet diameter 10 cm and outlet diameter 5 cm.…

A: Given data as per the question inlet diameter = 10 cm  outlet diameter =5 cm The pressure at inlet…

Q: A reducing elbow is used to deflect water flow at 25 L/s in a horizontal pipe upward by an angle…

A: Given Data: Flow rate Q=25 Ls=25×10-3 m3s Horizontal pipe upward by an angle of θ=45°  The diameter…

Q: diameter pipe with a density of 0.0035 slugs/ft³ and a uniform speed of 696 ft/s. (a) Determine the…

A:

Q: A 3-in.-diameter horizontal water jet having a velocity of 97 ft/s strikes a curved plate, which…

A: The force required to hold the plate. Given: The diameter of the water jet is d=3 in=0.25 ft. The…

Q: Consider two liquids of densities p₁ = 1000 kg/m³ and p2 = 800 kg/m³ that are initially flowing in…

A: According to principle of conservation of mass, the mass can neither be created nor be destroyed so…

Q: Air at standard conditions enters the compressor shown in the figure below at a rate of 10 ft³/s. It…

A: Given: Air standard conditions of compressor Volume flow rate, Vf = 10 ft3/s Leaving pipe diamter,…

Q: 1. While watering plants, a home owner is experimenting with his water hose. He sprayed the water…

A: Answer: The plate can be suspended at the height of 3.98 m above the tip of hose.

Q: 1. Water (p = 1000- kg H = 10-3 flows in a horizontal constant-area pipe; the pipe cross ms section…

A:

Q: A tank with openings 1, 2, and 3 is moving to left at a speed of 25 km/h. Knowing that D1 = D2 = 20…

A: Consider the diagram shown below with the velocities of flow. The velocity of the tank is The…

Q: Compare the mechanical properties of a steel cable, made by twisting many thin wires together, with…

A: Both the cables have their advantages at different conditions. For the case of the tensile forces,…

Q: projectile-like object with maximum diameter of 20 cm is placed at the exit of a 25-cm-diameter…

A:

Q: A free jet of water of velocity V strikes against a series of curved semi-cireular vanes…

A: Calculate the relative velocity of the water jet when it strikes the vanes. vr1=v1-u Here, vr1 is…

Q: A 9.0-cm diameter pipe contains water with a mean flow velocity of 2.0 m/s. The pipe has a 90-degree…

A:

Q: A free water jet strikes a horizontal plate as shown. The free jet with mass flow rate of m1%3D 0.1…

A: This problem is related to fluid mechanics. Fluid mechanics is the subject of mechanical engineering…

Q: A 90° elbow is directs water upwards into the atmosphere from a horizontal pipe with a diameter of…

A:

Q: 20 cm diameter pipe carries air at 24 m / s at a pressure of 148 kpa absolute pressure and 27 ° C.…

A: Given:d1=20 cmv1=24 m/sP1=148 KPaT1=27°C =300 Kd2=10 cmT2=11°C =284 KP2=130.5 KPa

Q: As shown in the figure, water enters and leaves a U-shaped piece of pipe in the horizontal plane.…

A: Density It is the property of fluid which is ratio of mass and volume of fluid.   Continuity…

Q: The gauge pressure of water at A is 150.5 kPa. Water flows through the pipe at A with a velocity of…

A:

Q: A reducing elbow in a horizontal pipe is used to deflect water flow by an angle = 45° from the flow…

A: Inlet cross-sectional area is A1 = 150 cm2.Outlet cross-sectional area is A2= 25 cm2.The elevation…

Q: A jet engine on an airplane moving at 950 km/hr has an exit area of 0.5 m². If gas exiting the…

A: