A horizontal circular plate is supported by three wires at 18° angles to the vertical and attached to a support at D. Knowing that the x component of the force exerted by wire AD on the plate is 140 N, determine the magnitude of the tension in wire AD. The angle Theta is 54°.

Q: A frame ABC is supported in part by cable DBE that passes through a frictionless ring at B. Knowing…

A: given Tension = 385 N

Q: Three cables are used to tether a balloon as shown.  Determine the vertical force P exerted by the…

A: Given data, The coordinates of A = (0, 5.6, 0) The coordinates of B = (-4.2, 0, 0) The coordinates…

Q: A farmer uses cables and winch pullers B and E to plumb one side of a small barn. If it is known…

A:

Q: What would the approximate amperage setting be if a welder were set to the high range (150 to 350…

A:

Q: A force P of magnitude 550 lb acts on the frame shown at point E. Determine the perpendicular…

A:

Q: NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to…

A: The co-ordinates of the given points are,

Q: Q/3 A rectangular plate is supported by hinges A and B and by cables DF and DG. Knowing th the…

A:

Q: Knowing that the tension in cable AC is 300 lb, determine the smallest angle between cable AC and…

A:

Q: B 4.20 y 5.60 22C₂ 2.Cables AB, AC, and AD are used to tether a balloon. Knowing that the balloon…

A: The force exerted by ballon on A is .

Q: A disabled automobile is pulled by means of two ropes as shown. Knowing that the tension in rope AB…

A: `Given: The tension in rope AB is FAB = 3 kN. The resultant force at A is R = 4.8 kN.

Q: Knowing that a= 55° and that boom AC exerts on pin C a force directed along line AC , determine (a)…

A: Law of sines:             FACsin35=TBCsin50=1500sin95

Q: Determine the magnitude and direction of the resultant of the forces exerted by the cables at B…

A: The resultant force of two or more noncoplanar concurrent forces is given by,.....(a)where, .The…

Q: Two cables are tied together at C and loaded as shown. Determine the tension (a) in cable AC, (b) in…

A: The free diagram of the cables are shown below, Here, TAC and TBC are the tension in cable AC and…

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.