A horizontal block-spring system with the block on a frictionless surface has total mechanical energy E= 46.9 J and a maximum displacement from equilibrium of 0.201 m. (a) What is the spring constant? 1163.2 X N/m (b) What is the kinetic energy of the system at the equilibrium point? 0 X The correct answer is not zero. J (c) If the maximum speed of the block is 3.45 m/s, what is its mass? 420 x Your response differs significantly from the correct answer. Rework your solution from the beginning and check each step carefully. kg. (d) What is the speed of the block when its displacement is 0.160 m? 3.04 x Your response differs from the correct answer by more than 10%. Double check your calculations. m/s.

Q: * Two weightless bars pinned together as shown in Fig. Support a load of 35 kN. Determine the forces…

A:

Q: A Wheel barrow carries a 500 kg load by Inclining his Wheel barrow at 25" with the horizontal. If…

A: We are given the mass of load. We are also given perpendicular distance. We are given coefficient of…

Q: You are lifting a 7.6 kg wheel barrel barrel is 13 cm from the wheel and y force (in lbs) is exerted…

A: Given that mass of rock = M = 112 kgmass of barrel = m = 7.6 kghence gravitational force on earth is…

Q: An ant was minding its own business, sitting on a bicycle tire. A student got on the bike, and rode…

A: Given: Tangential Velocity,vT=9.04m/sDiameter,d=674mm=674×10-3mRadius,r=337mm=337×10-3m Tangential…

Q: The joints of the human body can be studied as levers, as can be the elbow that appears in the…

A:

Q: Need help finding forces acting on A.

A:

Q: 31. A solid cylinder rolls up an incline at an angle of 20°. If it starts at the bottom with a speed…

A:

Q: F2= 675N Fタ=ラN X = 410 B= 370 © = 300 Aneye bolt is anchored im corncuetk, Three farces are acting…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: a. O.07 I U. 11.VI AIY u. Iv.vJ N 42. A concrete block is acted upon by two tension wires by means…

A:

Q: Problem 5: L. Bone SENS Muscle 100° 30 cm 4 cm 40 cm Fm W A simplified model of a human arm holding…

A: Given:length of the forearm; l = 40cm = 0.4 mmass og the fore arm, m = 1.7 kgtherefore weight of the…

Q: 3. For the system of pulleys, weights and wires shown below, solve for the forces in each of the…

A:

Q: 14. An object is swung around on a string in a vertical circle, while its speed is slowly increased.…

A: At the bottom of the vertical circle. Since at the bottom, tension is maximum.

Q: To get a toolbox up an inclined slope, a student installs a pulley system as in the picture shown.…

A: Given: The weight of the student is 77.6 kg.            The weight of the toolbox is 19.5 kg.…

Q: what is the magnitude of the resultant force acting on the pin and the angle between the resultant…

A: From the question, it is given that- F1 = 60N along 45o with +ve x-axisF2 = 50N along 15o with -ve…

Q: F = 40 N 45° 15° F2 = 30 N 15° F3 = 25 N

A:

Q: Find the theoretical value of "x" and compare with experimental value.

A: It is given that

Q: 4. When the 6-kg box reaches point A it has a speed of VA = 2 m/s. Determine the angle at which it…

A:

Q: You can handwritten but i wont upvote. The uniform horizontal beam supporting the sign is 1.39 m…

A: Given Data:-  The length of the uniform horizontal beam b  = 1.39 m  The mass of the uniform…

Q: ) For the system shown in (FIG.) determine the resultant and locate it w.r.t. point A? 120KN

A: Draw the given diagram with resultant force and resultant moment.

Q: away at the rate of 48 fusec a. What is the rate of change of the height of the top of the ladder?…

A: Given:- L= 25 ft Vx = d(x(t))/dt = 48 ft/sec   at x= 7 ft

Q: 18. A store clerk pulls three carts connected with two horizontal cords to move products from the…

A: Given:         3 carts are connected as shown,                   m1= 15.0 kg…

Q: A block of weight = 30.0 N sits on a frictionless inclined plane, which makes an angle 8 = 21.0 with…

A:

Q: to rest after traveling d = 3.00 m along the plane, which is inclined at an angle of = 30.0° to the…

A:

Q: the two forces F= 856 N and P = 1550 N is a vertical force directed upwa %3D ure, find the magnitude…

A:

Q: Determine the magnitude of Q if the particle is in equilibrium given that e = 17.9° and P = 265.…

A: Solution attached in the photo

Q: or the truss and loading shown, determine the force (Ib) of member DG, if P = 32047 lb, Q= 35791 Ib,…

A:

Q: Mr. M is opening a physics help center! The sign looks like this The mass of his sign is 82.0kg. If…

A:

Q: Can you help with D, E, F of this problem? thank you

A: D) phase of the motion is π5 rad

Q: 1. A 1000 N billboard worker stands on a 4 m scaffold supported by vertical ropes at each end. If…

A: Using Force balance in vertical direction: T1 = tension in left wire T2 = tension in right wire T1 +…

Q: A rope attached to a 500-lb block passes over a fric- tionless pulley and is wrapped for one full…

A: (a) Given: The weight of the block is 500 lb. The coefficient of friction between the rope and the…

Q: The brakes are applied to a vehicle with a mass of 2 Mg while it is descending a l-in-7.8 gradient…

A:

Q: rom the fulcrum. Use a zero or a dash (–) when there is no second object on one side of a problem.…

A: We see in the figure which is given here  m represents mass and r represents the distance from the…

Q: 27. A meter stick is found to balance at the 49.7-cm mark when placed on a fulcrum. When a 50.0-gram…

A:

Q: Q(3): What is frictional mass in an Atwood machine? And how it is used in the calculation?

A:

Q: ma il.google.co X F Lehman Collec X The Division o X Lehman Colleu X Lehman Collec x Office of the R…

A:

Q: A carpenter holds a 15-lb 2-in. by 4-in. board as shown. If he exerts vertical forces on the board,…

A: We use the concept of equilibrium of both forces and torque here. The weight of board is given. This…

Q: The power at the MPP (Pmax) is the product of ………………………….   a.   Rmax and Imax   b.   Rmax…

A: Introduction: Maximum power point(MPP) is that point where the wattage is highest. For wattage to be…

Q: 25. A potter's wheel moves uniformly from rest to an angular velocity of 1.00 rev/s in 30.0 s. Find…

A: As per our guidelines, we are supposed to answer only first one question in case of multiple…

Q: 1. Wall-a-stick  One end of a 2.00 [m] long uniform stick is placed against a vertical wall. The…

A: Length of the meter stick = 2.00 m Co-efficient of friction between the wall and the stick = 0.530

Q: A plank is supported by the floor at one end and a vertical rope at the other end. A person has…

A:

Q: Fig. I shows a uniform ladder t Amitha lead cn it. Ii is leaning.against avreugh wertical availl.…

A: According to the condition of equilibrium, the net or algebraic sum of all forces and moment about a…

Spring Potential Energy

The potential energy is the energy possessed by a body by virtue of its position or the energy held by the object due to its position relative to other objects, its force like stresses, charge, and other factors affecting the particles of the body. The potential energy is the measure of the net work done by or on the body. The spring potential energy is the potential energy stored due to the deformation of an elastic spring and this elasticity is due to the stretched spring. The elasticity is the ability of a solid-state matter to come back to its equilibrium position or original position after any kind of external force is acted on it. It is also known as Elastic potential energy. The potential energy here is caused due to the displacement of the spring from its equilibrium position to another position and this potential energy is equal to the net work done due to the stretching of the spring. It also resembles the same mechanics of the oscillation of a simple pendulum, where due to the external force, the object moves from its equilibrium position to its maximum ends and the periodic motion continues till it comes back to the equilibrium position to rest.