A hollow tube extruded with the shape of an equilateral triangle is shown in the figure below. Its base is 4.5 in. long and its wall thickness is 0.15 in. The tube is subjected to a torque of 1000 in lbf. If the tube is fabricated from aluminium and is 38 in. long, determine the maximum value of the average shearing stress and the angle of twist of the tube. Tavg o = 1 number (rtol-0.01, atol=1e-05) number (rtol=0.01, atol=1e-05) O ksi

Q: The shaft shown consists of a steel tube (1) bonded to a brass core (2). The shear modulus of steel…

A:

Q: The following shaft consists of a 3.50 m long steel shaft and a 2.00 m long aluminum tube. The steel…

A:

Q: Q3) The aluminum tube shown in Figure (2) has a thickness of (5 mm) and outer cross sectional…

A: For equilibrium  280 = 135 + Tc Tc = 145 Nm Average shear stress τ=T2tAmMaxm τavg will be obtained @…

Q: - 150 mm - 3 mm B 200 mm A 3 mm

A: shear strain  is defined as the angular deformation of the object when subjected to  shear force…

Q: A shaft is subjected to a torque T. Compare the effectiveness of using the tube shown in the figure…

A:

Q: Consider a solid circular shaft fixed at one end and free at the other end with a concentrated…

A:

Q: What is the max shear stress in the shaft? Input your answer as a value only in MPa to one decimal…

A:

Q: 2.25. A system consists of two rigid end-plates, tied together by three horizontal bars as shown in…

A:

Q: A circular steel tube of length L = 1.5 m is loaded in torsion by torques T (see figure). (a) If the…

A: INTRODUCTION: This is the case of circular section for twist to be applied which causes the shear…

Q: The member is loaded as shown. The diameter of the member is 32 mm. 1) Calculate all internal…

A:

Methods to Determine Vertical Stress

The load applied to the soil is transferred to the underground. The presence of water at soil pores and solid grains above the soil are the primary components that are responsible for the effective load transfer. Due to the load acting, the internal component of the soil or the underground formations undergoes deformations or a tectonic shift. The amount of deformation depends upon the amount of load acting on the soil surface, which indeed, depends on the weight of everything present above the soil. Due to this, the underground soil element develops internal stresses which try to resist the tectonic changes.