(a) Given a mixture of solid potassium nitrate, solid cobalt (III) chloride, and solid lithium bromide, can one of the three components be completely separated from the other two by filtration? (b) A mixture of 800 g potassium nitrate and 200g cobalt (III) chloride is mixed with 1000 g water and heated to 100°C. Will the mixture completely dissolve? Explain. (c) If the mixture from (b) is cooled to 0°C, will the crystals collected be 100% potassium nitrate? Explain.

(a) Given a mixture of solid potassium nitrate, solid cobalt (III) chloride, and solid lithium bromide, can one of the three components be completely separated from the other two by filtration? (b) A mixture of 800 g potassium nitrate and 200g cobalt (III) chloride is mixed with 1000 g water and heated to 100°C. Will the mixture completely dissolve? Explain. (c) If the mixture from (b) is cooled to 0°C, will the crystals collected be 100% potassium nitrate? Explain.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

1. CH3OH (shown below) is soluble in water. Draw molecular level pictures representing: (a) a container with only CH3OH (several molecules) before mixing and (b) after CH3OH is dissolved in water H H-C H 2. MgCl₂ is an ionic compound that is soluble in water. Draw a molecular level picture that represents after MgCl2 is dissolved in water. H— :0:
Calculate the molarity of the following solutions: (a) 0.31 mol of solute in 84.7 mL of solution (b) 1.59 mol of KBr in 0.81 L of solution (c) 34.2 g of NaC2H3O2 in 1.93 L of solution (d) 70 . g of CuSO4 · 5H2O in 2.1 L of solution
Because of the toxicity of mercury compounds, mercury(I) chloride is used in antibacterial salves. The mercury(I) ion Hg22+ consists of two bound Hg+ ions.How many grams of mercury(I) chloride are needed to saturate 4900 km3 of water (the volume of Lake Michigan)? (Ksp = 1.5 × 10−18) .
Suppose you had a sample of a white crystalline solid that was a mixture of calcium carbonate and calcium chloride. Describe how you could treat the sample to isolate one of the solid in the pure state. Which solid would it be.
A chemist prepares a solution of zinc oxalate ZnC2O4 by measuring out 0.00201μmol of zinc oxalate into a 300.mL volumetric flask and filling the flask to the mark with water. Calculate the concentration in /μmolL of the chemist's zinc oxalate solution.
A total of 10.0 g of potassium permanganate, an ionic compound with chemical formula KMnO4, is dissolved in water such that the final volume of the solution is 850 mL. What is [KMNO4] in that solution?
The dense vapor iodine heptafluoride reacts rapidly with water to give a mixture of periodic acid and hydrofluoric acid .(a) Write a balanced chemical equation for this reaction. (b) Determine the concentration (in moles per liter) of each of the acids that result from the complete reaction of 4.07×10-2 moles of iodine heptafluoride with enough water to give a solution volume of 620 mL.periodic acid : Mhydrofluoric acid : M
Hydrobromic acid dissolves solid iron according to the following reaction: Fe(s)+2HBr(aq)→FeBr2(aq)+H2(g) A.) What mass of HBr (in g) would you need to dissolve a 2.6−g pure iron bar on a padlock? Express your answer using two significant figures. B.)What mass of H2 would be produced by the complete reaction of the iron bar? Express your answer using two significant figures.
Determine the volume of 0.116 M Li3PO4 and 0.0871 M Mg(C2H3O2)2 solutions needed to form 135 g of precipitate when mixed. Write the balanced chemical equation.
A precisely measured volume of 250.0 mL of a saturated NaCl(aq) solution at room temperature is heated to evaporate the solvent and crystallize the solute.The mass of the dry solute is measured to be 88.8 g. What is the solubility of the sodium chloride solution?
2. For oxygen to dissolve in water, it needs to be soluble. Solubility is the ability of a substance to dissolve into a liquid. Oxygen can dissolve into water in multiple ways; namely, oxygen can diffuse from the atmosphere and dissolve in the water, and/or it can be introduced into water as a byproduct from the photosynthesis of aquatic plants. Wind helps with the first method, as it aerates the water, which helps the oxygen to dissolve. Since dissolved oxygen is needed by all forms of aquatic life, it is often used as one measure to determine the health of bodies of water. What do you think would happen if there was not enough dissolved oxygen in a lake? There would be no effect on the lake. Fish would not get enough oxygen and could die. The diversity of aquatic organisms would increase.