A generation station has the following daily load cycle: Time (h) 0-6 6-10 10-12 12-16 16-20 20-24 Load (MW) 40 50 60 50 X 40 Find the value of X, if the units generated between 3pm to 11pm is 290000. Draw the load duration curve.

Q: 4.A generating station has the following daily load cycle : Time (Hours) 0-6 6-10 10-12 12-16 Load…

A: In the generating system,  Daily load curve data are given Find the maximum demand Energy per day…

Q: Draw, on the Same graph, the lo ad chavacteristics listed in the table what do you learn from the…

A: The load characteristic is the relationship between the quick pear values ​​of the variable load and…

Q: power station has this daily load curve data (a) Draw the daily load curve. (b) Draw the load…

A: Answer shown below

Q: sformer 1200 KVA, 11000/2200 V, 50 Hz e reactance/phase of the primary winding ar ding values for…

A:

Q: a) Find the ICA load current b) Give the voltage Vab c) Calculate the total complex power on…

A: a) Find the ICA load current b) Give the voltage Vab c) Calculate the total complex power on voltage…

Q: Q1. A supply system feeds the following loads (i) a lighting load of 500 kW (ii) a load of 400 kW at…

A: In the question, 5 loads are connected to parallel each other. Find the power factor of the…

Q: For the following circuit, determine the maximum power, PMax in Watts that can be transferred to the…

A:

Q: i(t) Find rms value of given current waveform. HAA 10 2 4 6 8 10 -10

A: RMS of AC is that value which when passes through a resistor of known value for a particular…

Q: Determine the apparent power, active power and reactive power in a series circuit, when the supply…

A:

Q: 27 in crlinr cal rotor SYchronous Genrator (8) what is the relation Bet ween the Angle( in the Plot…

A: There are leading and lagging Power factor phasor diagrams given.

Q: Q1/ Find the RMS value of lo in the unbalanced three-phase circuit. 0.40 j20 a 1.60 j4 A 780 1540…

A: The solution can be achieved as follows.

Q: What is the difference between single-phase and three-phase alternating current? Select one: A.…

A: Single-phase supply consists of the two power legs - Phase and Neutral  Three-phase supply consist…

Q: A power station has the following daily load cycle: Time (Hours) 0-6 6-10 10 - 12 12 - 16 16– 20 20…

A:

Q: In class B chopper, which of the given statement is true The value of On time is always less than…

A: The formula for output voltage in step up chopper is, Vo = Vin/(1- delta)-----(1) Delta is the duty…

Q: An alternating current completes 5 cycles in 8 ms. What is its frequency?

A: Number of cycles = 5 Time = 8ms

Q: Copper losses in a generator vary with load

A:

Q: A generating station has the following daily load cycle :Time (Hours) 0-66-10 10-12 12–16 16-20…

A: In this question we will solve daily load curve .

Q: The power input measurement to a synchronous motor is done using the two- wattmeter method. Each of…

A: This question belongs to measurements and instrumentation . It is based on the concept of two…

Q: A tree-phase generator has a load 100 kw per phase at a power factor 80 percent,lagging what is the…

A: The active power consumed by a 3ϕ load is equal to the sum of active power consumed by each load.…

Q: Determine the generator resistance if the noise factor is 3 and the equivalent noise resistance is…

A: Given data, Noise factor = 3 Equivalent noise resistance = 10 kΩ

Q: 10. Naghsh-Jahan Generation owns three generating units that have the following cost functions: Unit…

A: The generation cost is minimum when the incremental fuel cost of all the units are equal i.e.…

Q: The reactance of a generator is given as 0.25 pu based on the generator of 13 KV, 200 MVA. Determine…

A: Given, Reactance, Xg(old)= 0.25 pu Voltage, kV(old)= 13 kV Apparent power, MVA (old)= 200 MVA Base…

Q: The incremental cost characteristics of t generators delivering 200 MW are as follows: dF2 dP ah =…

A:

Q: See the picture the haight between A &E is:

A: Consider the waveform given.

Q: The load sharing between two parallel connected synchronous generators may be adjusted by varying…

A:

Q: A generation station has the following daily load cycle: 20-24 16-20 12-16 10-12 6-10 0-6…

A: we need to find out the value of X, and need to draw the load duration curve.

Q: In class B chopper, which of the given statement is true The value of On time is always less than…

A: Class B chopper is basically equivalent to step up chopper The circuit diagram of class B chopper…

Q: Plant A - 150kVA, 0.68pf lagging Plant B - 70kVA, 0.65pf lagging It is desired to correct the power…

A:

Q: determine the current in each branch using Nodal Analysis

A: It is given that: Zx=100∠0°

Q: How many hours C O A) 0-24 O B) 0-48 O9 0-12 O D) 0-72 O E 02

A: UPSs generally feed their loads for 0-2 hours

Q: A generating station has the following daily load cycle : Time (Hours) 0-6 6-10 10-12 12-16 16-20…

A: This question belongs to power system . It is based on the concept of load curve . By making load…

Q: * Two generators, rated at 100 MW and 400 MW, are supplying power to a network. The system frequency…

A: we need to tell the value of droop R of the 100MW generator.

Q: The reactance of a generator is given as 0.55 pu based on the generator of 21 KV, 350 MVA. Determine…

A:

Q: What are factors on which induced EMF of an alternator depends?

A: INDUCED  EMF=4.44FφNKpKdF= frequencyφ=fluxN=speedKp=Pitch FctorKd=Distribution factor

Q: A charge of 3500 VA to a with a power factov of 0,70 leading, connected of 50 Hz and Voltage of 23O…

A: The solution can be achieved as follows.

Q: on A Load absorbs 10 KVA at a leading power factor of 0.6 The complex power is: Select one: O a…

A: The is a problem of circuits.  Given:- Load power |SL|= 10 kVA  Power factor, cos(phi)= 0.6 leading…

Q: What are these load profiles? Explain their differences. Why is it important to know these load…

A: Load Profile: These load profiles are the graphs between the electrical peak load versus time. It…

Q: An electrodynamometer type wattmeter is used to measure power in 1-o circuit. The connected load…

A: The solution is given below

Q: Q1) A system consists of two generators. Data of these generators as follow GI has 30 MW capacity…

A: Answer (A) From the data of G1 which is having 30 MW capacity  and the failure rate is 0.38day and…

Q: The slip rings ause a d.c enerator to

A: Slip ring is a closed circular ring with the brushes connected to outer surface. In case of AC…

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.