A generating station has a maximum demand of 75MW and a yearly load factor of 45%. Annual Generating costs inclusive of station capital costs are 1200 Dinars/kW demand plus 80 Dinars/kWh transmitted. The annual capital charges for transmission system are 40 million Dinars and for distribution system 30 million Dinars ; the respective diversity factors being 1:3 and 1:4. The efficiency of transmission system is 90% and that of the distribution system inclusive of substation losses is 85%. Find the yearly cost per kW demand and cost per kWh supplied : (1) at the substation (2) at the consumers premises.

A generating station has a maximum demand of 75MW and a yearly load factor of 45%. Annual Generating costs inclusive of station capital costs are 1200 Dinars/kW demand plus 80 Dinars/kWh transmitted. The annual capital charges for transmission system are 40 million Dinars and for distribution system 30 million Dinars ; the respective diversity factors being 1:3 and 1:4. The efficiency of transmission system is 90% and that of the distribution system inclusive of substation losses is 85%. Find the yearly cost per kW demand and cost per kWh supplied : (1) at the substation (2) at the consumers premises.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A 4-bus three-phase power system consists of the following equipment: • Generator 1 connected to bus 1 with a rated power of 20MVA, rated voltage of 20 kV, and a series reactance of 0.4 p.u. • Generator 2 connected to bus 5, with a rated power of 12MVA, rated voltage of 10 kV, and a series reactance of 0.3 p.u. Transformer 1 connected between buses 1 and 2, is wye-wye connected with a rated power of 20 MVA, rated voltages 20/100 kV, and a series reactance of 0.1 p.u. • Transformer 2 connected between buses 4 and 5, is wye-wye connected with a rated power of 12 MVA, rated voltages 12/110 kV, and a series reactance of 0.15 p.u. • Transmission Line 2-3 connects buses 2 and 3 and had a series impedance of 50 + j75 ohms. • Transmission Line 3-4 connects buses 3 and 4 and had a series impedance of 40 + j80 ohms. • Load A connected to bus 3 and abosorbes20 MW and 10 MVAR. The voltage at bus 3 is 105 kV. 1) Draw the one-line diagram for the system. 2) Draw the per-unit, per phase…
3) A three-phase transformer of 60 kVA (three-phase power), 13200/480 V (line A line) in delta-strella connection has a resistance of 0.02 PU and a reactance of 0.08 PU. For this transformer, calculate: a) The voltage regulation at full load and F.P. 0.85 in delay. (b) The regulation of voltage voltage to full cargo and F.P. Unitarian. c) The voltage regulation at full load and F.P. 0.85 in advance.
Determine the reliability of the complex system shown if the failure rate of each component is 0.02. (c)
Each line of a three phase system is suspended by a string of three similar insulators. If the voltage across the line unit is 16.5 kV, calculate the line to neutral voltage. Assume that the shunt capacitance between each insulator and earth is 1/8th of the capacitance of the insulator itself. Also find the string efficiency.
3 Two units of generation maintain 132 kV and 120 kV (line) at the ends of an interconnector of inductive reactance per phase of 40V and with negligible resistance and shunt capacitance. A load of 22 MW is to be transferred from the 132 kV unit to the other end. Calculate the necessary conditions between the two ends, including the power factor of the current transmitted.
The interconnected system has the following advantages. It increases the service reliability and any area fed from one generating station during peak load hours can be fed from the other generating station. Select one: a. False b. None of the above c. True
the distribution of loads among the generating units is called as economic dispatch. Select one: True False
Q2: The constants of a 275 KV transmission line are A = 0.8525° and B = 200275° 0/phase. Draw the circle diagram to determine the power and power angle at unity power factor that can be received if the voltage profile at each end is to be maintained at 275 KV. What type a rating of compensating equipment will be required if the load is 150 MW at unity power factor with same voltage profile. (5.5 mark)
A system consists of four idenital 400 MVA generating units feed- ing a total load of 1016 MW. The intertia constant of each unit is 5 on 400 MVA base. The load changes by 1.5% for a 1% change in frequency. When there is sudden drop in load by 16 MW, obtain the power system time constant (T) with constants H and D expressed on 1600 MVA base.