A gas storage cylinder in an ordinary chemical laboratory measures 7.5 cm wide and 30. cm high. This is the label on it. Contents: N, gas 圖 Pressure: 24.8 atm If the cylinder is opened and the gas allowed to escape into a large empty plastic bag, what will be the final volume of nitrogen gas, including what's collected in the plastic bag and what's left over in the cylinder? Write your answer in liters. Be sure your answer has the correct number of significant digits. dlo ?

A gas storage cylinder in an ordinary chemical laboratory measures 7.5 cm wide and 30. cm high. This is the label on it. Contents: N, gas 圖 Pressure: 24.8 atm If the cylinder is opened and the gas allowed to escape into a large empty plastic bag, what will be the final volume of nitrogen gas, including what's collected in the plastic bag and what's left over in the cylinder? Write your answer in liters. Be sure your answer has the correct number of significant digits. dlo ?

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

What are the partial pressures of the gases? If the gas was consumed completely, put 0 for the answer. atm PNO atm Po, Incorrect atm PNO, Incorrect
A gas storage cylinder in an ordinary chemical laboratory measures 2.5 cm wide and 10. cm high. This is the label on it. Contents: N, gas Pressure: 17.8 atm If the cylinder is opened and the gas allowed to escape into a large empty plastic bag, what will be the final volume of nitrogen gas, including what's collected in the plastic bag and what's left over in the cylinder? Write your answer in liters. Round your answer to 2 significant digits. L x10
A gas storage cylinder in an ordinary chemical laboratory measures 7.1 cm wide and 28. cm high. This is the label on it. Contents: N₂ gas Pressure: 16.2 atm If the cylinder is opened and the gas allowed to escape into a large empty plastic bag, what will be the final volume of nitrogen gas, including what's collected in the plastic bag and what's left over in the cylinder? Write your answer in liters. Be sure your answer has the correct number of significant digits. L x10 X S
A container of N,0,(g) has a pressure of 0.445 atm. When the absolute temperature of the N,O,(g) is tripled, the gas completely decomposes, producing NO, (g) and NO(g). Calculate the final pressure of the gas mixture, assuming that the container volume does not change. final pressure: atm
The diagram below shows a gas with an initial pressure of 4.0 atm in a cylinder at a constant temperature.The gas expands inside the cylinder and pushes the piston up. What is the final pressure of the gas after the expansion?
A bottle of N2O3(G) has a pressure of 0.475 atm. When the absolute temperature of the N2O3 (G) is tripled, the gas completly decomposes, producing NO2 (g) and NO(G). Calculate the final pressure of the gas mixture, assuming that the bottle volume does not change. Answer should be in atm.
#13: Two containers of identical volume are connected by a tube with a stopper to prevent gases inside the tanks from mixing with each other. Container A has a pressure of 2.00 atm and a volume of 10.0 L while container B has a pressure of 4.00 atm and a volume of 10.0 L. Both containers have an initial temperature of 27.0 °C and were then heated to 127 °C. Upon reaching 127 °C, the stopper was released. What is the new pressure in both containers after the stopper was released?
Dinitrogen monoxide gas is collected at 28.0 °C in an evacuated flask with a measured volume of 30.0 L. When all the gas has been collected, the pressure in the flask is measured to be 0.290 atm. Calculate the mass and number of moles of dinitrogen monoxide gas that were collected. Be sure your answer has the correct number of significant digits. mass: g dlo mole: |mol I Don't Know Submit O 2021 McGraw Hill LLC. All Rights Reserved. Terms of Use | Privacy Center | Accessibility
2. Sodium sulfide (0,1159 g) and excess hydrochloric acid were reacted together to form 35.75 mL of an unknown gas. The gas was collected over water when the atmospheric pressure was measured to be 767 mmHg. The temperature of the water was 23.0°C. Determine the molar mass, as well as identity, of the gas. Hint: You will need to reference your textbook for the vapor pressure of water.
#14
A sealed 2.0L container at 380 K is filled with 0.75 g of hydrogen gas and 3.25 g of oxygen gas and combusted to produce water vapor. what is the partial pressure of hydrogen gas after combustion if the temperature is maintained at 380 K there is no hydrogen gas left over since oxygen gas is the limiting reactant 2.63 atm H2 4.55 atm H2 5.80 atm H2 none of the above
In a fixed volume container at 25°C, NO2 gas partially combines to form N2O4 gas. The mass percentage of N2O4 in the resulting mixture is 76.3%, and the total pressure is 0.500 atm. What is the partial pressure of N2O4? A. 0.309 atm B. 0.619 atm C. 0.192 atm D. 0.119 atm E. 0.382 atm