A garden hose attached with a nozzle is used to fill a 40-liter bucket. The inner diameter of the hose is 2.0 cm, and it reduces to 1.0 cm at the nozzle exit. If it takes 58 s to fill the bucket with water, determine (a) the volume and mass flow rate of water through the hose, and (b) the mean velocity of water at the nozzle entry and exit.

Q: Using the situation below, how would I determine the net resultant force exerted on the reducer by…

A: Given Data The diameter of the pipe is: d=25 cm The velocity of the water is: v=8 m/s The pressure…

Q: Water is flowing into a factory in a horizontal pipe with a radius of 0.0223 m at ground level. This…

A:

Q: Water is being drained through a hole at the bottom of a tank at a velocity of 10 m/s. For a tank…

A:

Q: A boiler requires 100 000 m3/hr of standard air. The mechanical efficiency of fan to be installed is…

A: Given data: V˙=100,000 m3/hr=27.78 m3/shw=160 mm=0.16 mη=70% Need to determine the size of driving…

Q: Water is pumped through a pipeline to a height of 10 m at the rate of 0.1 m³/s, friction and other…

A: Pumping height H=10 mTotal head loss hf=5 mRate of flow Q=0.1 m3/sUnit Weight of Water To Find-The…

Q: Water enters a tank of diameter DT steadily at a mass flow rate of m . in. An orifice at the bottom…

A: Consider the diagram shown below for the given system. Let us consider that the maximum height of…

Q: Air (density 1.2 kg/m³) flows through a horizontal pipe with negligible energy loss due to friction.…

A:

Q: 8. An open water tank has two inlets and one outlet. The water flow rate through the two inlets are…

A:

Q: Water flows through a pipe at 130 L/s that changes gradually in diameter from 154 mm at point A to…

A:

Q: At the bottom of a pressurized water tank is a mouth with a diameter of 5 cm, where water is…

A: Fluid is a state of matter which deforms continuously on the application of force externally,…

Q: water circulates throughout a house in a hot water heating system. if the water is pumped at a speed…

A:

Q: Air flows steadily at low speed through a horizontal nozzle (by definition a device for accelerating…

A: The pressure, speed, and height (y) at two points in a steady-flowing, non-viscous, incompressible…

Q: Water (modeled as an incompressible substance) flows steadily through a circular pipe of total…

A: Total length of the circular pipe, L=10 mMass flow rate through the pipe, m=2 kg/sTemperature drop…

Q: A venturi meter is placed in a pipe to measure the flow of oil with a specific gravity (SG) of 0.9…

A:

Q: Water vapor, whose pressure is 650 kPa and temperature 573 K, enters a well-insulated device at a…

A: Initial pressure of vapor(P1) = 650 KPaFinal pressure of vapor(P2 ) =  130 KPaInitial temperature of…

Q: A boiler is being fed by a conical tank seen in the figure. The piping between tanks is through a…

A:

Q: A 4-ft-high, 3-ft-diameter cylindrical water tank whose top is open to the atmosphere is initially…

A: Given data : The diameter of the water tank (Dtank) = 3 ft height of the water tank (ho) = 4 ft The…

Q: A pressurized tank of water has a 10-cm-diameter orifice at the bottom, where water discharges to…

A: In order to proceed with the given problem, the following assumptions need to be taken into…

Q: A hemispherical tank of radius 3m is filled with 4500 liters of water. Find the time it will take to…

A: Given : r = 3 m V = 4500 L = 4.5 m3 P = 10 kW To find : Time taken

Q: 1)Determine the mass flow rate in lbm/s of a liquid (ρ = 0.8 g/cm3) flowing through a 2 in (inside…

A:

Q: A water is flowing through the duct having daimeter 15 cm and length 15 m. The inlet temperature of…

A: