Answered: A galvometer with a full- scale… | bartleby

Related questions

Question

A galvometer with a full-
scale sensitivity of 500 mA and a coil resis-
tance of 60 is to be used to build an ammeter designed t
o read 5.0 A at
full scale. What is the required shunt resistance?

Expert Solution

Step by step

Solved in 3 steps with 8 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

A galvanometer has a full-scale deflection current of 5 mA and an internal resistance of 40 N. It is intended to use it, first, as a voltmeter reading to 20 V, then as an ammeter reading to 10 A. Draw circuits enabling these two functions and calculate the required component values.
Se
the 1.00 mA,20 2 of 0 to 50.0 mA? What shunt resistance is required to make galvanometer into an ammeter with a range
A 150 μA full scale galvanometer is used as a 3.00 A full scale ammeter when shunted by 3.3 Mega-Ohm. What is the coil resistance of the galvanometer?
2. For a real battery of emf E and an internal resistance of r, find the "load resistance" RL which maximizes the power delivered to that load.
In the figure, the total resistance is 10kΩ, and the battery's emf is 20.0 V.If the time constant is measure to be 20.0 μseconds, calculate the time it takes for the voltage across the resistor to reach 15.0 V after the switch is closed.
Q-18: A galvanometer has resistance of 30 ohm and it can give full scale deflection for 25 mA. What will be the value of shunt resistance in order to change in to Am-meter which can measure maximum 5A current?
For a certain electric circuit, the current (in A) is given by i=1.45e-74.1t sin 212t, where t is the time (in s). Find di dt the expression for dt (Round to one decimal place as needed.) E L m R C
A galvanometer has a coil resistance of Rgaly I = 2.55 A. If the galvanometer deflects full scale for a current of Igalv 45.2 Q. It is to be made into an ammeter with a full-scale deflection equal to 175 mA, what size shunt resistor should be used? size of shunt resistor: Ω
What is the emf ɛx of a cell being measured in a potentiometer, if the standard cell's emf is 12.0 V and the potentiometer balances for Rx = 5.50 N and Rs = 1.90 N? V
What is the sensitivity of the galvanometer (that is, what current gives a full-scale deflection) inside a voltmeter that has a 1.00-M Ω resistance on its 30.0-V scale?
A galvanometer has a coil resistance of Rgaly = 41.4 Q. It is to be made into a voltmeter with a full-scale voltage equal to = 115.5 mA, what size additional resistor should V = 155.0 V. If the galvanometer deflects full scale for a current of I galv be used? additional resistor size: Ω

SEE MORE QUESTIONS