A full wave rectifier uses a centre - tap transform whose turns ratio to half secondary is 10:1and is supplied with 230 V at 50 Hz. The load resistance is 50 Q. Calculate the load voltage and the ripple voltage. If now a capacitor of 470 µF.is used as a filter, recalculate the load voltage and the ripple voltage. assuming same load current.

Q: What are the main differences between the D-MOSFET and E-MOSFET amplifiers?

A: MOSFET The metal oxide semiconductor field-effect transistor (MOSFET) is a type of transistor in…

Q: Discuss the situations where instrumentation amplifiers are required

A: given data :  circuit diagram of instrumentation amplifier. To Find :  the situations where…

Q: Problem 6 Find output voltage to the difference amplifier circuit shown in the figure given two…

A:

Q: The load voltage waveform of a single phase full bridge inverter supplied from 30OV DC voltage…

A: Given:

Q: z transformer

A:

Q: Related Problem Determine the average value of the half-wave voltage if its peak amplitude is 12 V.

A: Peak amplitude Average value of half wave voltage

Q: (a) Calculate the directivity for n = 1, 2, and 3

A: Since you have asked four questions, we will solve the first question for you. If you want the other…

Q: A reactance, either capacitive or inductive, placed in series with an AC signal can be used to…

A:

Q: The input resistance of the LF356 is≈ 10¹2 №, much greater than any resistor likely to be placed…

A: The  is a JFET-input operational amplifier (op-amp) that is known for its high input impedance. An…

Q: A single phase 208V AC control power to R=4 2 load if the desired output power is 3 KW, determine…

A: Given data: The voltage supplied, V=208 V. The load resistance, R=4 Ω. The desired output power,…

Q: A common emitter amplifier has a voltage gain of 50, an input impedance of 100 2 and an output…

A:

Q: The gain of an AC inverting amplifier with a -3dB frequency of 10kHz is measured at 300HZ to be…

A:

Q: Explain how an AM signal is produced using a collector modulator.

A: How an AM signal is produced using a collector modulator.

Q: An unknown load ZL is attached to a 75 Q air-spaced and lossless slotted line. Using a 150 MHz…

A: To calculate the position of the first voltage standing wave minimum on the slotted line, we can use…

Q: Consider a common-emitter BJT amplifier circuit in Figure 3. Assume that Bac = 100 remains constant…

A: Given that, re=10 Ω and β=100. D.C parameters are already given so DC analysis can be skipped. But…

Q: Question 4 What is the common mode input voltage, Vicm? Question 5 What is the differential input…

A:

Q: Assuming the R and C values are different for Circuit 1-4, while the value of L and the peak-to-peak…

A: Current is given as Vm/√(R2+(wL-1/wC)2). Peak current is at resonant frequency when wL = 1/wC. So…

Q: Q3/ For the emitter-bias BJT find: (a) B; (b) Vcc: (c) RB given the following information: Rc = 2.7…

A: Given : RC=2.7kΩ, RE=0.68kΩ, VCE=7.3V, VE=2.1V, IB=20μA 3)  (a) In an emitter bias BJT, the voltage…

Q: . Design a multivibrator circuit to produce 12V p-p (0-12), 0.2 duty cycle, 2k Hz fro 2k Hz, 0.5…

A: The design considerations are, Thigh is 0.693(Ra+Rb)C The discharge of capacitor through Rb T low is…

Q: What is the quiescent output voltage of the amplifier shown below? Give your answer in Volts to 2…

A: The dc voltage at an output terminal with reference to a common terminal, normally ground, when no…

Q: A truck is to be loaded onto a ship by a crane that exerts an upward force of 31kN on the truck.…

A:

Q: Problem H a) Determine the closed-loop 3-db bandwidth. The op amp has a unity-gain frequency of 0.8…

A:

Q: For the given circuit for a 40 V (p-p) sinusoidal input vi, what is the value of vi at which the…

A: From the given circuit the diode will be in the forward bias when vi < 5 V. And for vi > 5 V…

Q: A firing angle controlled triac is feeding a single-phase R-L load with L=15 mH and R=11 ohm.The…

A: A triac is feeding a single-phase R-L load with Voltage  V=220V and 60 Hz Determine: a) Minimum…

Q: A 50 cycle A.C. supply is supplied to a 1 circuit having an inductance of Henry and resistance 2kN.…

A: Impedance is a measurement of electrical resistance.

Q: The in the figure below is designed to equency sighals, Impeding their transmission between cireult…

A:

Q: Problem 1: A certain circuit breaker trips when the rms current becomes 14.5 A. Randomized Variables…

A: Rms current (Irms14.5 A

Q: A simple difference amplifier circuit is shown in Figure 4.1. Why would replacing the common…

A: Normally difference amplifiers are meant to reject common-mode signals, especially when they are…

Q: difference amplifier circuit

A:

Q: The change in output voltage, SE, , from a 1/4 arm Wheatstone bridge circuit is 299 micro-volts.…

A:

Q: Considering a frequency-division multiplexing system where a baseband signal from sending end is…

A: The corresponding RC bandpass filter is shown below:

Q: A 10 mv, 2kHz sinussoidel signal is applied to the input of an op - Amp integrator having

A:

Q: Color code value as 2 k Ω± 5% Color coding of a read resistor do you do?

A: given :-  color code value = 2 k Ω ± 5 %                               = 2000 Ω ±5%

Q: For the amplifier shown in Figure 1, the BJT parameters are ß = 75, Vaz (on) = 0.7 V, VCE (sat) =…

A: