A full-wave rectifier operating from the 60-Hz ac supply produces a 20-V peak rectified voltage.If a 200-uF capacitor is used, calculate the ripple at a load of 120 mA.Ripple- 1.44A Full wave rectifier operating from the 60Hz acsupply produces a 20-V rectified voltage. If a 200-uFcapacitor is used, calculate the ripple at a load of 120mA

In this question We need to determine the ripple at the load. We know, Output average voltage of…

Answered: A Full wave rectifier operating from…

A Full wave rectifier operating from the 60Hz ac supply produces a 20-V rectified voltage. If a 200-uF capacitor is used, calculate the ripple at a load of 120 mA

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 420 ohm 30 V Voltage 1,(max) = 80 mA 0.6 V 2.2 kohm Vp-out Vp-in Zener Current Answer the following…

Q: 1. How great is the number of pulses in the three - phase half-wave rectifier?

A: The diagram in this experiment shows a 3-phase half-bridge half wave diode rectifier. The circuit is…

Q: The input to a full-wave rectifier is 40 V AC (RMS). The load resistor is 10 ohms. The DC voltage at…

A: The input to a full-wave rectifier : V=40 V (rms)and Load resistance RL=10 ΩThen DC voltage at the…

Q: Design a half-wave rectifier with a capacitor filter that will deliver to the load an average…

A: The generalized circuit of HWR with capacitive filter Let the operating frequency of the…

Q: The RMS output voltage ofa Full-Wave Bridge Rectifier is 20 volts, Calculate the average current (in…

A: for full bridge rectifier RMS value of output voltage Vrms= Vm2…

Q: Q6 A full-wave rectifier is powered with 24V rms. What is the average current through a 1.2 K2…

Q: ) Determine the ripple factor for the filtered bridge rectifier with a load as indicated in the…

A: Given Data: turns ratio = 17:17 = 1 Vrms = 36 V RL = 220 kohm C = 10000 uF

Q: can vary between: ww VI Oa 151.80 Ohm, 2211.00 Ohm Ob. 129.80 Ohm, 2189.00 Ohm Oc 163.80 Ohm,…

A: In this question , we will find input resistance minimum and maximum value for zenwe diode..

Q: A full-wave rectifier produces a 20V peak rectified voltage from a 120Hz ac source. If a 1000μF…

A: In this question, We need to determine the dc output voltage Vo for RC full wave rectifier. Vo =…

Q: A diode has forward characteristics as follows: Table 1 V (V) | I (A) 0.50 0.75 1.00 1.25 1.50 1.75…

A: We use forward characteristics table of diode to solve this question.

Q: Q: A full-wave rectifier produces an 80 V peak rectified voltage from a 60 Hz ac source. If a 10 uF…

Q: Trace the output of the network if the input is a 30V triangle wave, repeat for a sine wave of 8V .…

A: In the circuit, 2 zener diode is connected to back to back. Draw the output waveform 1. f the input…

Q: A 3 phase half wave controlled rectifier has a 3 phase line to line supply voltage of 420 V rms at…

A: Given, Vrmsline=420 Vα=70∘ Vrmsphase=Vrmsline2=4202V

Q: 2 a) Name of the Circuit? (Assume Silicon Diodes) 4:1 D b) Find the peak input voltage to the 120 V…

A: As per the guidelines of Bartleby we supposed to answer first three subparts of the question for…

Q: Q1(B) Prove that the single phase half wave rectifier with load inductive that:- [1+cos(+0)] vde…

A: Step 1: Step 2: Step 3: Step 4:

Q: (in amperes) flowing into the load resistor with 2.5 kiloohms resistance. O 0.00386 O 0.00720…

Q: 3. A halfwave rectifier(HWR) has an AC input of 14.14Vrms. A Si diode rectifier is connected such…

A: First we have to convert the rms value into DC value so, Vdc=Vrms*2

Q: ... 0.25 A 120 V 60 Hz RL 1 k2 470 μF When the circuit is working normally, it has an rms secondary…

A: Diode maintains 0.7 volts across it when diode is conducting. Calculate peak value of voltage at…

Q: For a certain 12 V zener diode, a 10 mA change in zener current produces a 0.05 V change in zener…

A: Given data, Change in Zener current △I=10 mA=0.01 A. Change in Zener voltage △V=0.05 V.

Q: Calculate the ripple voltage of a full-wave rectifier with a 150 µF filter capacitor connected to a…

Q: CHOICES: Oa. Ob. QUESTION #4. Assuming ideal diodes, select from the choices shown the output…

A: As given diode is ideal. Forward voltage drop of ideal diode is 0V i.e. act as short circuit.…

Q: In a pn junction, forward-biased current is mainly due to neither majority nor minority carrier…

A: Question (1): We need to tell in a p-n junction forward biased current flows due to which…

Q: Find the range of values that will keep the zener diode “on” (operating) in the figure. (Plot the…

Q: In a full wave bridge rectifier, if one diode is damage, this gives: A) The circuit will not work B)…

A: The solution can be achieved as follows.

Q: ner queston Will save this response. Quèstion 6 Power supply circuit is delivering 0.5 A and an…

A: From the given observation we can say that the given circuit is a half wave rectifier with capacitor…

Q: A 3 phase half wave controlled rectifier has a 3 phase line to line supply voltage of 420 V rms at…

A: In this question we need to find a average output voltage

Q: 12 V battery is supplied by a single-phase 60 Vrms AC supply through a 4.26 Ohm resistance and a…

Q: Calculate the currents I1, 12 and 13 using the modified diode model (non-ideal, VD = 0.7V) for the…

A: The solution can be achieved as follows.

Q: A Fullwave rectifier supplies a load of 1k02. The a.c voltage applied to the diode is 220 volt rms.…

A: A fullwave rectifier- Load RL=1 kΩ = 1000 Ω. Ac voltage V=220 V, Diode resistance is neglected. To…

Q: Assume that all the diodes are ideal in the given figure. Calculate the voltage across diode D2 in…

A: To find the voltage across diode D2 in steady state. Given, all the diodes are ideal.

Q: . A 12 V battery is supplied by a single-phase 60 Vrms AC supply through a 4.26 Ohm resistance and a…

Q: A 1-phase half wave diode rectifier with R load, has input voltage of 240 V. The input power factor…

A: Given data, Input voltage Vs=240 V

Q: A single phase half wave diode rectifier is fed from a 170V(RMS) 50Hz AC voltage source, and charges…

A: Given Data: A single-phase diode rectifier with a load of, Resistor R=4Ω Battery Vbt=120 V Current…

Q: 4. Determine Vout for the figure below when the types of diodes (Si) and the resistance (R) equal…

Q: B. Plot the input and output waveforms, one above the other, for each of the three circuits below.…

A: The Diode circuit is given ashere

Q: (a). Consider a Full Wave Rectifier Circuit with given values as shown. Would you expect the Circuit…

A: Need to find if circuit is fall or not

Q: Q.4) A single-phase full-wave controlled rectifier is supplied from 220V, 50Hz. The load is R 1002…

A: Given the Single phase full wave controlled rectifier Vrms= 220 V at 50 Hz RL load R=10 Ω L=100…

Q: 3. For the circuit below, find the Q-point for all diodes. You can do ONE of the three options…

A: DIODE: A diode is a semiconductor device that functions as a current one-way switch. It lets current…

Q: 2. Connect the 22 F and 10F capacitors separately (insert the fina capacitor and take the…

Q: Forward bias VBR VF 0.7 V Knee Barrier Potential Reverse bias

A: I have explained these in step 2.

Question

A full-wave rectifier operating from the 60-Hz ac supply produces a 20-V peak rectified voltage.
If a 200-uF capacitor is used, calculate the ripple at a load of 120 mA.
Ripple- 1.44
A Full wave rectifier operating from the 60Hz ac
supply produces a 20-V rectified voltage. If a 200-uF
capacitor is used, calculate the ripple at a load of 120
mA

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Three Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Quiq
Calculate the ripple voltage for a full-wave rectifier @120 Hz with a 45.03 uF filter capacitor connected to a load drawing 326.20 mA current.
The RMS output voltage of a Full-Wave Bridge Rectifier is 20 volts, Calculate the average current (in amperes) flowing into the load resistor with 3.2 kiloohms resistance. O 0.00563 O 0.00301 O 0.00426 O -0.00261
In a full wave bridge rectifier, the transformer secondary voltage is 10sinwt. Theforward resistance of each diode is 25Ω and load resistance is 1KΩ.Calculate,i. Imii. Idciii. Pdciv. Pacv. η
The RMS output voltage of a Full-Wave Bridge Rectifier is 20 volts, Calculate the average current (in amperes) flowing into the load resistor with 4.6 kiloohms resistance. 0.00210 O 0.00296 O 0.00391 O -0.00182
The RMS output voltage of a Full-Wave Bridge Rectifier is 20 volts, Calculate the average current (in amperes) flowing into the load resistor with 1.7 kiloohms resistance. O 0.00802 O 0.01059 -0.00492 O 0.00567
1. Single phase half wave rectifier The rectifier circuit shown below has the following parameters: V, = 170 sin 0; R = 25 52; Turns Ratio N = 12:1 Treat the diode as IDEAL Vout V 20 15 10 5 O a) Draw the voltage across the resistor Your on the following graph. Label the peak value. -5 -10 -15 -20 12:1 3 0 0.5 TT b) What is the average voltage across the resistor? c) What is the average current through the resistor? R DI TC D1 R 1.57 0 270
The single-phase full wave rectifier is suppling a heavily resistive load. Assume an input of 230 V, 50HZ, α = x/3 calculate the average and rms values of an output voltage. Note: NO. of primary = 6 No. of secondary-3
7. Will give thumbs up Multiple choice Choose the letter of correct answer
A single-phase full-wave controlled rectifier, operating at 120 V rms and 60 Hz ac supply, has a firing angle of 60°. The average value of its output voltage is
i. Show that the power factor for a controlled full-wave rectifier with a resistive load is 1 sin(2a) + pf = -
What the range of values of Vi that will maintain the Zener diode in the "on" state. IR R " 220 Ω V₁ R, 21.2 ΚΩ V V/₂= 20 V 12M=60 mA 32.68v to 33.87v 23.67v to 36.37v 20.80v to 38.9v 27.00v to 56.8v