A foundation 4 x 2 m carries a uniform pressure of 200 kN/ m- at a depth of I m in a layer of saturated clay 11m deep and underlain by a hard stratum. If E for the clay is 45 MN m, determine the average value of immediate settlement under the foundation.

A foundation 4 x 2 m carries a uniform pressure of 200 kN/ m- at a depth of I m in a layer of saturated clay 11m deep and underlain by a hard stratum. If E for the clay is 45 MN m, determine the average value of immediate settlement under the foundation.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A square foundation is shown in Figure 4.30, with e = 0.3 m and eg = 0.15 m. Assume two-way eccentricity, and determine the ultimate load, Q %3D Sảnd 18 kN/m 30 1.5 m x 1.5 m R= 0.15 m 15 m EL 0.3 m Figure 4.30 An eccentrically loaded foundation 1.5 m
A column foundation [ 2.0 m x (1.7m] in size is located at a depth of 1.4 m in a strong cohesive soil layer 2.4 m thick has a unit weight of 19.7 kN/m3, cohesion of 29 kN/m2 and , friction angle of 28o. This layer overlies a weaker cohesive soil layer 15 m thick has a unit weight of 16.3 kN/m3, cohesion of 8 kN/m2 and friction angle of 20o. Determine the allowable foundation load if the factor of safety is 2.5. Show all the related labeled sketches clearly.
It has been determined that the stress increase occurring at a depth of 6 m below the center of the foundation with a diameter of 6 m is equal to the increase in stress at 6 m depth under the center of the square foundation of 6 m X 6 m. Since the load carried by the circular foundation is 1000kN, how much load does the square foundation carry?
A circular foundation 2m in diameter is shown in the figure below. A normallyconsolidated clay layer 5m thick is located below the foundation. Determine the consolidation settlement of the clay. 1- method 2:1 2- consolidation settlement Cc method
A permanent load of 2500kN and an imposed load of 1250 kN are to be supported on a square pad foundation at a depth of 1.0 m in a deposit of gravelly sand extending from the surface to a depth of 6.0 m. A layer of clay 2.0 m thick lies immediately below the sand. The water table may rise to foundation level. The unit weight of the sand above the water table is 17 kN/m3 and below the water table the saturated unit weight is 20 kN/m3. Characteristic values of the shear strength parameters for the sand are c = 0 and ϕ = 38 . The coefficient of volume compressibility for the clay is 0.15m2/MN. It is specified that the long term settlement of the foundation due to consolidation of the clay should not exceed 20 mm. Using the Working Stress Design Approach with Fs = 2.5, determine the foundation size to safeguard against bearing capacity failure and excessive settlement
2. Please find the possible solutions for this question! A foundation 4 m x 5 m transfers a total load of 5 MN to stiff overconsolidated clay with an OCR=4 and ysar=19 kN/m (given figure below). Groundwater level is at 1 m below the ground surface. A CU test was conducted on a soil sample taken at a depth 5 m below the center of the foundation. The results obtained are (cu.)p = 40 kPa, o', = 28, and 'es= 24. Determine if the soil will reach the failure state for short- term and long-term loading conditions. If the soil does not reach the failure state, what are the factors of safety for short-term and long-term loading conditions? Assume the soil above the groundwater level is saturated. Please discuss the details of your findings! 5 MN Foundation: 4 m x 5 m 21 =1m Stiff clay 22 = 4 m Sample
Question 1) For a shallow foundation measuring (1.7 m x 2.2 m) as shown below: , A. Estimate the elastic settlement proposed by Mayerhof. Then, B. Estimate the elastic settlement proposed by Bowles, if the water table rises 1.5 m. Then, Use yw=10 kN/m³ qnet= 1.2 MN/m2 G.S 1.5 m Sand Yd=16 kN/m³ Ysat= 17 kN/m3 %3D 2.5 m N60=52 V W.T. Silty Sand Ya=18 kN/m³ Ysat = 18.5 kN/m? N60=52 3.5 m Sand Ya=19 kN/m3 Ysat = 22 kN/m³ e, = 0.4, Ae=0.04 , o'= 194 kN/m2 5 m Cc= 0.3, Cs= 0.2 , Ca= 0.05 N60=60 CS Scanned with CamScanner
Prob. 3) Referring to the figure below: A) Compute the average increase in stress Ao below the centre of the footing for the clay layer 2. B) Compute the elastic settlement of the clay assuming a shallow foundation. OCR=3, P.I-30%, C-120 kPa, us=0.5. P= 1350 kN G.S. ydry= 17.7 kN/m³ 3 m Clay1 3.mx6 m. 2 m W.T. 2 m ysat= 20 kN/m3 4 m Clay2 ysat= 21 kN/m3 Rigid rock CS Scanned with CamScanner
4. A square foundation will be constructed at ground surface. The subsoil profile is shown in the figure below. The mat will have a net uniform load of 500 psf at El. O. The mat will have a net uniform load (Induce stress) at El. -15 of 360 psf, the primary consolidation settlement (in.) of the clay layer directly below the center of the foudnation is? fr ORIGINAL GROUND SURFACE ELEV. O ft ELEV-5 ft. ELEV-10 ft ELEV-20 ft 30 ft SAND Y = 115 pcf MAT FOUNDATION SAND Y = 105 pcf GROUNDWATER TABLE NORMALLY CONSOLIDATED CLAY SATURATED UNIT WEIGHT = 95 pcf COMPRESSION INDEX C₂ = 0.29 VOID RATIO=1.0
A square column foundation with base of 1.51 m is shown in the figure. It carries an axial load of 468 kN and has its bottom resting on the ground water table located h1 = 1.4 m. below the ground surface. h2 = 0.8 m and h3 = 2.5 m. Compute the settlement of the clay layer in millimeter caused by primary consolidation if the preconsolidation pressure of the clay is 98 KPa. |P Shy h1 kak 1:1:1 2222 1:1 I Dry Sand Wet Sand Clay Soil Properties: Unit Weight of Dry Sand = 15.4 KN/m3 Saturated Unit Weight of Sand = 19.4 KN/m3 Saturated Unit Weight of Clay = 18.6 KN/m3 Compression Index = 0.264 Void Ratio of Clay = 0.75 Swell Index = 1/5Cc 11 LEE ILLI CEET EEGGE LLLLLLI TELLIT 1