A force of 12 N is applied to a cylinder of radius r = 0.35 m, as shown in Figure Q2(a). The moment of inertia of this cylinder is J = 6 kg.m². Determine: (i) The magnitude and direction of the torque produced on the cylinder. (ii) The angular acceleration a of the cylinder.

Q: A thermistor has a: a. positive output voltage. b. negative output voltage. c .positive…

A: A thermistor is an electronic component that is sensitive to temperature changes and is often used…

Q: 11. The supply voltage is 100 V, the armature resistance is 1.3 Ohms, the CEMF is 93 V and the speed…

A: The solution is given below

Q: R= バニスル | कि-30-

A:

Q: when using lm393, is it necessary to use a pull up resistor between the output and the power supply?

A: It is asked to discuss why we need to use a pull up resistor between the output and the power…

Q: Which of the following is used for very heavy loads? 1. Permanent magnet motor 2. AC servomotor 3.…

A: We need to discuss about the these motor based on heavy load.

Q: In a motor, increasing the gap between electromagnets and a rotor: Select one: decreases motor…

A: The question is asking about the effect of increasing the gap between the electromagnets and the…

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.