A force F is applied to the upper end of the curved wrench, as shown in the diagram. Assuming that the angle a may be varied as required (whilst keeping the magnitude of F unchanged), calculate the maximum possible value of the moment caused by F about the centre O of the bolt (take the counter-clockwise direction as being positive). Express your answer in Nm. F = 205 N, d = 166 mm. F -A 25 mm 70 d mm 70 mm 25 mm mm

Q: 3.0000 R2.0000 1.0000 4.0000 2.0000 4.0000 4.0000 0000 0000 0000-

A: Handmade drawing are attached for better understanding.

Q: Why interior angles could be observed either clockwise or counterclockwise?

A: Solution: The  Interior angle traverse are basically used for many works and they are especially…

Q: Exercise 1.9: Draw the Isometric view from the provided views (Front, Top, Right). Note: Third Angle…

A: Orthographic projections are given.To draw : isometric projection.

Q: then why did you assume that that y distance is 4 |??? why cant it be 5 or 7

A:

Q: Explain the axis translation technique without using any figure. What are the limitations of this…

A: The axis translation technique  is a grounded technique for forcing upsides of pull unsaturated soil…

Q: 01m 0.3m hole I= 0.5m D.3m 0.Qm0.I m

A:

Q: Exercise 1.8: Draw the Isometric view from the provided views (Front, Top, Right). Note: Third Angle…

A: Orthographic projections are given.To draw : isometric projection.

Q: The azimuth of a line is 207*. The back azimuth of the same line is A. 63* B. 297* C. 27* D.…

A: Azimuth is Angular measurement in a spherical coordinate system. Back Azimuth is calculated by…

Graphical Methods

The graphical method is a method of solving equations involving more than one variable using the Cartesian coordinate system. In civil engineering, the use of the graphical method is limited to the problems involving two variables. The graphical method has a great impact in solving the questions regarding engineering mechanics.