A footing 2.25 m square is located at a depth of 1.5 m in a sand of unit weight 18 kN/m3. The shear strength parameters are c' = 0 and 6 = 36°. Calculate the safe load carried by the footing against complete shear failure. Factor of safety against shear failure is 3. Use Terzaghi's analysis. (N. = 65.4, N = 54.0) = 49.4, %3D b.

A footing 2.25 m square is located at a depth of 1.5 m in a sand of unit weight 18 kN/m3. The shear strength parameters are c' = 0 and 6 = 36°. Calculate the safe load carried by the footing against complete shear failure. Factor of safety against shear failure is 3. Use Terzaghi's analysis. (N. = 65.4, N = 54.0) = 49.4, %3D b.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Solve using eurocode 7, design approach 1, combination 2
For the embedded strip footing (infinitely long in the out-of-plane direction) shown below, the maximum vertical pressure that the soil can bear before failure is 100 kPa (i.e., qmax should not exceed 100 kPa). What is the maximum overall eccentricity of the foundation in mm before failure? (answer tolerance = 2%). Consider γconcrete = 25 kN/m3, γsoil = 18 kN/m3 and assume that the width of the embedded column is negligible, and the entire top of the foundation is covered with soil. Hint: for a strip footing, the calculations should be conducted assuming a 1-m long footing in the out-of-plane direction.
A footing 4 mx 2 m in a plan, transmits a pressure of 150kN/m² on a cohesive soil have E = 6 x 10¹kN/m² and × μ = 0.5. What will be the immediate settlement of the footing at the center? Take influence factor = 1.5
Prob. 3) Referring to the figure below: A) Compute the average increase in stress Ao below the centre of the footing for the clay layer 2. B) Compute the elastic settlement of the clay assuming a shallow foundation. OCR=3, P.I-30%, C-120 kPa, us=0.5. P= 1350 kN G.S. ydry= 17.7 kN/m³ 3 m Clay1 3.mx6 m. 2 m W.T. 2 m ysat= 20 kN/m3 4 m Clay2 ysat= 21 kN/m3 Rigid rock CS Scanned with CamScanner
A square footing 3 m x 3 m is supporting an axial load of 650 kN. The weight of the soil is aasumed to be 17.32 kN/m^3. Compute the vertical stress increment due to this load at a depth of 1.5 m below the center of the footing using the approximate method. a. 51.46 kPa b. 32.10 kPa c. 76.54 kPa d. 50.56 kPa
For general c- soil, cohesion c is 50 kPa, the total unit weight y. is 20 kN/m3 and the bearing capacity factors are N= 8 and = 3 and N, = 2. Using Terzaghi's formula. Na Calculate the net ultimate bearing capacity for a strip footing of width B=2m at depth z = 1 m. Considering shear failure only, estimate the safe total load on a footing 10m long by 2m wide strip footing using a factor of safety of 3. %3D
Example: 1 • A square footing 2.5m x 2.5m is shown in the figure below. Determine the magnitude of the safe gross load (using MEYERHOF'S method and factor of safety of 3) that the footing can carry. 1m Bearing Capacity 1m y = 15kN/m³ c=0 = 35⁰ Yat=19kN/m²
A square footing shown has the following details: Unit weight of soil = 15.28 kN/m3 Saturated unit weight of soil = 19.92 kN/m3 cohesion = 21.44 kPa %3D friction angle = 24 degrees %3D B = 2 meter Df = 2.45 meter P = 861 kN e/B = 0.12 --> one way eccentricity Calculate for the net allowable bearing capacity using FOS = 2.8. Use Meyerhof General Bearing Capacity Formula. D, B B Water table
FDE 006. The square footing shown carries a load of 3500 KN. Assume that the stress below the footing is distributed at a slope 1H:2V. The clay layer is overconsolidated with OCR=2. Q = 3500kN Vd 17.5kN/m'. Sand- Vsat 18.3kN/m³ Ysat 17.1kN/m² eo=1.4 Refer to FDE 006. Determi the settlement of the overconsolidated clay layer. Select the correct response: 101.819 mm 73.624 mm 37.561 mm 86.241 mm Clay 3m x 3m GWT Cs= 0.06 Cc = 0.38 0.6m 0.6m 1.2m 1.2m
Example: 1 • A square footing 2.5m x 2.5m is shown in the figure below. Determine the magnitude of the safe gross load (using MEYERHOF'S method and factor of safety of 3) that the footing can carry. 1m Bearing Capacity 1m y = 15kN/m³ c=0 = 35⁰ Yat=19kN/m²