A flypress has two rotating spheres, each of mass 5 kg, fixed to a horizontal arm, s that they are at a radius of 700 mm from the axis of rotation. When the press is use to punch holes in a metal plate, the initial speed of the arm is 5 rev/s and the speed fal. to 4.5 rev/s during one operation. Find the energy used in the punching stroke and th average force exerted if the plate is 12 mm thick. 2021.N

Q: Prism 1 of mass ml and with angle sits on a horizontal surface On the prism, a bar 2 of mass m2 is…

A:

Q: However, I don't understand why the Force of Friction is going in the same direction as the…

A: Given Data:   To Find: Why the Force of Friction is going in the same direction as the displacement…

Q: Consider the system below. Calculate the kinetic energy of this system. Assume that pulley otates…

A: Drr

Q: 2) A hoop of mass M and radius R has an initial angular velocity wo at the bottom of a ramp of angle…

A: (a) The free-body diagram of the hoop is: Where the force vector, N→ is the reaction force applied…

Q: The bar AB is uniform and has a mass of 50.0 kg.  At the moment shown, the rod has an angular…

A: Given that, Mass of bar AB = 50 kg Angular velocity of rod = 4 rad/sec Spring is stretched by 0.3 m

Q: A 50 kg barrel with a diameter of .75 meters is placed on a 20° slope. Assuming the barrel rolls…

A: Given data  Weight of barrel = 50 kg  Diameter = 0.75 m Slope = 20 °  Given figure

Q: *28 In Fig. 4-34, a stone is pro- jected at a cliff of height h with an initial spced of 42.0 m/s…

A:

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.