- A fluid of constant density flows at the rate of 15 litres/sec along a pipe AB of 100 mm diameter. This pipe branches at b into two pipes BC and BD each of 25 mm diameter and a third pipe BE of 50 mm diameter. The flow rates are such that the flow through BC is three times the flow rate through BE and the velocity

- A fluid of constant density flows at the rate of 15 litres/sec along a pipe AB of 100 mm diameter. This pipe branches at b into two pipes BC and BD each of 25 mm diameter and a third pipe BE of 50 mm diameter. The flow rates are such that the flow through BC is three times the flow rate through BE and the velocity

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A liquid enters a diffuser at speed 10.8 feet/second. The diffuser's inlet diameter is 4 inches while it's outlet diameter is 6 inches. Determine the speed of the water at the diffuser outlet in feet/second.
Water at a pressure of 294 3 kN/m flows through a horizontal pipe of 100 mm diameter with a velocity of 2 m/s. If the diameter of the pipe gradually reduces to 50 mm, what is the axial force on the pipe assuming no loss of energy.
7.60 PLUS The pump shown draws water (20°C) through a 20 cm suction pipe and discharges it through a 10 cm pipe in which the velocity is 3 m/s. The 10 cm pipe discharges horizontally into air at point C. To what height h above the water surface at A can the water be raised if 26 kW is delivered to the pump? Assume that the pump operates at 60% efficiency and that the head loss in the pipe between A and C is equal to 2 V/2g. Assume a = 1.0 throughout. Pump C Water PROBLEMS 7.59, 7.60
..
Heavy machine tool lubricating oil (ref. Appendix C applied fluid mechanics) is pumped through six rectangular slots in a heat exchanger (oil flows in the white rectangles in section view a-a) as shown below. You may assume that the oil flows through the heat exchanger with a constant temperature of 40°C. If the flow rate from A to B is 3 cm³/sec determine the Reynolds number for the oil flow. Is the flow laminar or turbulent?
A pipe with a radius of 7.5 mm is attached to a garden hose with a nozzle. If the velocity of flow in the pipe is 2 m/s, what is the velocity of the flow at the nozzle when it is adjusted to have a diameter of 8 millimeters, and what is the flow rate?
2. Two interconnected pipes A and B with 300 mm and 200 mm diameter, respectively, carries a flow of 0.116 m3/s. Determine the velocity in m/s of pipe A and pipe B. If pipe B was replaced with 400 mm diameter, determine the velocity in m/s of pipe B.
(a) If it takes 2.35 min to fill a 20.5 L bucket with water flowing from a garden hose of diameter 3.30 cm, determine the speed at which water is traveling through the hose. m/s(b) If a nozzle with a diameter four-fifths the diameter of the hose is attached to the hose, determine the speed of the water leaving the nozzle. m/s
please refer to image tq