A floor system consists of a 125 mm concrete slab supported by concrete T-beams with a 7.5 m span and 1.2 m on centers. Web dimensions, which are determined by negative moments requirements at supports, are b.- 350 mm and d =- 500 mm. What is the tensile steel area required at midspan to support a factored moment of 500 KN.m? Material properties: fe'- 21 MPa and fy = 420 MPa.

A floor system consists of a 125 mm concrete slab supported by concrete T-beams with a 7.5 m span and 1.2 m on centers. Web dimensions, which are determined by negative moments requirements at supports, are b.- 350 mm and d =- 500 mm. What is the tensile steel area required at midspan to support a factored moment of 500 KN.m? Material properties: fe'- 21 MPa and fy = 420 MPa.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Please describe the requirements for the concrete transportation.
NEED ASAP! USE NSCP 2015(REINFORCE CONCRETE DESIGN SUBJECT) determine the Concrete Shear Force and Critical Spacing of Stirrups to be adopted by the entire grid distance.Convert all the dimensions from ft and inches into millimeters (use 1 inch = 25mm for distance and dimension approximations). Use the following parameters: fc' = 21 MPa, fy = 420MPa, fyt = 275 MPa, Wdl = 23.7 KN/m, WII = 16 kN/m.
what is the concrete precast?
Problem 1: Calculate Mn and check the minimum steel limit f'c =4 ksi, fy 60 ksi. 2.5" 25" 6-#9 12" 3.5" 4" 25"
Define the abaqus modelling technique for reinforced concrete.
i need the answer quickly
Q) Differentiate b/w the following: A ) UBC & IBC. Subject: Reinforced concrete design ii
Give the comparison of the Pre – Stressed Concrete andthat Cast in Place concrete.