(a) Find its resistance R (in ohms) if the capacitor charges to 90.0% of its final value in 13.7 s. Ω (b) Find the average current (in A) delivered to the flash bulb if the capacitor discharges 90.0% of its full charge in 1.44 ms. A

(a) Find its resistance R (in ohms) if the capacitor charges to 90.0% of its final value in 13.7 s. Ω (b) Find the average current (in A) delivered to the flash bulb if the capacitor discharges 90.0% of its full charge in 1.44 ms. A

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

In an RC series circuit EMF = 120.0 V, R = 1.40 MOhm, and C = 1.80 muF. (a) Calculate the time constant. (b) Find the maximum charge that will appear on the capacitor during charging. (c) How long does it take for the charge to build up to 20 muC? (d) What is the maximum current through the resistor? (e) What is the potential difference across the capacitor after it has been charging for 1.0 sec? (f) Sketch the charge and current as functions of time. (g) After being totally charged, the capacitor is carefully disconnected from the circuit above without discharging it. It is connected to a 520 kOhm resistor and begins to discharge. What is the time constant for this circuit? (h) What will be the potential difference across the capacitor after 400 msec? (i) Sketch the charge and current as functions of time.
(a) What is the resistance of a lightbulb that uses an average power of 85.0 W when connected to a 60.0 Hz power source having a maximum voltage of 190 V? Ω (b) What is the resistance of a 110 W bulb? Ω
Using the exact exponential treatment, find how much time (in s) is required to charge an initially uncharged 120 pF capacitor through a 67.0 MΩ resistor to 91.0% of its final voltage. __________s
A 2.00-nF capacitor with an initial charge of 5.27 µC is discharged through a 2.47-k2 resistor. dQ (a) Calculate the current in the resistor 9.00 µs after the resistor is connected across the terminals of the capacitor. (Let the positive direction of the current be define such that > 0.) dt (b) What charge remains on the capacitor after 8.00 µs? (c) What is the (magnitude of the) maximum current in the resistor? A
(!) THE FOLLOWING QUESTIONS ARE BASED ON THE INFORMATION GIVEN HERE. R ww The emf source, E R, = 5.6 N. The capacitor has a capacitance C = 3.7 µF. 2.1 V, of the circuit shown in the figure has negligible internal resistance. The resistors have resistances R, = 2.6N and 3. R1 A) Determine the time constant T, in units of microseconds for charging the capacitor. Answer: B) What is the charge Q on the capacitor in units of microcoulomb? Answer.
The figure below shows how a bleeder resistor (R = 250 kΩ) is used to discharge a capacitor (C = 90.0 µF) after an electronic device is shut off, allowing a person to work on the electronics with less risk of shock. (a) What is the time constant? _______s (b) How long will it take to reduce the voltage on the capacitor to 0.100% of its full value once discharge begins? _______s (c) If the capacitor is charged to a voltage V0 through a 150 Ω resistance, calculate the time it takes to rise to 0.865V0 (this is about two time constants). _______s
Integrated ConceptsIf you wish to take a picture of a bullet traveling at 500 m/s, then a very brief flash of light produced by an RC discharge through a flash tube can limit blurring. Assuming 1.00 mm of motion during one RC constant is acceptable, and given that the flash is driven by a 600-μF capacitor, what is the resistance in the flash tube?
The RC charging circuit in a camera flash unit has a voltage source of 265 V and a capacitance of 126 uF. HINT (a) Find its resistance R (in ohms) if the capacitor charges to 90.0% of its final value in 17.2 s. 5.96E-4 (b) Find the average current (in A) delivered to the flash bulb if the capacitor discharges 90.0% of its full charge in 1.04 ms.
(a) What is the resistance of a lightbulb that uses an average power of 25.0 W when connected to a 60.0-Hz power source having a maximum voltage of 170 V? Ω (b) What is the resistance of a 75.0-W lightbulb? (Assume the lightbulb uses an average power of 75.0 W when connected to a power source having a maximum voltage of 170 V.) Ω
An uncharged capacitor and to a source of emf. If ɛ = 9.00 V, C = 20.0 µF, and R = 1.00 x 102 Q, find (a) the time constant of the circuit, (b) the maximum charge capacitor after one time constant. a resistor are connected in series the capacitor, and (c) the charge the on on
(!) THE FOLLOWING QUESTIONS ARE BASED ON THE INFORMATION GIVEN R2 HERE. R1 The emf source, E = 2.5 V, of the circuit shown in the figure has negligible internal resistance. The resistors have resistances R, = 2.2N and R2 = 4N. The capacitor has a capacitance C = 5.2 µF. A) Determine the time constant T, in units of microseconds, for charging the capacitor. Answer: B) What is the charge Q on the capacitor in units of microcoulomb? Answer:
The RC charging circuit in a camera flash unit has a voltage source of 265 V and a capacitance of 136 µF. HINT (a) Find its resistance R (in ohms) if the capacitor charges to 90.0% of its final value in 17.2 s. 54.96 хо (b) Find the average current (in A) delivered to the flash bulb if the capacitor discharges 90.0% of its full charge in 1.04 ms. 3.66 ХА