A Fig. P12.38 B 30° 12.39 A single wire ACB passes through a ring at C attached to a sphere which revolves at a constant speed v in the horizontal circle shown. Knowing that the tension is the same in both portions of the wire, determine the speed v. 45° 5 kg E40 Two wires AC and BC are tied at C to a sphere that revolves at a con- stant speed v in the horizontal circle shown. Determine the range of the allowable values of y if both wires are to remain taut and if the 1.6 m Fig. P12.39 and P12.40

Q: 1.) The following statements are true except: CHOICES:      a.) The ordinate for influence line…

A: Influence Line Diagram(ILD) is  a diagram which shows the reactions, Shear force and Bending moment…

Q: Draw the Influence line for member BC of the k-truss hown, Indicate numerical values for peaks.

A: A k truss member is given below need to find the ILD(Influence line Diagram ) for member BC

Q: Which of the following gives the reaction at E in the given beam??

A: We know that at internal hinge we get zero bending Moment. And reactions at hinge will get…

Q: The influence line for shear just to the right of D for the beam shown A B -5 m- -6 m- a. crosses…

A: Given data in question Overhanging beam Span 22mTo find out ILD for D+NoteWe will draw ILD using…

Q: 22-19. The slender rod has a mass of 0.2 kg and is supported at O by a pin and at its end A by two…

A: Given information:

Q: A 2 kN |—3 m3 m 12 kN•m 6 m 1 kN/m B

A:

Q: 70KN/m 45KN GO 25KN/m 0.60m A 65KNM 18KN/m 2.5m 5m 2.0m

A:

Q: The beam is shown  a.) What is the reaction at A in KN? b.) What is the vertical reaction at B in…

A:

Q: Draw the influence line for (internal) bending moment MA. Enter the magnitude of your influence line…

A:

Q: If each of the three links of the mechanism have a mass of 4 kg, determine the angle θ for…

A: Draw the free body diagram.

Q: 90 kips 60 kips 6 kips/ft C D E F 6 ft 6 ft 6 ft 6 ft 12 ft 6 ft

A:

Q: and vertical components of force at the pin A, and the reaction at the rocker B of the curved beam.…

A: The multiple forces that are being applied on the body that is in equilibrium along any direction is…

Q: Wo A 91910 —7- B

A:

Q: Determine the reaction at A in kips due to a uniform load of 0.4 kips/ft placed over the whole beam.…

A: 1.) The expression of Reaction due to uniform load of 0.4 kips/ft is given as Area under given…

Q: Draw the influence lines for the forces in the members identified with an "x" in the figure The…

A:

Graphical Methods

The graphical method is a method of solving equations involving more than one variable using the Cartesian coordinate system. In civil engineering, the use of the graphical method is limited to the problems involving two variables. The graphical method has a great impact in solving the questions regarding engineering mechanics.