A farmer is using a rope and pulley to lift a bucket of water from the bottom of a well that is h, = 9.5 m deep. The farmer uses a force F,= 51 N to pull the bucket of water directly upwards. The total mass of the bucket of water is m; + m, = 3.7 kg. Part (a) Select the correct free body diagram. m,gf F m„gf F mg'm,g m„g m,g F m„gTm,g F m,g m.g F m„gY m,g Submit I give up! Hint Feedback -Draw your own free body diagram and compare it to the ones listed. |-What forces are acting up, what forces are acting vertically down? Part (b) Calculate how much work Wrin J the farmer does on the bucket of water (via the rope) to raise it to ground level. W;= 484.5 / Correct! Part (c) Calculate how much work W, in J gravity does on the bucket filled with water as the farmer lifts it up the well. W. =- 206.1 W = -206.1 Part (d) Calculate the net work Wnet in J done on the bucket of water by the two forces F and F,. Wner = 278.37 Wner = 278.4 Feedback: The answer provided was not correct. We have recognized the following, - Your answer appears to be off by a factor of 2.

A farmer is using a rope and pulley to lift a bucket of water from the bottom of a well that is h, = 9.5 m deep. The farmer uses a force F,= 51 N to pull the bucket of water directly upwards. The total mass of the bucket of water is m; + m, = 3.7 kg. Part (a) Select the correct free body diagram. m,gf F m„gf F mg'm,g m„g m,g F m„gTm,g F m,g m.g F m„gY m,g Submit I give up! Hint Feedback -Draw your own free body diagram and compare it to the ones listed. |-What forces are acting up, what forces are acting vertically down? Part (b) Calculate how much work Wrin J the farmer does on the bucket of water (via the rope) to raise it to ground level. W;= 484.5 / Correct! Part (c) Calculate how much work W, in J gravity does on the bucket filled with water as the farmer lifts it up the well. W. =- 206.1 W = -206.1 Part (d) Calculate the net work Wnet in J done on the bucket of water by the two forces F and F,. Wner = 278.37 Wner = 278.4 Feedback: The answer provided was not correct. We have recognized the following, - Your answer appears to be off by a factor of 2.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Sneak E. Fox Scheme #2: Hoist an Acme brand anvil into the air and drop it onto the bird, using a rope over a steel shaft. The anvil is made of steel and weighs 250 lbs. How much force on the free end of the rope does it take to hold the anvil in place? how much force on the rope is required to lift the anvil into place? is the fox able to hold the anvil using the rope? Can the fox lift the anvil using the rope?
1.3 f a system is isolated: a. The velocities of all objects must sum to exactly zero. b. Sum of all the forces must be 3.14159 Newtons c. The vector sum of all external forces acting on the system must be zero. d. It will interact with the external environment.
A sled of mass 500kg sits at rest on a rough slope that is inclined at 10* to the horizontal. The coefficient of friction between the slope and the sled is 0.3. The sled is held in place by a wire attached to a winch. The tension in the wire is TN. a) Find the maximum possible value of T. A load of mass mkg is added to the sled, and tension in the wire is increased to 5000N in order to pull the sled and load up the slop. Given that the sled and load are pulled a distance of 100m in 80seconds, b) Work out the value of m
1. A horizontal force P the plane, and a horizontal force P= 350 N is required to just push the block up the plane. Determine the coefficient of static friction between the plane and the crate, and find the weight of the block. 100 N is just sufficient to hold the block from sliding down 30° 2. Blocks A and B weigh 200 N and 150 N, respectively. They are connected together with a cable and placed on the inclined plane. If the angle 0 is gradually increased, determine 0 when the crates begin to slide. The coefficients of static friction between the crates and the plane are HA 0.25 and HB= 0.35.
How much tension must a 28.0 m long wire be able to exert without breaking when it is used to hang an iron sculpture that weighs 2784 N? The wire must be attached to two anchors in the ceiling 16.1 m apart.
A 30kg barrel of oil is sitting in a holding container consisting of two walls one at an angle of 60o from the horizontal, and the other wall at 40o from the horizontal. What are the normal forces acting on the walls – N1 and N2? Draw a free body diagram and a resolved free body diagram.
At a construction site, a pallet of bricks is to be suspended by attaching a rope to it and connecting the other end to a couple of heavy crates on the roof of a building, as shown in (Figure 1). The rope pulls horizontally on the lower crate, and the coefficient of static friction between the lower crate and the roof is 0.509. What is the weight of the heaviest pallet of bricks that can be supported this way? (Hint: Start by drawing appropriate free-body diagrams.) (Express your answer in pounds.) What is the friction force on the upper crate under the conditions given in Part 1? (Express your answer in pounds.)
At a construction site, a pallet of bricks is to be suspended by attaching a rope to it and connecting the other end to a couple of heavy crates on the roof of a building, as shown in (Figure 1). The rope pulls horizontally on the lower crate, and the coefficient of static friction between the lower crate and the roof is 0.707. What is the weight of the heaviest pallet of bricks that can be supported this way? (Hint: Start by drawing appropriate free-body diagrams.)
Calculate the ratio of the drag force on a business jet flying at 834 km/h at an altitude of 10 km to the drag force on a drone flying at 384 km/h at half that altitude. The density of air is 0.28 kg/m3 at 10 km and 0.57 kg/m3 at 5 km. Assume that the drone has half the effective sectional area of the business jet and the same drag force coefficient.
Calculate the ratio of the drag force on a jet flying at 885 km/h at an altitude of 8.6 km to the drag force on a prop-driven transport flying at half that speed and altitude. The density of air is 0.46 kg/m³ at 8.6 km and 0.71 kg/m³ at 4.3 km. Assume that the airplanes have the same effective cross-sectional area and drag coefficient C. Number i Units
IS Halliday, Fundamentals of Physics, 11e Help | System Announcements PRINTER VERSION 1 BACK NEXT Chapter 06, Problem 093 (2.1). N (with t in seconds) is applied to the box. The acceleration of the box A 1.0 kg box is initially at rest on a horizontal surface when at t = 0 a horizontal force F= as a function of time t is given by a = 0 for 0 2.8 s. (a) What is the coefficient of static friction between the box and the surface? (b) What is the coefficient of kinetic friction between the box and the surface? (a) Number Units (b) Number Units Click if you would like to Show Work for this question: Open Show Work Question Attempts: Unlimited SAVE FOR LATER SUBMIT ANSWER 7:13 PM re to search ENG 4/4/2021 17 pause break pgdn prt sc insert delete Pgup %23 3 4 backspace