A factory is supplied by a single-phase network of 220 V - 50 Hz. It contains in parallel: - 2 motors, each of active power 3000 W and of reactive power 2775 VAR. 14 incandescent lamps each of 100W. 2 air conditioners, each of useful power 2400W, efficiency 0.8 and of power factor 0.8. - One compressor of absorbed power 2440W and of power factor 0.8. • - At full load, calculate: 1) The total active power absorbed by the factory. 2) The total reactive power. 3) The total apparent power. 4) The power factor of the factory. 5) The current absorbed by the factory.

A factory is supplied by a single-phase network of 220 V - 50 Hz. It contains in parallel: - 2 motors, each of active power 3000 W and of reactive power 2775 VAR. 14 incandescent lamps each of 100W. 2 air conditioners, each of useful power 2400W, efficiency 0.8 and of power factor 0.8. - One compressor of absorbed power 2440W and of power factor 0.8. • - At full load, calculate: 1) The total active power absorbed by the factory. 2) The total reactive power. 3) The total apparent power. 4) The power factor of the factory. 5) The current absorbed by the factory.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Q1: A 50Hz,11KV,3-ph, alternator with earthed neutral has a reactance of 502\ph and is connected to bus bar through a C.B.The distributed capacitance up to C.B between phase and neutral is 0.01μF,Determine: 1-The restriking voltage across the contacts of the breaker, 2-The frequency of oscillation, and 3-The voltage across the capacitance.
please write your Introduction about this topic , and answer please in print font do not write in hand writing ? beceuse I want to copy it ?
using zero power factor potier methode
1. Which of the following applies to the instantaneous power in a single-phase ac circuit? A. Constant component B. Time varying component O C. Frequency of time varying component is twice the voltage or current D. All of these
Draw phasor daigram
problem 2 1. what is the voltage provided by the building 2. What is the amount of current provided to the bullding? 3. If the building consumes 3200W of power, what is it's power factor? 4. What is the phase angle of the secondary power source in the bullding?
A 440 V, 60 Hz generatorsuppliestwo parallel-connected loads A and B,. LoadA draws an apparent power of 100 KVA at 0.8 pf lagging and load B draws anapparent power of 70 KVA at unity pf. Determine the KVA supplied by the generator.
- Define Wye and Delta Connection in AC Motor - Define Three Phase AC Motor
Please answer all subpart either dislike is ready.. please all subpart
250-kW generator has an efficiency of 89.2 per cent when delivering one -half of rated load. Determine the losses under this condition