A dynamic cone pentameter (DCP) is used for measuring material resistance to penetration (mm/blow) as a cone is driven into pavement or subgrade. Suppose that for a particular application it is required that the true average DCP value for a certain type of pavement be less than 30. The pavement will not be used unless there is conclusive evidence that the specification has been met. Suppose that the sample mean is 28.8 and the sample standard deviation is 12.3 for the sample size of 52. Test this claim at 5% level of significance. Let μ be the true average DCP value. (a) State the hypothesis. (b) Decide the significance level. (c) Calculate the test statistic

A dynamic cone pentameter (DCP) is used for measuring material resistance to penetration (mm/blow) as a cone is driven into pavement or subgrade. Suppose that for a particular application it is required that the true average DCP value for a certain type of pavement be less than 30. The pavement will not be used unless there is conclusive evidence that the specification has been met. Suppose that the sample mean is 28.8 and the sample standard deviation is 12.3 for the sample size of 52. Test this claim at 5% level of significance. Let μ be the true average DCP value. (a) State the hypothesis. (b) Decide the significance level. (c) Calculate the test statistic

A First Course in Probability (10th Edition)

10th Edition

ISBN:9780134753119

Author:Sheldon Ross

Publisher:Sheldon Ross

Chapter1: Combinatorial Analysis

Section: Chapter Questions

Problem 1.1P: a. How many different 7-place license plates are possible if the first 2 places are for letters and...

See similar textbooks

Similar questions

Acrylic bone cement is sometimes used in hip and knee replacements to fix an artificial joint in place. The force required to break an acrylic bone cement bond was measured for six specimens under specified conditions, and the resulting mean and standard deviation were 306.03 newtons and 41.95 newtons, respectively. Assuming that it is reasonable to believe that breaking force under these conditions has a distribution that is approximately normal, estimate the mean breaking force for acrylic bone cement under the specified conditions using a 95% confidence interval. (Round your answers to three decimal places.) n USE SALT
A survey found that women's heights are normally distributed with mean 62.2 in. and standard deviation 3.9 in. The survey also found that men's heights are normally distributed with mean 67.9 in. and standard deviation 3.4 in. Most of the live characters employed at an amusement park have height requirements of a minimum of 57 in. and a maximum of 64 in. Complete parts (a) and (b) below. ..... a. Find the percentage of men meeting the height requirement. What does the result suggest about the genders of the people who are employed as characters at the amusement park? The percentage of men who meet the height requirement is %. (Round to two decimal places as needed.) Since most men the height requirement, it is likely that most of the characters are b. If the height requirements are changed to exclude only the tallest 50% of men and the shortest 5% of men, what are the new height requirements? The new height requirements are a minimum of in. and a maximum of in. (Round to one decimal…
An engineer has designed a valve that will regulate water pressure on an automobile engine. The valve was tested on 200 engines and the mean pressure was 4.4 lbs/square inch. Assume the standard deviation is known to be 0.9. If the valve was designed to produce a mean pressure of 4.5 lbs/square inch, is there sufficient evidence at the 0.02 level that the valve performs below the specifications? State the null and alternative hypotheses for the above scenario.
A manufacturing process produces a critical part of average length 80 millimeters, with a standard deviation of 3 millimeters. All parts deviating by more than 5 millimeters from the mean must be rejected. What percentage of the parts must be rejected, on average? Assume a normal distribution.
Concrete cubes are used to test the quality of mix from a concrete mixing plant. 28 day compressive strength is taken as the standard measure to test the quality of the mix. Tests show that mean compressive strength of a sample of cubes is 28.4 units with a standard deviation of 2.95 units. To assure quality, the mixing company requires that at least 95% of the samples have compressive strength greater than 24 units. Based on this information and assuming a large sample size, answer the following questions. After major improvements on the plant, the mixing company is able to make cubes more consistent (reduce SD of compressive strength but maintain the same mean). For what value of the new SD will be cube standards be just met? Based on the requirements, only about___% of the samples meet the company standards.?
A survey found that women's heights are normally distributed with mean 63.1 in. and standard deviation 2.7 in. The survey also found that men's heights are normally distributed with mean 68.9 in. and standard deviation 3.8 in. Most of the live characters employed at an amusement park have height requirements of a minimum of 57 in. and a maximum of 62 in. Complete parts (a) and (b) below. ..... a. Find the percentage of men meeting the height requirement. What does the result suggest about the genders of the people who are employed as characters at the amusement park? The percentage of men who meet the height requirement is %. (Round to two decimal places as needed.)
The manufacturer of a particular brand of tires claims they average at least 50,000 miles before needing to be replaced. From past studies of this tire, it is known that the population standard deviation is 8,000 miles. A survey of tire owners was conducted. From the 23 tires surveyed, the mean lifespan was 43500 miles. Using alpha = 0.05, can we prove that the data in inconsistent with the manufacturers claim? We should use a t v test. What are the correct hypotheses? Ho: Select an answer v| ? v H Select an answer | ? v Based on the hypotheses, find the following: Test Statistic= p-value- The correct decision is to Select an answer The correct conclusion would be: Select an answer Question Help: M Message İnstructor Submit Question MacBook Pro FR.I END.S DD F8 F9 F10 F11 F12 F7 & 8 9 delete
The average IQ level in the United States is 98 (standard deviation of 4). A sample of 200 people was selected from the city of Loma Linda and had an IQ average of 105. Assuming an alpha of 0.05, is the sample mean significantly greater than the population mean? 1. List the 5 steps needed for the hypothesis testing. Do not forget to make your conclusion in step 5. 2. Compute and interpret the effect size. Edit View Insert Format Tools Table 12pt ✓ Paragraph BIUA ✓ T² v
Aleem tossed a coin 50 times and recorded the results in a frequency distribution table. Outcome Frequency Heads 22 Tails 28 What is the experimental probability of tossing a head?
Acrylic bone cement is sometimes used in hip and knee replacements to fix an artificial joint in place. The force required to break an acrylic bone cement bond was measured for eight specimens under specified conditions, and the resulting mean and standard deviation were 306.11 newtons and 41.94 newtons, respectively. Assuming that it is reasonable to believe that breaking force under these conditions has a distribution that is approximately normal, estimate the mean breaking force for acrylic bone cement under the specified conditions using a 95% confidence interval. (Use a table or technology. Round your answers to three decimal places.) n USE SALT