A dry sand is placed in a containerhaving a volume of 0.0089 cm3. The dry weight of the sample is 0.014 grams. Water is carefully added to the container so as not to be disturbthe condition of the sand. When the container is filled, the combined weight of the of soil plus water is 0.0174 grams. With this, find the void ratio, the porosity, the water content, the specific gravity thepertinent unit weights of the soil sample.

A dry sand is placed in a containerhaving a volume of 0.0089 cm3. The dry weight of the sample is 0.014 grams. Water is carefully added to the container so as not to be disturbthe condition of the sand. When the container is filled, the combined weight of the of soil plus water is 0.0174 grams. With this, find the void ratio, the porosity, the water content, the specific gravity thepertinent unit weights of the soil sample.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A sample of saturated clay was placed in a container and weighed. The weight was 6N. The clay in its container was placed in an oven for 24 hours at 105˚C. The weight reduced to a constant value of 5N. The weight of the container is 1N. If Gs = 2.7, determine: a) Water Content b) Void Ratio c) Bulk Unit Weight d) Dry Unit Weight e) Effective Unit Weight
In order to calculate void ratio of a soil sample, which laboratory test(s) need(s) to be conducted? a. Liquid limit test b. Drying in oven c. Pumping well test d. Pycnometer test e. Ground Penetrating Radar tests f. Hydrometer analysis
A certain saturated sand (S = 100%) has a moisture content of 27.9% and a specific gravity of solids of 2.61. It also has a maximum index void ratio of 0.90 and a minimum index void ratio of 0.33. Compute its relative density and classify its consistency. (Table on the right) Solution: Given the values of mmoisture content, specific gravity and degree of saturation, the void ratio can be estiamted as: e = Thus the relative density is found to be Dr = • According to the table, the soil is classified as %; soil. TABLE 3.3 CONSISTENCY OF COARSE-GRAINED SOILS AT VARIOUS RELATIVE DENSITIES (data from Lambe and Whitman, 1969) Relative Density, D,(%) 0-15 15-35 35-65 65-85 85-100 Classification Very loose Loose Medium denseª Dense Very dense "Lambe and Whitman used the term "medium," but "medium dense" is better because "medium" usually refers to the particle size distribution.
A soil specimen has a total volume of 70 cm3 and a total mass of 135.5g. After complete drying in an oven, the specimen has a mass of 122.0g. The Gs is 2.60. Determine the void ratio. Report your answer to three significant figures, and draw the full phase diagram.
An undisturbed sample of fine sand is tested in the laboratory and found to have a dry mass of 4.63 kg, a total volume of 0.00198 m³ and a specific gravity of 2.70. Other laboratory tests are performed to determine the maximum and minimum density of the sand. At the maximum density, it is determined that the void ratio is 0.35 at the minimum density, the void ratio is 0.95. A. Compute the void ratio of the sand. B. Compute the relative density of the undisturbed sample. C. Compute the dry density in Mg/m³.
The wet weight of a soil specimen is 207 g. The dried weight of the specimen is 163 g. If the volume of the specimen is measured before drying is 110 cubic centimeter, determine the Void ratio if specific gravity of solids is 2.68.
A cylindrical specimen of a cohesive soil of 11 cm diameter and 20 cm length was prepared by compaction in a mold. If the wet mass of the specimen was 3.85 kg. and its water content was 15.45%. (Specific gravity of soil solids is 2.76). Determine the void ratio of the soil. Round off to three decimal places.
OMC-Proctor's Test A sample of dry sand has a volume of 1000 ml in its natural state. Its minimum volume when compacted is 750 ml. When gently poured into a measuring cylinder, its possible maximum volume is 1320 ml. what is the relative density?
1. A dry sand is placed in a container having a volume of 0.0092 cubic centimeter. The dry unit weightof the sample is 0.015 gram. Water is carefully added to the container so as not to disturbed thecondition of the sand. When the container is filled, the combined weight of soil plus water is 0.0182gram.a. Determine the specific gravity of soil particle.b. Determine the dry unit weight of soil.2. If the soil sample has a water content of 11% and a unit weight of 19.67 kN/m3 , determine thepercentage of air in voids and the degree of saturation if the specific gravity of soil solid is 2.75.3. If the soil sample has a specific gravity of 2.71 and a porosity of 0.345, determine the saturated unitweight and the bouyant unit weight.4. A soil sample having a liquidity index of 0.85, a plasticity index of 16.50 and a plastic limit of 11.45.The soil sample has a specicfic gravity of 2.68 and a void ratio of 0.77.a. Compute the degree of saturation.b. Compute the air void ratio.
The following results were obtained by testing a sample of clay: water content 25.6%, liquid limit 43.5%, plastic limit 19.1%. From this compute the following: (a) Liquidity Index (b) Plasticity Index (c) Shrinkage Limit
The dry unit weight of a sand sample in the loosest state is 13.34 kN and in the densest state, it is 21.19 kN. Its grain specific gravity is 270 and has a porosity of 33% P.S. Sorry for the question can’t fully grasp what was written