A double-angle tension member, 2L 75 x 50 x 8 LLBB, of A36 steel with F= 250 MPa and Fy= 400 MPa, is subjected to a service loads of DL= 55 KN and LL= 160 KN. It is connected to a gusset plate with 20 mm o bolts through the long leg. Assume Ae= 0.85A,. Use LRFD. ... Section Check the adequacy of the tension member.0

Q: 1.4) The design block shear strength is A) 234.900 kips B) 176.175 kips C) 211.050 kips D) 158.288…

A: The given figure is shown below:

Q: 4.3-2 Compute the nominal axial compressive strength of the member shown in Figure P4.3-2. Use AISC…

A:

Q: A riveted connection is shown in the figure 3.26. A 25 mm diameter A 502, grade 2 rivets are used. A…

A: To compute:Tensile strength when shear stress of rivet governsTensile strength when bearing stress…

Q: The following image shows a front and side view of the column connection. The bolts have a diameter…

A:

Q: A 3/4 in (thickness) X 5 in (height) steel plate is connected to another one through two bolts of…

A:

Q: 4. An A992 WF steel section is used for the tension member shown in the figure. The bolts are 20mm…

A: A W16x67 is given , we need to find out a. The nominal strength based on gross section yielding.b.…

Q: A double-angle tension member, 2L 3 x 2 x 4 LLBB, of A36 steel is subjected to a dead load of 12…

A: 2L 3 x 2 x 1/4 LLBB section A36 steelDL = 12 kipLL = 36 kip db = 3/4 in

Q: Compute the maximum acceptable tensile SERVICE LOAD that may act on a single tee section that is…

A: Answer In order to calculate the minimum acceptable tensile service load we need to first find the…

Q: The tension member shown in the figure below is a ¹/2 x 10 plate of A36 steel: Fy = 36 ksi, Fu = 58…

A:

Q: 1.2) The effective net area is A) 5.510 in B) 4.536 in C) 4.536 in D) 4.109 in

A: A double-channel shape, 2 C8*18.75, is used as a tension member. The channels are bolted to a…

Members with compression and bending

Compression members are structural elements that carry compressive axial force. They are the vertical members of a building that support beams and their design, which is governed by buckling and strength. Columns are known as struct or compression members, which are subjected to compressive forces. These members provide stiffness to the building and avoid any imperfection regarding the transfer of axial load. For instance, webs in a truss, braces in a framed structure, tiers, and so on.