A diverging tube discharge water from a reservoir at a depth of 10m below the water surface. The diameter of the tube gradually increases from 150mm at the throat to 225mm at the outlet. Neglecting friction, determine: a) the maximum possible rate of discharge through this tube, and b) the corresponding pressure at the throat FL Water 10 m 150 mm 225 mm 0

Q: Water flows upward through a vertical pipe of diameter 5 cm and height 10 m. For a constant…

A: Dia of vertical pipe = 5 cmHeight = 10 mPressure head at lower end of pipe = 20.4 mTo Find :The head…

Q: 4) In the system below, pipe A has a diameter of 6", a length of 1500 ft and a friction factor of…

A: Given Parallel pipesVelocity in pipe B 5 ft/sLengths of A and B = 1500 and 1000 ftDiameter of A and…

Q: weight of the liquid. 4. The absolute pressure in water at a depth of 8m is read to be 175 kPa.…

A:

Q: (6a) A siphon is made of a pipe whose inside diameter is 25.4 mm and is used to maintain a constant…

A: Data given Siphon pipe, diameter = 25.4 mm = 0.0254 m Depth of tank = 6.0975 m

Q: A straight pipe AB, of length 10 m, tapers from a diameter of 40 cm at A to 20 cm at B. The centre…

A:

Q: Nozzle

A: To calculate pressure head at point 2. Applying Bernoullis equation at point 2 and exit. Note that…

Q: Given Water at 10°C flows at the rate of 970 L/min from the reservoir and through the pipe shown in…

A:

Q: 2. A nozzle 3 m long has a diameter of 1.3 m at the upstream end and reduces linearly to 0.45 m…

A: As per Bartleby policy i can answer  only one question at a time. Please upload other questions…

Q: Water is pumped up from a reservoir to a smaller holding tank. If the flow rate through the pipe is…

A: NPSH is the net positive suction head, which is measured in the centrifugal pump.If the local…

Q: storage tank located  30m above the pump.  The suction pipe is 350mm in diameter and 12m in length,…

A:

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?