a) Determine the equivalent point load as the distributed load shown on the figure below. Indicate the location of this point load relative to B. b) The pin at C can support a maximum force of 200 lb. Determine the maximum moment M that can be applied to member AC. Note the applied moment direction in the figure is in the clockwise direction. 4 ft B 100 lb/ft M K 3 ft 3 ft 2 ft → D RE

Q: Calculate the young’s modulus from one of these two graphs?

A:

Q: Q3 A plate of mild steel, 5 mm thick, 1000 mm long and 400 mm wide is stretched plastically 12% in…

A:

Q: Are you please able to include a free body diagram for the question and solution above

A: Given data:- To find:-the state of stress on an element if it is oriented 30° clockwise from the…

Q: Discuss the means of measuring the force distribution within a body?

A: Force is the impact or action applied on a body.

Q: rts are roller, and fixed Supports. Fig. 1. 21 (6) tang = tai

A:

Q: The table gives data concerning the shrink fit of two cylinders of differing materials and…

A:

Q: Using the Magic Formula described in Section 1.4.4, estimate the cornering force of a car tire at a…

A: Given : The slip angle is The applied load is

Q: A two-layered material is made of two metal bars, each with square cross-sectional area t² and…

A: Given: Thickness of each bar is t Increase in the temperature=∆T Let the coefficient of thermal…

Q: Define the term stress trajectory?

A: Stress Trajectory: It is the line continuously showing the changes in orientation of principal…

Q: A socket of above knee amputee is used in the following analysis. It may considered as cylinder with…

A:

Q: Can the External forces be applied to a body as distributed or concentrated loadings?

A: Yes, external forces can be distributed or concentrated.

Q: Which of the following won't have the same unit as the others? Select the correct response: Stress…

A: Stress:  It is the ratio of internal resistive force per unit area of any object is known as stress…

Q: How can we find the value of shear flow?

A: Shear flow: In the built-up beams, the phenomena of shear flow appear frequently. These beams are…

Q: a pipe varies jointly with the internal pressure and the diameter of the pipe, and inversely with…

A: Given data as per question The stressσ in pipe varies jointly with the internal pressure(P) and the…

Q: Q7: Estimate the yield strength and hardness of a piece of cast iron, a hardness indentation using a…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.