A delta connected balanced resistive load is connected across an unbalanced three- phase supply. The currents in lines A and B are 10 230° and 15 Z-60° respectively. Find the current in line C. Find symmetrical components of phase current.

A delta connected balanced resistive load is connected across an unbalanced three- phase supply. The currents in lines A and B are 10 230° and 15 Z-60° respectively. Find the current in line C. Find symmetrical components of phase current.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Determine the possible flows in the network shown in figure below.And solve a system of linear…

A: possible flows in the network shown in the figure below are determined

Q: 3. The single-line diagram of a three-phase power system is as shown in Figure Al-3. Impedances are…

A: According to the question we have to find the value of voltage across buses 2 and 1 with the help of…

Q: Suppose you have a three-phase generator that provides 120 V per phase and works at a frequency of…

A: Here we discuss the concept of power & power factor.

Q: a) Find the ICA load current. b) Give the line voltage Vab. c) Calculate the total complex power on…

A: a) Find the ICA load current. b) Give the line voltage Vab. c) Calculate the total complex power on…

Q: Given: 1. 2 wye-connected loads per phase to a 3 phase power source 2. first load consists of a…

Q: a balanced three phase voltage of 100v line to neutral is applied to a balanced y connected load…

A: symmetrical component are define the stability of power system . symmetrical component are three…

Q: The total power drawn by the two-impedance load in parallel is 26kW at 0.98 power factor lagging, it…

Q: 1. What is the main direct cause of reactive power in AC system? A. Resistance of transmission lines…

Q: 4. In Y-Y connection, line - to neutral voltage equals the line to - line voltage. (wrong / true /…

Q: a) Find the ICA load current. b) Give the line voltage Vab. c) Calculate the total complex power on…

A: a) Find the ICA load current. b) Give the line voltage Vab. c) Calculate the total complex power on…

Q: There are two loads connected in parallel and powered from a 7200-V source. The first load is 50-kVA…

Q: A power station is to supply two loads. The daily load curves of two loads are shown in figure…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: There are two loads connected in parallel and powered from a 7200-V source. The first load is 50-kVA…

Q: What is the angle between 'R' phase voltage and 'RY' line voltage in a balanced three-phase star-…

A: Given a balanced three phase system The positive phase sequence of the three phase is…

Q: The single-line diagram of a subtransmision system is presented in the figure below. At point B a…

A: Three phase fault is the symmetrical fault and it is the most severe fault.

Q: Describe a single-phase circuit, polyphase circuit, and a three-phase circuit. List the advantages…

A: In electrical engineering, the distribution and transmission of electrical power are achieved…

Q: 1. Two impedances, Z1 =5230• ohms and Z2 = 10445• ohms, draw a current of 3.36 A when connected in…

Q: 1a)Analyze the circuit in Figure 1, consider R = 10 k and C= 10 nF. Obtain the mathematical equation…

A: Given: A RC circuit with R=1 KΩ and C=10 nF, f = 4 KHz ⇒ω=2π×4×103=8000π, To find: a) Equivalent…

Q: V₁4-120 V₁2120 2₁ Z₁ Ic Three-phase source Feeder lines Balanced load In the above circuit diagram,…

Q: A 400 MVA synchronous machine has H₁ = 4.6 MJ/MVA and a 1200 MVA machine has H₂=3.0 MJ/MVA. The two…

A: It is given that: H1=4.6 MJMVA ,S1=400 MVAH2=3.0 MJMVA ,S2=1200 MVASbase=100 MVA

Q: The following single-phase loads are connected to a 415V three-phase supply. Z, = (25- j15)n, z,…

A: The data given in the question are: VL=415V, VPH=4153=239.6 VZR=25-j15 Ω, ZY=45+j10 Ω, ZB=5+j30 Ω…

Q: Describe the concept of three-phase power in electrical systems and its advantages over single-phase…

A: In this question, we need to describe the concept of three phase power in electrical system and also…

Q: Define three cases on which real and reactive power flow gets affected. Draw the phasor diagrams of…

A: The three cases on which real and reactive power flow gets affected are as following, CASE-1 When…

Q: In a three phase balanced Y-Y system, the source phase currents have a magnitude of 9 A. The…

Q: Two impedances Z₁ and Z2 are connected in series to a voltage source with voltage Vs volts. Let V₁…

A: Please comment if you need any clarification. If you find my answer useful please put thumbs up.…

Q: The circuit shows an unbalanced electrical installation powered by a positive sequence symmetrical…

A: Given: Load-1:P1=950Wcosϕ1=0.5 LaggingLoad-2:P2=1.14Wcosϕ2=1Load-3:P3=760Wcosϕ3=0.5 leadingline…

Q: Single Phase and Three Phase Principles

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: Which one of the following diagrams shows delta-delta connections of three single-phase transformers…

Q: VRY = 220 cis 0°, VYB = 220 cis -120° and VBR = 220 cis -240°. IR = 10 cis 0°. The load is balanced…

Q: 12- Sketch the phasor diagrams of the following cases: i) Synchronous generator supplies both real…

A: GENERATOR/ALTERNATOR/SYNCHRONOUS GENERATOR: An alternator/Synchronous generator is a type of…

Q: The actual impedance of a load is 30 OHM. The per-unit impedance of the load is 0.5 pu when Base…

A: In this answer let us try to find the base power used in order to get the given per unit impedance…

Q: Suppose that a current source with Is amperes of current is connected in parallel to a pair of…

A: This is a basic problem of circuit. The solution is given in the next step.

Q: What are symmetrical components and why are they used

A: Characteristic of three phase balanced system: Each phase is displaced by 120° phase angle. Each…

Q: Two 7970-V:230-V single-phase transformers with impedance with respect to their secondaries of 1.5 +…

Q: In the three phase system, phase is on no load, phase b and c are shorted circuited to ground. The…

Q: 10 Ω j4 Ω + E₁ Μ ~) Vs 2:1 The Ioad on the right is absorbing 650 W - j200 VAR. V, = 80 / 0° V. I1…

A: Given in question, Power absorbed by the load and load voltage are, SL=650 W-j200 VARVL=80∠0° V we…

Q: Give your background about the AC systems from single phase and three phase systems to their…

A: AC system with single phase and three phase systems

Q: A three-phase alternator generating unbalanced voltages is connected to an unbalanced load through a…

A: Given data:Required information:

Q: i need the answer quickly

Q: Three Impedances each of (9 - j18)N are connected in mesh across a three-phase 415V ac supply.…

Q: 13.8-kV, single-phase generator supplies power to a load through a transmission line. The load's…

A: Single phase generator,Voltage = 13.8 kV. The load impedance Z_load = 500∠36.87° ohms.The…

Q: The circuit shows an unbalanced electrical installation powered by a positive sequence symmetrical…

A: Given data:Load - 1 :P1=950Wcosϕ1=0.5 Lagging Load-2:P2=1.14Wcosϕ2=1 Load-3:P3=760Wcosϕ3=0.5…

Question

A delta connected balanced resistive load is connected across an unbalanced three-
phase supply. The currents in lines A and B are 10 Z30° and 15 Z-60° respectively. Find the current
in line C. Find symmetrical components of phase current.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Introduction

VIEW

Step 2: current in line C

VIEW

Step 3: symmetrical components.

VIEW

Solution

VIEW

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Single Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

If the line-to-line primary voltage and line current is 1.0 at 0 degrees, what is the secondary line- to-line voltage for the following three-phase transformers? Assume a turns ratio of N = 10. Express answer in polar form. a. Delta-to-Delta: b. Delta-to-Wye: c. Wye-to-Delta: d. Wye-to-Wye:
If the load is connected to the generator thgrough an inductive line and the voltage at the load side is the same as the voltage at the terminals of the generator, which of the following must be true? O A. The reactive power is flowing from the generator to the load and from load to the generator at the same time. O B. The load is disconnected, and no power is delivered to the load. O C. The load has a poor power factor and it's absorbing too much reactive power. O D. None of the other choices are correct O E. The generator is unable to produce reactive power; therefore, the reactive power is flowing from the load to the generator.
In a balanced tephasic system Y - Delta of the figure. Find the line current IL and the average and supplied power to the load
A balanced load is connected in star across a 3 phasec415V 50Hz supply. The load consists of a coil of resistance 25 ohms and inducrance 0.5 henry in paeallel with a purw resistance of 28 ohms and a pure capaciror of 60microfarads capacitance ,in each branch. Calculate a. The line currents The answer has to be 9.3A
X₂=0.1 1 XL +03 Soto X₁ = 0.2 X = 0.1 X = 0.1 Above is the one-line diagram of a simple power system. Each generator is represented by an emf behind the subtransient reactance. All impedances are expressed in per unit on a common base. All resistances and shunt capacitance are neglected. The generators are operating on no load at their rated voltage with their emfs in phase. A symmetrical fault occurs at bus 1 through a fault impedance Z, =j0.08 per unit. a) Using Thevenin's Theorem, determine the impedance to the point of fault and the fault current in per unit. b) Find the bus voltages and line currents during the fault. 2 O oto
Given at the load: Vioond = 452-25° VRMS, 452-25° VRMS, Iload What are the real and reactive power and power factor at the load? Exclude the units. real power: reactive power: power factor: Iload-10-25 ARMS what type of impedance is seen at the load? R. L. or Ch
A three-phase alternator generating unbalanced voltages is connected to an unbalanced load through a 3-phase transmission line as shown in figure. The neutral of the alternator and the star point of the load are solidly grounded. The phase voltages of the alternator are Ea = 1020º, Eb = 102-90°, Ec = 10/120⁰ E E E The positive sequence component of the load current is (A) 1.3102-107⁰ A (B) 0.3322-120° A (C) 0.9962-120º A (D) 3.5104-81⁰ A +) + j1.002 0000 j1.002 0000 j1.0Ω vovo j1.0Ω 0000 j2.002 voor j3.002 oooo
= = Impedances Z₂ and z3 in parallel are in series with an impedance z₁ across a 100V,50Hz AC supply. Z₁ (6.25 +j1.25)ohms, Z₂ = (5 + j0)ohms and Z3 (5 - jxc)ohms. Determine the value of capacitance Xc said that the total current of the circuit will be in phase with the total voltage. What is then the circuit current and power?
The maximum efficiency of 10Kw D.C generator is 98% and occurs at 80% of full load. Find the total copper losses at rated load
1. Given the circuit below, the phase voltages are given by Van = 20040° Vrms. The source impedance is 5 + j7 per phase and the wire impedance is 8 +j10 per phase. Let the load impedance be Zy = 50 ohms. Find: Van Vin Ven a. II, and Ic b. c. VAN, VBN, and VCN, and VAB, VBC, and VCA Z₂ Z₂ Z₂ Zw Zw Zw B C le N
The circuit shows an unbalanced electrical installation powered by a positive sequence symmetrical three- phase network of 380 V compound voltage. The loads are single phase. Load 1 absorbs an active power of 950 W with f.d.p. 0.5 inductive. Load 2 absorbs an active power of 1,140 W with f.d.p. Unit. Load 3 absorbs from the network an active power of 760 W with f.d.p. 0.5 capacitive. Taking the network voltage URN as the phase reference, calculate: a) complex expressions of the line currents IR. Is. and IT RO- SO TO IR Is IT U₁-380 V CARGA 1 P₁ =950 W cos p1=0,5 ind. CARGA 2 P₂=1.140 W cos p₂=1 CARGA 3 P3=760 W cos p3=0,5 cap.
Please Answer My Questions in 30 minutes i'm very needed... Please thank u...