A) Define the following: Pipes in series, Dehydration, Critical point, Condensate, B) A 50-cubic ft tank contains gas at 50 psia and 50F°. It is connected to another tank that contains gas at 25 psia and 50Fº When the valve between the two is opened, the pressure equalizes at 35 psia at 50F° as in the adjacent figure. What is the volume of the second tank? Tank-2 BET Tar

Q: - A horizontal, cylindrical, tank, bar. The vessel is 5 m internal required to resist this pressure…

A:

Q: Example 7.2: A simple U-tube manometer is installed across an orifice meter. The manometric fluid is…

A: U tube manometer is the simplest pressure measuring devices and are used for measuring low pressure…

Q: 05: A rigid vessel (A) is connected to a spherical elastic balloon (B). Both contain air at the…

A:

Q: A throttling steam calorimeter is an instrument used for the determination of the quality of wet…

A:

Q: Soybean oil is being pumped through a uniform-diameter pipe at a steady mass- J mass of fluid…

A:

Q: Q:-Determine the force exerted on the cone curved surface. The liquid in the tank has a specific…

A: Given Absolute pressure of air in tank=151 kPa Specific weight of liquid=27 kNm3 So exerted pressure…

Q: 7. Joule-Thompson cooling of a gas occurs when the pressure of the gas drops as it goes through a…

A: If Z= f(x,y) is function of two variables say x and y. then total differential will be ;…

Q: Q₂. (A) For a long cylinder of inside radius ri, outside radius ro, and length L, as shown in…

A:

Q: Q.3) The gage pressure of the air in the tank shown in Figure below is measured to be 80 kPa.…

A:

Q: determine the gage pressure

A:

Q: 17. Calculate the pressure at point A in Fig. 2.50. The slope of the tube is 4 horizontal to 1…

A: Reservoir review is given.Calculate pressure at point A.

Q: A pipe (ID: 130 mm, OD: 165 mm, k=15 W/m²-K, Length: 2 meters) is insulated with several materials,…

A: Given Pipe have  Di=130mm D0=165mm K=15 W/(m2K) L=2m Inside fluid –Oil temperature T1=118℃ Outside…

Q: a- the volume flow rate of air at the inlet b- the mass flow rate of air at inlet and at exit c- the…

A: HGGHH

Q: The process of injecting water into a well under high pressure is called Thermal EOR a. False b.…

A: The oil is recovered from the reservoir by means of natural energy (pressure difference) but when…

Q: Specify a suitable orifice meter run for measuring 100 MMscf/day of GOM production sale gas entering…

A: An orifice meter run is a crucial instrument in the field of fluid dynamics and engineering,…

Q: If the suction pressure of compressor equal to discharge pressure then the work of compression for…

A:

Q: a.What is the approximation of Fick's equation (Hint: the first three terms)! b. A quiescent body of…

A: (a)   The first law of Fick’s gives the relationship between the diffusive flux and the…

Q: PMut The density of gases are calculated by P Calculate the air density using the data in table [P,…

A: Note: We’ll answer the first question since the exact one wasn’t specified. Please submit a new…

Q: A sample of helium gas was placed inside a cylinder enclosed with a moving piston. The gas expanded…

A: Given: Constant temperature process  Initial volume V1 is 10.9 Final volume V2 is 15.3  Work done in…

Q: Problem 2. Water is flowing through a circular pipe of radius R=2.5cm. The velocity profile of the…

A: Given, The velocity profile, v = v01-rR1/7 Where, v0 = 3 m/s The radius of circular pipe, R = 2.5 cm…

Q: Air enters an electric furnace at 100 kPa and 28°C with a volume flow rate of 22 m/min. At the exit…

A: Given that :At entering P1  =100KPaT1   =28 C  =28+273.15 = 301.15 KQ = 22 m3minAt exit P2  = 100…

Q: Use Bernoulli’s equation .

A: (a) v = 20.88 m/s(b) v = 1.886 m/s(c) v = 2.5668 m/s(d) v = 1.197 m/sExplanation:

Q: At time t = 0 the level of water in tank A is two feet above the level of water in tank B (the above…

A: The solution is given below.Explanation:Approach to solving the question: Detailed explanation:…

Q: As fluid flows in a piping system, changes in elevation, velocity, and pressure heads must be…

A:

Q: a) The temperature of the steam, b) The quality c) The volume percentage of the saturated steam

A: Consider the steam boiler has a saturated water mixture. Provided Data: V=1.5 m3m=750 kgP=1 MPa

Q: A 5 Wt% salt, 95 Wt% water solution flows into a tank at 15g/min, where it mixes with some salts…

A:

Q: 4. (20 points) Water (25°C) flows at 4.5 gpm (gpm is gallons per minute) in the system shown below.…

A: a) flow rates will be same along the pipe assuming no change in density.   1 gpm =0.00006309 m3/s…

Q: Oil SG=0.79 = 370 kPa gage A gasoline line is connected to a pressure gage through a double-U…

A: Considered a gasoline line is connected to a pressure gauge through a double-U tube manometer and…

Q: The condition for entrainment is O a. The entire mass of vapor may boil over into the liquid outlet…

A: Answer: d. The entire mass of liquid may boil over into the vapor outlet

Q: . If 10 Ib of water is evaporated at atmospheric pressure until the vohume of 288.5 ft' is occupied,…

A: Given data Mass of water evaporated (m)= 10 lb volume occupied (V2)= 288.5 ft3 formula of work done…

Q: A gas from a dry gas reservoir has a specific gravity of 0.735 at reservoir temperature of 200…

A: Given = SG = 0.735Tr = 200F = 659.67 oRPr = 1800 PsiaTo find = Z and Bg

Q: Q.2 Put the word (True) or the word (False) of the flowing expressions; (25 Pt.) True False 1. A…

A: Statement-1 is true. Statement -2 is false. Explanation is given below

Q: Question 4 A well-insulated piston contains ethylene. It is initially at 30 °C and 800 kPa with a…

A: Given Data  We need to find the following

Q: Carbon dioxide at 300 K and 1 atm conditions will be pumped through a channel with a square section…

A:

Q: Consider the surface of a pipe to be smooth with air flowing through it. Calculate for the air flow…

A: Given Details: Pipe is smooth. Air is flowing through this. Pressure at upstream point is 102 Psi…

Q: The water in an aboveground huge swimming pool is to be emptied by unplugging a 3-cm- diameter…

A:

Q: Calculate the diameter of a smooth pipe 150 m long to transmit air at 0.30 kg/s under isothermal…

A: Given Length of smooth pipe  l= 150m mass flow rate of air  m→= 0.3 kg/s The inlet pressure and…

Q: . a. A gas flowing in a pipe compresses as density falls. b. A gas is flowing in a pipe. As gas…

A: Answer  d. A gas flowing in a pipe expands as density falls A gas flowing in a pipe expands as…

Q: calculate the gauge pressure at the bottom

A:

Q: section( 2). 05: Water flowing through a pipe of 22 cm LD. at section (1) and 12 cm The discharge…

A:

Q: 9. In figure, pressure gage A reads 10.8 psi, while pressure gage B reads 11.7 psi. Find the…

A: Given, Pressure at A = 10.8 psi Pressure at B = 11.7 psi