A dc motor runs for daily from a constant 230 volt line. If the average currents are 28 amperes for 4 hrs, 33 amperes for 1 hrs,120 amperes for 2 hrs,25 amperes for 2 hrs and 5 amperes for 2 hour. Compute the monthly cost of energy at a rate of P11.00 per KWHR If it works for 23 days.

A dc motor runs for daily from a constant 230 volt line. If the average currents are 28 amperes for 4 hrs, 33 amperes for 1 hrs,120 amperes for 2 hrs,25 amperes for 2 hrs and 5 amperes for 2 hour. Compute the monthly cost of energy at a rate of P11.00 per KWHR If it works for 23 days.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: An energy meter revolves 190 revolutions of disc for a unit of energy. Find the number of…

A: Need to find the number of revolution for the given load conditions then find error

Q: Q3/A/ Two 5-bit numbers (10110 and 10001) are applied to a 5-bit parallel adder. The inputs carry…

A: The solution can be achieved as follows.

Q: a) A sinewave is having a frequency of 50 Hz and instantaneous value of 250 Volts at 1.2 milli…

Q: Consider a solar cell made of Alo.3Ga0.7As. When exposed to sunlight, it generates a photocurrent of…

A: Photocurrent (Iph)= 0.096 A Open circuit voltage(Voc)= 0.6 volts Here we will use the…

Q: generator is rated 100 MVA at 11 kV, and 90% power factor. The effective ac resistance to ohmic…

A: (Nothing is mentioned about whether the generator is 3 phase or 1 phase ,so iam taking 1 phase…

Q: 1 KW 0.5 KW rotor 57 KW 25 KW JU 60 KW In the diagram above of the DFEM, having 6 poles with main…

A: A power flow diagram is an important tool to analyze the performance of any system. when input power…

Q: Please write a short discussion for each number and explain. 1. Losses in a DC generator 2.…

A: Discussion about 1.Losses in a DC generator 2. Power stages in a DC generator 3. Efficiency of a DC…

Q: The RMS value of current, if the value of armature current is 13 A, a = 53 degrees, and B = 159…

A: We need to calculate RMS value of given wave , we will use RMS formula.

Q: 78 The induced emf of a dc machine running at 750 rpm is 220 V. The percentage increase in field…

A: we need to determine percentage increase in the field flux.

Q: Identify the effect of the power coefficient for a wind turbine if the power extracted by rotor…

Q: A compound generator has a no load voltage of 136 V and a full load voltage of 145 V. Calculate the…

Q: a) A sinewave is having a frequency of 60 Hz and instantaneous voltage of 200 Volts at 1.5 milli…

Q: A 6 pole DC wave wound generator has 34 armature conductors with flux per pole is 20 mWb and the…

A: The data given in the question are: P=6, A=2, Z=34,ϕ=20mWB,Eg=53V The formula of generated voltage…

Q: iii. Induced emf in the coil if the current fall from 3A to 1A a. 420V b. 620V c. 0.62V d. 0.42V

A: Put the given inductor value L and change in time

Q: Two 3300 V star-connected alternators running in parallel supply the following loads : 800 kW at…

A: Given, (i) The active power, P1=800 kW The power factor, cosφ1=1 (ii) The active power, P2=600 kW…

Q: Q1/ Calculate the voltage per phase for a 3-phase 1500 rpm, 4-pole alternator having a 16 conductors…

A: Eph = 4.44 kpkdϕf Tphkp = pitch factor = cos α2α -short pitch angle kd = Distribution factor = sin…

Q: The following questions refer to to a 6-pole DC generator has a simplex lap-wound armature…

Q: The figure below shows a vapor power cycle that provides process heat and produces power. The steam…

Q: ← Energy meter & Electrodyna... A 230V, 12A, 1-6 Energy meter makes 216 revolutions in 5 minutes at…

A: Given data- 230 V, 12 A, 1-ϕ energy meter, 216 revolutions in 5 minutes at half load, Power factor…

Q: When will the VAR - hour meter disc rotate in one direction for a lagging current and in the…

A: In this question we need to choose a correct option

Q: A 50-cycle voltage with maximum value of 24 V. (a) What will be the value of the instantaneous…

Q: i) The maximum value of sinusoidal voltage waveform ii) The value of voltage at 1.7 milli seconds.…

A: According to the bartleby's guidelines we have to solve only one question posted by students so…

Q: 5. A welder machine operates automatically as follows : 30A current in 10 seconds, 20A in 10 sec.,…

A: In this question we will find RMS value of given waveform....

Q: current through the armature of a motor changes from +3.0-A to - 3.0-A in 0.0030 s. A 104- V induced…

A: We need to find out the inductance for given Change in current

Q: The number of revolutions per kw for a 230v, 10A watt- hour meter is 900. On test at half load, the…

A: In this question we will find energy meter error at half load....

Q: A 3-phase, 6-pole, Y-connected, AC generator has a stator with 48 slots, each slot contains 60…

Q: 11. The variation of generated voltage of AC Generator can be varied through a) the speed of the…

Q: A 255 V, DC lathe machine, (not a 2 pole machine) has armature resistance and series resistance are…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: Instantaneous voltage is multiplication of the resistace and .......... current in the resistive…

A: According to the Ohm’s law, the voltage is the product of the current and the resistance. Similarly,…

Q: A 220 V DC Machine supplies 20 A at 200 V as a generator. The armature resistance is 0.2 ohm. If the…

A: Given a 220 V DC machine, As a generator: Armature current, Ia=20 A Terminal voltage, V = 200 V…

Q: 1. A 6 ampere supply has a frequency of 25 Hz. Find the instantaneous value of current a. at 0.00530…

Q: Q3: A universal fractional horsepower series motor has a resistance of 30 2 and a total inductance…

A: Given data: Resistance:30 ohm Total inductance: 0.5H DC voltage: 250V current: 0.8A r.p.m : 2000

Q: Find value of voltage induced in a coil. if a coil has 780 turns and a constant flux of 7mWb and a…

A: Given values are - Numbers of turnsN=780Constant fluxϕ1=7mWbChanging fluxdϕ2dt=13mWb

Q: Leakage reactance of the machine is included in the armature reaction reactance in Magneto Motive…

A: Need to find true false

Q: A series DC motor has a resistance of 5 0 between its terminals. The motor runs at 1,210 rpm at. 230…

Q: The meter constant of a single phase 230 V, induction energy meter is 800 rev/ kWh. What will be the…

A: Given: For a single phase energy meter V=230 VI=20 Acosϕ=0.7 lagMeter constant=800 rev/kWh

Q: Ia a α 10.89 O 2.91 O 5.16 O 82.46

Q: 14. A 50- cycle current has a maximum value of 7.5 amp. What will be the instantaneous value of…

A: We need to select correct option for given current .

Q: The field winding of a d.c. motor is connected to a 110V supply. At a temperature of 18°C, the…

A: Given: Voltage, V=110V At a temperature of 18°C, the current drawn is 0.575 A. T1=18° and I1=0.575A…

Q: a) A sinewave is having a frequency of 60 Hz and instantaneous voltage of 100 Volts at 1.5 milli…

A: According to the bartleby's guidelines we have to solve only one question posted by students so…

Q: Please write a short discussion for each number and explain. 1. Losses in a DC generator 2.…

Concept explainers

Motor Load, Torque, and Power Quality Requirement

An electric motor is a gadget that changes electrical energy into mechanical energy over to follow up on a mechanical burden. The weight set on the motor because of this mechanical movement is known as motor load. Appropriately matching the motor burden to the engine is vital to forestall harm to the engine or wasteful and unnecessary expensive activity. Engines perform such undertakings as moving a thing starting with one spot then onto the next, cutting it, changing its shape, etc. The motors might be evaluated as far as a few variables including power yield, voltage, current, and temperature. Harm to an engine might happen when it is worked under over the top engine load contrasted with its appraised limit.

Question

A dc motor runs for daily from a constant 230 volt line. If the
average currents are 28 amperes for 4 hrs, 33 amperes for 1
hrs,120 amperes for 2 hrs,25 amperes for 2 hrs and 5 amperes for 2
hour. Compute the monthly cost of energy at a rate of P11.00 per
KWHR If it works for 23 days.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

3- A shunt machine connected to 250V mains has an armature resistance (including brushes) of 0.120 and the resistance of the field circuit is 1002. Find the ratio of the speed as a generator to the speed as a motor. The line current in each case being 80A 1001 W 200
i need Full detailed Steps
When one coil of a magnetically coupled pair has a current of 5 A, the resulting fluxes p11 and p12 are 0.40 mWb and 0.80 mWb, respectively. If the number of turns N1 and N2 are 500 and 1500, respectively, what is the self-inductance L2? a. 560 mH b. 1080 mH c. 540 mH d. 1060 mH
Q2) An energymeter is designed to make 100 revolutions of disc for one-unit energy. Calculate the number of revolutions made by it when connected to load carrying 20 A at 230 V and 0.4 p.f. for two hours. If it actually makes 360 revolutions, find the percentage error? Comment?
4. Two 3300 V star-connected alternators running in parallel supply the following loads : 800 kW at unity p.f.; 600 kW at p.f. 0-8 lagging; 400 kW at p.f. 0-707 lagging The armature current of one machine is 150 A at p.f. 0-85 lagging. What is the armature current, output and p.f. of the other machine? [200 A; 1071 kW; 0-937 lagging]
A 3-phase, 60 Hz, Y-connected, AC generator has a stator with 60 slots, each slot contains 12 conductors. The conductors of each phase are connected in series. The flux per pole in the machine is 0.05 Wb. The speed of rotation of the magnetic field is 720 RPM. What are the resulting RMS phase voltage and RMS line voltage of this stator? Select one: O a. V = 2262.0 Volts and Vr = 3917.8 Volts O b. V = 2770 Volts and VT = 2770 Volts O c. Vộ = 1599.4 Volts and VT = 1599.4 Volts O d. V = 1599.4 Volts and VT = 2770 Volts O e. None
6. The time for 1 cycle is 5 micro second. Find the frequency. a. 1500 Hz b. 1500 kHz C. 200 kHz d. 200,000 kHz C.
26
DC parallel motor fed from the source 220 volts rotating at 500rpm. When the product takes 20 amperes, find the speed at which the motor rotates if the torque increases to twice, noting that the resistance of the product is 0.2 ohm
EE energy engineering Solve the The part indicated in the photo ( last two questions)
The meter constant of a 245 volt, 70 ampere, single phase energy meter is 1650 revolutions per KWh When tested at quarter load, rated voltage and 0.8 power factor, the meter is found to make 100 revolutions in 65 seconds. Determine the percentage error at quarter load
2. A 60- cycle engine- driven alternator has a speed of 20 rps. How many poles are there in the alternator? a. 1.5 b. 6 C. 40 d. 360