A DC compound generator has no-load armature current of 1A. Armature resistance is 1N and shunt field resistance is 1192. Series field resistance is 42. A 360W load gets connected to the terminals that starts drawing load current of 4A. Determine the induced voltage at no-load and full-load.

A DC compound generator has no-load armature current of 1A. Armature resistance is 1N and shunt field resistance is 1192. Series field resistance is 42. A 360W load gets connected to the terminals that starts drawing load current of 4A. Determine the induced voltage at no-load and full-load.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A long - shunt compound generator delivers a load current of 5OA at 500V and has armature, series…

A: Long Shunt Compound DC Generator A long shunt compound dc generator is a kind of compound wound dc…

Q: 1- Power taken by the prime mover of an alternator in case of no-load goes to a. Produce power in…

Q: Some measurements of a shunt generator are given in the table below. Fill in the blanks in the table…

A: Given shunt generator measurement as shown

Q: (iv) Define two parameters which are indices of performance of a DC generator and there values…

A: The Two parameters which are indices of a performance of a DC generator and there values affect the…

Q: A 380-V, 60-Hz, A-connected, four-pole synchronous generator has a per-phase synchronous reactance…

A: As per our policy we can provide solution of first three questions only.

Q: long-shunt compound generato

Q: In a long shunt DC generator, Shunt winding is parallel with the Armature winding of the DC…

A: Given statement In a long shunt DC generator, Shunt winding is parallel with the Armature winding of…

Q: 1. Which of the following is/are a reason for the drop in terminal voltage of a separately excited…

A: There is an typing error is question B2 Please correct it It's not latninated it is laminated

Q: A 18 kW shunt generator having an armature circuit resistance of 0.5 ohm and a field resistance of…

Q: Chorded windings are used in induction motors because they

A: Induction motor works on the magnetic induction principle. The induction motor always rotates less…

Q: + 3.26 A 4-pole lap-wound de generator is designed to have an average air gap flux density of 0.8 T.…

A: 8 pole lap wound(A=P=4) B=0.8TRa=0.3ΩVbd=2V

Q: the circuit shown in the figure, a voltage with a peak value of 212.16 V is applied to the input of…

Q: 1 use direct subfarction on the following binary numbers: ☺ lloo- lool

Q: Draw the Terminal Characteristics of the following Generators. (i)Shunt DC Generator (ii)Series DC…

Q: A 300 KW and 600 V Long shunt compound DC generator has shunt field resistance 100 2 armature…

A: There are two types of DC generators depends on the way in which their fields are excited.…

Q: The shunt generators are together supplying 100 A to a load. Generator 1 gives 400 V on no-load…

A: It is given that: IL=80 A Generator 1: Eg1= 400 V Vt1=360 V Ia1=100 A. Generator 2: Eg1= 400 V…

Q: 4. A short shunt compound generator supplies 100A at 110V. Armature resistance is 0.0502 and the…

Q: Draw the circuit. A compound generator has 120V induced voltage. The armature resistance is 1ohms,…

A: Type of Compound Generator Long Shunt Compound Generator (Series field winding connected in series…

Q: 13. A 250-V, 50-kW shunt generator has 1000 turns on each pole of its field winding. On no load a…

Q: For a dc generator, the current of the shunt winding is small as compared to armature current true O…

A: In a DC generator the shunt winding or field winding is characterized as high Resistance to handle…

Q: A 240-V, short-shunt, cumulative compound generator is rated at 100 A. The shunt field current is 3…

A: Given,Voltage, V=240 VRated current, IL=100 AShunt field current, If= 3 AArmature resistance, Ra=50…

Q: How can we keep terminal voltage at constant level even when the load is gradually increases in…

Q: 4. A 20-kW, 250-V dc series generator has armature and series field winding resistances of 0.095 Q…

A: Given 20kW 250V Armature resistance = 0.095 Ohms Series field winding resistance=0.16 Ohms

Q: Which of the following factor is responsible for negative voltage regulation of a DC generator? Over…

A: In this question we will find in which dc generator negative voltage regulation occurs...

Q: A)-An 8-pole lap wound d.c shunt generator has 120 slots with 4 conductors per slot. If each…

Q: The rating of a 3 phase synchronous generator is given as 2 MVA, 4400 V, 60 Hz. If the synchronous…

A: It is given that:- S = 2 MVAVL = 4400 Vf = 60 HzXs=2.6 Ohmra =?

Q: A 6-pole, lap-wound, DC generator has a useful flux per pole of 0.08 Wb. The armature winding…

Q: Q1. The per-unit d-axis and g-axis reactance's of a salient-pole generator are 0.9 and 0.6…

Q: Two DC Shunt generators are connected to a common load with linear load characteristic. Generator A…

A: Use nodal analysis to find the terminal or load voltage . Then find the current from the each…

Q: A 20 kW COMPOUND GENERATOR WORKS ON FULL LOAD WITH TERMINAL VOLTAGE OF 250V. THE ARMATURE, SERIES…

Q: A 150 kW, 250-volt compound DC generator has its field windings which are connected in long shunt.…

A: First using ohms law we will find current in shunt field winding. Now using following relation we…

Q: An 8-pole lap wound d.e shunt generator has 120 slots with 4 conductors per slot. If each conductor…

Q: Q2-A 4- pole lap-wound, 900 r.p.m shunt generator has armature and field resistances of 0.442 and…

A: generated emf = flux×speed×no. of armature conductors60×no. of polesno. of parallel paths. using…

Q: Explain Compound DC. :- generator, types also describe its and terminal characteristics of compound…

Q: enerator delivers (16*10) A. Given that the shunt field is 133 ohms, series field resistance is…

Q: Q2-A 4 pole lap-wound, 900 r.p.m shunt generator has armature and field resistances of 0.442 and…

Question

A DC compound generator has no-load armature current of 1A. Armature resistance is 12 and
shunt field resistance is 1192. Series field resistance is 42. A 360W load gets connected to the
terminals that starts drawing load current of 4A. Determine the induced voltage at no-load and
full-load.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

continued

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

(iv) Define two parameters which are indices of performance of a DC generator and there values affect the performance of the generator?
I need the answer quickly
For a dc generator, the current of the shunt winding is small as compared to armature current true False
In a long shunt DC generator, Shunt winding is parallel with the Series filed winding and Armature winding of the DC generator. Select one: True False
Please solve this problem step by step and illustrate your answer properly. Write your answer in a piece of paper please. Box the final answer.
short shunt compound generator delivers a load current of 10A at 200V and has a shunt field resistance 200 ohms. The shunt field current of 2A. Then armature delivers a current of a.10A b.8A c.11A d.12A
Two separately excited DC generators are connected in parallel to supply a total loed of 300 A The two generators have the following paraneters: GI R. - 0,250 and induced E.M.F-220 v G2 R = 0.32 and induced E.M.F-250 V Find Mathematicall: (1) The armature current of euch generator, The bus-bar voltage, (ii) The power shuring by each generator, (ii) Repeat (i) and (ii) if the load current decreases to 100A.
Q/ dc shunt generator 4 pole with 500 condcutor , wave running at speed 1000 r.p.m the resistance of armature and field are 0.02 , 55 ohm and delivering load 43.12kwatt at terminal voltage 220 volt, the iron losses is 750 watt 1-Torque developed by the prime mover .........and The torque developed by the armature ........... when running at 1000 r.p.m * 2-The load current ,,,,,,,,,,,,when the speed drops to 800 r.p.m. if If is unchanged ? * 3-Output of the prime motor…….kwatt * 4-Mechanical , electrical and overall efficiency …….. * 5-Flux per pole is......... wb *