Answered: A data stream of 500 Mbps is to be…

A data stream of 500 Mbps is to be transmitted through a wireless channel using 32-PSK technique. Find the minimum bandwidth requirement of wireless channel.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Consider for a GSM transmitter

A: Given data: Carrier frequency, f= 1900 MHz Symbol rate, BS =30 Mbps

Q: If 280 kbps is to be sent over a noiseless channel with a bandwidth of 20 kHz, then how many…

A: Given information: Required data rate is r=280 kbps=280×103 bps Channel bandwidth B=20 kHz=20×103 Hz

Q: B) Select the best answer from Multiple choices: 1. In comparison of both SSB and VSB , we say: a-…

Q: Six 100-kbps connections are multiplexed together. A unit is 1 bit. Determine the rate of the…

A: Given No.of connections are = 6 Each unit is 1 bit capacity To determine transmission rate

Q: AM transmitter has a total power (480kw) and carrier frequency of 280kHz, transmits audio wave of…

Q: Television channel are 6MHz wide . a) How many bits/sec can be sent if eight levels signals are…

A: The bandwidth of the channel, BW=6 MHz Level of signals, V=8

Q: 5. a. If the bias voltage is kept constant, what happens to the average current gain of the…

A: As per our company guidelines we are supposed to answer only first three subparts kindly repost the…

Q: Consider the following types of signals and determine how many of each of them could Assign within a…

A: According to the question, consider the following types of signals and determine how many of each of…

Q: if a noiseless channel, if the bandwidth is 2 KHZ and there are 16 voltage levels, what is thw Data…

Q: For a transmission medium, SNRD is given as 30. The given capacity of 600 Kbps is valid for which…

Q: IV- The datasheet for a certain D-MOSFET gives Vp= 5V and Ipss=8mA (a) Is this device p channel or n…

A: Given: The datasheet for a certain D-MOSFET gives: VP=5 VIDSS=8 mA To find: (a) Is this device p…

Q: The minimum spectrum allocation required for W-CDMA is

A: The correct solution is provided in the following section.

Q: Question 4 ( A voice-grade telephone line with bandwidth of 4 kHz (0- 4kHz) is to be used in…

A: Given,Bandwidth is,BW=4kHzFrequency deviation is,∆f=100 Hzandd=0

Q: or Delta modulator, how many bits transmitted per sample?

A: In this case ,the number of bits transmitted per sample for a delta modulator is to be determined.

Q: what is the realistic channel capacity of a communication channel of 25KHZ that has 20db signal to…

A: Given data,Signal-to-noise ratio (dB) SNR(dB)=20 dB Bandwidth BW=25×103 Hz

Q: (5) If in a communication system BPSK, QPSK, QASK-8 are used for transmi digital data. (a) Determine…

A: Bandwidth of each modulation scheme for BPSK BW= 2Rb =2 x 2000 = 4000 For QPSK BW = Rb = 2000 For…

Q: A PCM-TDM system multiplexes 24 voice-band channels. Each sample is encoded into seven bits, and a…

Q: If 25 MHz of total spectrum is allocated for a duplex wireless cellular system and each simplex…

A: We are authorized to answer one question at a time since you have not mentioned which one you are…

Q: B. Why VSB modulation is used in TV picture transmission?

A: The explanation is as follows.

Q: 4. a) A communications link between two towns 38km apart is required to operate at a bit rate of…

Q: You look at an AM signal with an oscilloscope and see that the maximum Vpp is 100 volts and the…

A: For an AM signal with an oscilloscope Given : Vppmax=100 VoltsVppmin=25 Volts calculation of…

Q: Binary data is to be sent at the rate R, = 100 K bits/s over a channel with 40dB transmission loss…

Q: A typical modem transmit data serially at 4800 bps by encoding 2-bit data into one encoded symbol.…

A: Step 1:Given the following:Bit Rate (Rb) = 4800Number of encoder bits (N) = 2 Step 2:a. To solve for…

Q: Q4: Unseen operation in the same band as other types of wireless services, i.e. without interfering…

A: Frequency-Hopping Spread Spectrum (FHSS) is a modulation technique that involves rapidly switching…

Q: downstream communication?

Q: We need to send 210,000 bits per second over a noiseless channel using 128- QAM. Determine the…

A: In this question we will find bandwidth for transmitting signals through noiseless channel....

Q: A data of 240 kbps is to be transmitted over a channel of 5 kHz bandwidth. The transmission should…

Q: In a broadcasting studio, a 1000kHz carrier is modulated by an audio signal of frequency…

A: Given: An audio signal of frequency range100-5000Hz. fc=1000 kHzfmmin=100 Hz=0.1 kHzfmmax=5000 Hz=5…

Q: xplain why we can still receive monophonic FM signal with our stereophonic FM receiver by showing…

A: An stereo receiver is an amplifier and switching device used for a stereo system. The input given is…

Q: Optical fibres are generally better than copper cables for a number of reasons. Some of the…

A: We need to select the correct statements from the following i. Optical fibres have a bigger…

Q: If in a communication system BPSK, QPSK, QASK-8 are used for transmission and reception of digital…

Q: Calculate the Eb/No in 64-QAM system. Compare the results. (b) What are the maximum transmission…

Q: Writing frequency = fA= 80MHZ. Reading Frequency = fg = 50MHZ. Burst Length = No. of data items to…

Q: A data stream of 60 Mbps is to be transmitted through a wireless channel using 64-QAM technique.…

A: Given, A data stream of, Rb=60 Mbps Transmitted through a wireless channel using, M = 64 - QAM

Q: requency Division Multiplexing (FDM) Consider FM radio, which consists of 200 channels, each 150 kHz…

A: According to the question, for the given FM radio, which consists of 200 channels, each 150 kHz wide…

Q: a) Explain with a neat diagram the construction and working of a superheterodyne receiver.

A: solving only a part Block diagram of super heterodyne receiver is as shown below.

Q: which of the following requirement must be met for fast communicationt A.High sampling rate B.High…

Q: A communication channel of bandwidth 75 kHz is required to transmit binary data at a rate of 0.1…

Q: State a bit rate and maximum number of channels in T-1 and T-3 telephone TDM system.

A: For T-1 Bit rate is 1.544 Mbps Maximum number of channels are 24

Q: Assume that a voice channel occupies a bandwidth of 4 kHz. We need to combine three voice channels…

A: Given data: A voice channel occupies a bandwidth of 4 kHz. Let the voice channel has spectrum as…

Q: 9.SSB AM is not suitable for high quality music transmissions because: a one sideband containing…

A: SSB modulation : SSB is Amplitude modulation technique in which the only one side band present and…

Question

A data stream of 500 Mbps is to be
transmitted through a wireless channel
using 32-PSK technique. Find the
minimum bandwidth requirement of
wireless channel.
A 15.625 MHz
B 50 MHz
C
D
200 MHz
100 MHz

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

a) The Channel is a key component to consider in all communications systems. Give two examples of a channel commonly used in communications systems, and for each, the key properties that can impact transmission. Compare twisted-pair and fibre-optic wired channels. Explain how the use of differential signals can be used to improve the signal to noise ratio in a twisted pair channel. i) ii)
The minimum spectrum allocation required for W-CDMA is a. 5MHz b. 2MHz c. 500KHz d. 100KHz
d. MTN AMPS (advanced mobile phone system) cellular operator is allocated a frequency of 12.5 MHz for each simplex band, and if Band-guard is taken to be 10 KHz, and Bc is 30 kHz, compute the number of channels existing in an FDMA system. Also find the new allocated frequency if the computed number of channels was increased by 20%.
What is the minimum spectrum allocation required by W-CDMA? a) 5 MHz b) 20MHZ c) 1.25 MHz d) 200 KHz
In an FDMA-based multiple access system, each user is assigned an 80 kHz channel for full-duplex communication. There are 1000 channels in the system.Depending on the information given above, if the initial frequency of the frequency spectrum used by the FMDA system in one direction is 1000 MHz, which of the following is the correct spectrum of the bond's spectrum.A1.000.000 KHz - 10000.080 KHzB1000.000 KHZ - 1.000.040 KHzC1.000.000 KHZ - 1.040.000 KHzDNoneE1.000.000 KHZ - 1.020.000 KHZ
The minimum spectrum allocation required for W-CDMA is a. 5MHz b. 2MHz c. 500KHz d. 100KHz
Networking A digital signal is to be designed to permit 100 Mbps for a bandwidth of 10 MHz. Determine: (1) Number of levels (2) signal to noise ratio. According to Shanon Capacity
Please can you give me the full solution for this question.
Consider a telephone line initially noiseless channel having bandwidth and signal level determined by the network engineer. Calculate maximum data rate. After certain distance the channel becomes extremely noisy, so that the noise is strong which faints the signal .Calculate the capacity of the channel.
2 Q3) Transmitter device broadcasting an AM-DSB with 40w total power and the carrier is 8 cos(4m x 105t). Find the modulation index, the efficiency and the modulating AC signal if the USB frequency is 204 KHz. A-^/. souv vet
Discuss the role of modulation techniques in wireless transmission. Provide examples of modulation schemes and their applications.
The Channel Coding Theorem