A dam is triangular in cross-section with the upstream face vertical. Water is flushed with the top. The dam is 8m high and 6m wide at the base and weighs 2.4 tons per cubic meter. The coefficient of friction between the base and the foundation is 0.8. Determine (a) maximum and minimum unit pressure on the foundation, and (b) factors of safety against overturning and against sliding.

A dam is triangular in cross-section with the upstream face vertical. Water is flushed with the top. The dam is 8m high and 6m wide at the base and weighs 2.4 tons per cubic meter. The coefficient of friction between the base and the foundation is 0.8. Determine (a) maximum and minimum unit pressure on the foundation, and (b) factors of safety against overturning and against sliding.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

5. A dam is triangular in cross-section with the upstream face vertical. Water is flushed with the top. The dam is 8m high and 6m wide at the base and weighs 2.4 tons per cubic meter. The coefficient of friction between the base and the foundation is 0.8. Determine (a) maximum and minimum unit pressure on the foundation, and (b) factors of safety against overturning and against sliding. (* 6. A gravity dam of trapezoidal cross section with one face vertical and horizontal base is 22m high
1.) Situation 11. A rectangular vertical gate, 0.60 m wide and 2.45 m high and weighing 1.78 kN, is hinged at the bottom. There is water on both sides of the gate, 4.9 m on one side and 1.80 m on the other. The gate, however, is held in place by a horizontal force F applied at the top of the gate. Under the above conditions, determine the horizontal force F and the amount and direction of the reaction at the hinge. Assume weight of water to be 9.81 kN/cu.m. W.S. 2.45 m 0.60 m B 1.78 kN 2.45 m 1.80 m P.- P: hinge
Subject: Statics of Rigid Body Show Complete solution
A dam is subjected to a varying load as shown w1 kN/m X (x+3) m w2 kN/m w3 kN/m
NOTE: ANSWER SHOULD BE ON THE CHOICES
A masonry dam with one end face vertical, has a base 3.3 m and 7.2 m high. The vertical face is subjected to water pressure, the (s 2.4) triangular in cross section, water standing 4.5 Neglect hydrostatic uplift. Compute the following: above the base of the dam. a. The vertical reaction of the foundation. b. Distance of the vertical reaction from the heel. c. Factor of safety against overturning.
Civil engineering -Hydraulics
A masonry dam has a trapezoidal cross section, 25 m high, crest width of 3 m and base length 18 m. The upstream face slopes down 12 m in 25 m and the downstream faces slopes down 3 m in 25 m. If the water at the upstram face stands flushed with the crest and assuming no hydrostatic pressuruplift. Compute the factor of safety aginst overturning. The specific gravity of concrete is 2.40. a. 5.44 b. 5.25 c. 2.57 d. 2.67
1. A masonry dam of trapezoidal cross section, with one face vertical and horizontal base. The dam is 8-m high and has a thickness of 70-cm at the top and 4-m at the bottom. The unit weight of the masonry is 23.450 N/cu.m. What is the depth of water on the vertical side if the resultant force intersects the base at the downstream edge of the middle third. Neglect the hydrostatic uplift.