A cylindrical spool with mass m, radius R and moment of inertia Icm about its axis, is being pulled horizontally with a string that is wrapped around it, as shown in the figure. The coefficient of static friction between the spool and the table is Find the maximum value of the force F such that the spool will roll without slipping.

A cylindrical spool with mass m, radius R and moment of inertia Icm about its axis, is being pulled horizontally with a string that is wrapped around it, as shown in the figure. The coefficient of static friction between the spool and the table is Find the maximum value of the force F such that the spool will roll without slipping.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter11: Angular Momentum

Section: Chapter Questions

Problem 32P: A solid cylindrical wheel of mass M and radius R is pulled by a force applied to the center of the...

See similar textbooks

Related questions

Q: A (Yo-Yo) of mass m has an axle of radius b and spool of radius R. It's 1 moment of inertia be taken…

A: Given data ,Mass of the yo-yo=mMoment of Inertia , I=12mR2Axle radius=bSpool radius=RWe assume ,…

Q: A sied with a mass of 25.0 kg rests on a horizontal sheet of essentially frictionless ice. it is…

A: Mass of sled (m) = 25 kg initial speed of sled (u) = 0 msLength of rope (L) = 3 m Number of…

Q: The block on a smooth inclined plane is moving down with a constant acceleration of 4 m/s. m, The…

Q: A mass, m₁ = 8.00 kg, is on a 30.0° incline and it is attached to another mass, m₂ = 10.0 kg, on a…

Q: A wheel with a radius of 0.5 m and a mass of 100 kg turns freely at 50 rev/min. The wheel can be…

A: Given data: The radius of wheel is r=0.5 m. Mass of wheel is m=100 kg. Velocity of wheel is N=50…

Q: Two buckets of mass m1 = 18.5 kg and m2 = 12.5 kg are attached to the ends of a massless rope which…

Q: A centrifuge rotor rotating at 9500 rpmrpm is shut off and is eventually brought uniformly to rest…

A: The angular velocity of the centrifuge root is

Q: A model airplane with mass 0.749 kg is tethered to the ground by a wire so that it flies in a…

A: Given data The model airplane has a mass of m = 0.749 kg. The radius of the horizontal circle is r =…

Q: Determine ∑i τp,i, the sum of the torques on the seesaw. Consider only the torques exerted by the…

A: Since the seesaw is symmetric around the pivot, there is no net torque produced by the gravitational…

Q: ionary. Then, the pulley is allowed to rotate as the block falls. Assum

A: Given: To find the values using given figure is calculated as: As per policy, here solved only…

Q: Probiem 2: A string is wrapped around a pulley with a radius of 3.0 cm and no appreciable friction…

Q: Friction on the concrete surface creates a couple moment of MO = 100 N ⋅ m on the blades of the…

Q: A disk of radius 25.0 cm is free to turn about an axleperpendicular to it through its center. It has…

A: Part-a Given: The radius of the disk, r = 25 cm. The function of acceleration, a = At. The…

Q: Two buckets of mass m¡ = 21.1 kg and m2 = 13.1 kg attached to the ends of a massless rope which…

A: Given:- m1 = 21.1 kg m2 = 13.1 kg The mass of pully mp = 9.13 kg The radius of the pully rp =…

Q: A mass M of 3.60E-1 kg slides inside a hoop of radius R=1.60 m with negligible friction. When M is…

A: Given, A mass M=0.36 kg slides inside a hoop of radius R=1.60 m with negligible friction. When M is…

Q: A block with mass m1 = 3.00 kg sits on a horizontal table and is attached to a rope. The rope then…

Q: The coefficient of static friction between a certain hoop and a horizontal floor is 0.40. If the…

Q: A small block with mass 0.130 kg is attached to astring passing through a hole in a frictionless,…

A: The forces acting on the system and if they contribute to a net torque. Weight of the block (W) is…

Q: A ball of mass m, =5.7 kg and a block of mass m, =3.1 kg are connected with a lightweight string…

Q: The figure below shows a Yo-Yo of mass m =245 g which has an axle of radius r=1.2 cm and a spool of…

A: Given information: The symbols have the same meaning as stated in the question.

Q: A block (mass -3.0 kg) is hanging from a mass-less string that is wrapped around a pulley (moment of…

A: Solution: as given in the question: I = 1.3x10-3kg m2 R = 0.05 m L = 120 cm = 1.2 m mass of the…

Q: Calvin places his stuffed tiger Hobbes at the edge of a playground merry-go-round 0.92 m from the…

Q: Suppose you exert a force of 170 N tangential to the outer edge of a 1.355-m radius 73-kg grindstone…

A: The torque is

Q: How much torque is produced by opening a jar of pickles if the lid on the jar has a radius of 3.5…

A: Given that, The radius of the jar, r=3.5 cm=3.5×10-2 m The tangential force exerted, F=150 N Torque…

Q: A sphere of mass 5 kg and a block of mass m2 =3 kg are connected by a light cord that passes over a…

A: tension in the string connecting m1 = m1(g-a) = 5(g-a) ...(1)For m2 :T2 - μm2g = m2aT2 = 3 ( 0.1g +…

Q: A large wooden turntable in the shape of a flat uniform disk has a radius of 2.0 m and a total mass…

Q: The wheel of a car has a radius of 0.300 m. The engine ofthe car applies a torque of 240 N*m to this…

A: The counter torque is given as

Q: The resultant of the three parallelforces P, 2P and 3P, with their corresponding locations, is…

A: Since all forces are parallel so magnitude of resultant R = P+2P+3P =6P Now for position of R…

Q: Atwood machine is constructed using two wheels (with the masses concentrated at the rims). The left…

Q: A hollow sphere (M = 3.0kg and R = 60cm) is rolling down an inclined surface with a height of 2.0…

A: Given mass of hollow sphere M=3.0 kgRadius of sphere R=60 cm R=0.06…

Q: The circular disk of 270-mm radius has a mass of 36 kg with centroidal radius of gyration k⎯⎯k¯ =…

Q: yo-yo with an inner cylinder of r = 3.5 cm and outer radius of R = 6.50cm is at rest on a theta = 30…

A: Detailed explanation is given below, any further doubts can be asked. ThankyouExplanation:

Q: A half-Atwood machine is made from a 2 kg box resting on a friction-less ramp (inclined 10 ̋above…

Concept explainers

Torque

Torque is the rotational equivalent of linear force in physics and mechanics. Based on the course of study, it is also known as the moment of force, rotational force, or turning effect.

Question

A cylindrical spool with mass m, radius R
and moment of inertia Icm about its axis,
is being pulled horizontally with a
string that is wrapped around it, as shown
in the figure. The coefficient of static
friction between the spool and the table is
Find the maximum value of the force F such
that the spool will roll without slipping.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 6 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

What is the torque abot the origin of the force if it is applied at the point whose position is:
A boy rides his bicycle 2.00 km. The wheels have radius 30.0 cm. What is the total angle the tires rotate through during his trip?
Under what conditions can a rotating body be in equilibrium? Give an example.
The precession angular velocity of a gyroscope is 1.0 rad/s. If the mass of the rotating disk is 0.4 kg and its radius is 30 cm, as well as the distance from the center of mass to the pivot, what is the rotation rate in rev/s of the disk?
What three factors affect the torque created by a force relative to a specific pivot point?
When opening do you push on it perpendicularly with a force of 55.0 N at a distance of 0.850 m from the hinges. What torque are you exerting relative to the hinges?
Check Your Understanding A hollow cylinder is on an incline at an angle of 60 . The coefficient of static friction on the surface is s=0.6 . (a) Does the cylinder roll without slipping? (b) Will a solid cylinder roll without slipping?
A man stands on a merry-go-round that is rotating at 2.5 rad/s. If the coefficient of static friction between the man’s shoes and the merry-go-round is s=0.5 , how far from the axis of rotation can he stand without sliding?
A solid cylinder of radius 10.0 cm rolls down an incline with slipping. The angle of the incline is 30 . The coefficient of kinetic friction on the surface is 0.400. What is the angular acceleration of the solid cylinder? What is the linear acceleration?
A yo-yo can be thought of a solid cylinder of mass m and radius r that has a light string wrapped around its circumference (see below). One end of the string is held fixed in space. If the cylinder falls as the string unwinds without slipping, what is the acceleration of the cylinder?
Check Your Understanding The fan blades on a jet engine have a moment of inertia 30.0kgm2 . In 10s, they rotate counterclockwise from rest up to a rotation rate of 20 rev/s. (a) What torque must be applied to the blades to achieve this angular acceleration? (b) What is the torque required to bring the fan blades rotating at 20 rev/s to a rest in 20s?
When tightening a bolt, you push perpendicularly on a wrench with a force of 165 N at a distance of 0.140 m from the center of the bolt. How much torque are you exerting in newton-meters (relative to the center of the bolt)?