A cylindrical sample of soil,  having cohesion of 0.8 kg/cm2 and angle of  internal friction of 20 degrees is subjected to  a cell pressure of 1.0 kg/cm2.  Determine the maximum deviator stress  at which the sample will fail. Determine the angle made by the failure  plane with the axis of the sample.

Q: 3. If Liquidity Index (LI)0 <LI <1, the behavior of the soil is... A. dried C. liquid B. plastic D.…

A: 1)If Liquidity Index (LI)&lt;0 ---&gt; then, Soil is in "Semi-Plastic State or dry(Solid) State." 2)…

Q: There is an upward flow of 0.06 ml/s through a sand sample with a coefficient of permeability 3 ×…

A: Q = k i A    =k ×hL×A Where, Q  - Discharge = 0.06 x 10-6 m3/s k - Coefficient of permeability = 3…

Q: Root time method is used to determine A. C,, coefficient of consolidation C. a, coefficient of…

A:

Q: A normally consolidated clay sample, which is fully saturated, was consolidated in the triaxial cell…

A: Given data- A normally consolidated clay sample. ½ (σ1 – σ3) = 1/3 σ3 and ½ (σ1′ + σ3′) = 2/3 σ'3…

Q: 8. Choose from the following, the coulomb suggested a solution to this equation r= o • A. tf = C-G…

A:

Q: solve question 5 please

A: It is asked to solve the question 5 only

Q: In a triaxial test, total increament in cell pressure and total increament in deviator stress are…

A:

Q: The shear strength parameters of the soil are C = 15kN/m2 and p = 200. Undrained triaxial test is…

A: Givenshear strength parameterC=15 kN/m2  ϕ=20Cell pressure (σ3)=200 kN/m2pore pressure (u)=50 kN/m2…

Q: The effective size of particles of soil is de A. D0 C. Da В. D30 D. D

A: Hi! Thank you for the question As per the honour code, We’ll answer the one question since the exact…

Q: Question A dry sand specimen is put through a triaxial test. The cell pressure is 50 kPa and the…

A: Given - The cell pressure = 50 kPa The deviation stress = 100 kPa To find -  The angle of internal…

Q: A compression test is performed on a soil sample under drained condition. Determine the value of…

A:

Q: Undrained triaxial tests are to be carried out on soil samples which have property as c = 0.28…

A:

Q: 6 kN/m 3 m

A:

Q: When an unconfined compression test was conducted on a cylindrical soil sample, it failed under an…

A:

Q: A fine sand sample undergoes consolidated undrained test. A confinement pressure of 40 kN/m² was…

A: Answer We are given  Confinement pressure σ3 = 40 KN/m2  deviator stress σd = 60 KN/m2  Pore water…

Q: A uniform surface load of 220 kPa is applied over the area shown below. Estimate the stress increase…

A: The uniform surface load is, To Determine:The stress increase in soil due to surface load at a depth…

Q: Consider the upward flow of water through a layer of kaolinite in a tank. The total thickness of the…

A: Note- Since we only answer up to 3 sub-parts, we’ll answer the first3. Please resubmit the question…

Q: A sample of dry sand was tested in direct shear test apparatus under a normal load of 72 kg. The…

A: Normal load = 72 kg Shear load = 36 kg

Q: In a drained triaxial compression test, a sample of sand fails at deviator stress of 150 kPa under…

A: Concept Here for drained triaxial compression test,we will use formula for calculation of angle of…

Q: An undisturbed soil sample, 100 mm in diameter and 200 mm high, was tested in a triaxial machine.…

A: NoTE-  I already answered this question but again uploading with some changes.

Q: A soil sample is consolidated in the triaxial chamber under a chamber pressure of 200 kN/m2. The…

A: diverter = deviator   Given data,  Triaxial consolidation  drain valved is closed, which means pore…

Q: Given that the effective angle of internal friction of the soil is 100, the angle between the…

A: Angle of internal friction =10o

Q: A soil sample fails at the value of stresses σ1’= 300 kPa and σ3’=100 kPa. Calculated the friction…

A: Given: σ1’ = 300 kPa σ3’ = 100 kPa   Also, assuming C = 0

Q: The results of two drained triaxial tests on a saturated clay are as follows: chamber pressure…

A:

Q: A dilatometer test (DMT) was conducted in a clay deposit. The water table was located at a depth of…

A:

Q: The following compres: specimen (G, 2.73) wh. TABLE G Time (min) Gauge (mm) Time (min) 5.00 36 Gauge…

A: Saturated clay specimen Gs=2.73 H=13.6 mm TV time factor for 90% consolidation=0.848 t90=time…

Q: In a drained triaxial compression test, a sample of sand fails at deviator stress of 150kPa under…

A:

Q: angle of 50° with the h friction of the soil.

A: We know the relation ship between Angle of Failure plane and internal friction angle:θf=45+ϕ2

Q: 5m 3m 2m N.G.L Gs=2.67, e = 0.78 Sand 3 y(sat.) = 18KN/m ³ Silty Clay 20KN Ysat. m3 Gravel

A: step 1-

Q: solve question 7 please sir

A:

Q: There is an upward flow of 0.06 ml/s through a sand sample with a coefficient of permeability 3 ×…

A:

Q: The equation of the A-line in the plasticity chart is .... A. PI 0.9(LL-8) C. PI 0.73 (LL-20) 1. B.…

A: As per guidelines we can solve first three question at a time, please upload separately,Thanks (1)To…

Q: Question A dry sand specimen is put through a triaxial test. The cell pressure is 50 kPa and the…

A: Given data : Cell pressure (σ3)=50 KPaDeviator stress (σd)=100 KPa To Determine: The angle of…

Q: 1. The equation of the A-line in the plasticity chart is .... A. PI 0.9(LL - 8) C. PI 0.73 (LL-20)…

A: The question no (10) is related to Shear Strength of Soil from Soil Mechanics. There is correct…

Q: In a drained triaxial compression test, a sample

A:

Q: Q7- For the soil profile and loading condition shown in figure. The final settlement of the clay…

A: Given data:  unit weight of sand, γt=17 kNm3, γsat=20 kNm3 Unit weight of clay, γsat=21 kNm3…