A cup contains a fluid. The cup has a surface area of 0.04m2. A small hole is made 20 mm from the free surface of the fluid which is 1/3000 of the surface area of the cup. Fluid flows out of the hole. Assume the hole is made at h=0 m Using Bernoulli's equation to determine the volume of fluid that flows out of the cup per second Q (m/s) Q=velocity x Area
Q: A child’s rubber duck has a mass of 150 g. When fully immersed in water it experiences an upward…
A: We know that buoyancy force is given as Fb= weight of liquid displaced = PwVg 25= 1000×9.8×V V=…
Q: A jet of water squirts out horizontally from a hole near the bottom of the tank shown in the figure.…
A: According to Torricelli’s theorem, Here, vx, g and h represent the speed of the water coming out…
Q: The human iliac artery has a radius of 0.35 cm. The presure gradient is 390 Pa/m Assume blood is 4…
A: Given, radius of artery, r = 0.35 cmpressure gradient, ∆PL= 390 Pamviscosity of blood, ηblood =…
Q: An experiment is done where a pressure sensor is lowered into an unknown fluid and the pressure as…
A: The pressure at depth h of a liquid is given by:- P= Po + ρgh Where; ρ= Density of the liquid. g=…
Q: A round pipe of varying diameter carries petroleum from a wellhead to a refinery. At the wellhead,…
A: Given data: Diameter at wellhead (d1) = 0.511 m Flow speed at wellhead (V1) = 11.3 m/s Flow speed at…
Q: Two identical blocks are present. Both have a mass of 8.66 kg and a volume of 5.45 L. The first is…
A: M= 8.66kg V= 5.45 L = Weight in air 84.87 N In the fluid It is 14.9N
Q: A wood block has a mass of 10.4 kg. When placed in water, 65% of the wood is underneath the surface.…
A: According to Archimedes principle Buoyant force = weight of liquid displaced
Q: 0.0335 m°, and the density of helium is 0.164 kg/m. Given that the density of air is 1.29 kg/m, what…
A: Write a given value of the question. Volume of balloon =0.0335 m3 Density of helium=0.164kg/m3…
Q: A nozzle of inner radius 1.02 mm is connected to a hose of inner radius 8.02 mm. The nozzle shoots…
A:
Q: The figure below shows a fluid inside a cubical container of side 1 m. If the pressures inside and…
A: Given, Pressure outside, Pout=1 atm Pressure inside, Pin=4 atm Length of the cube, l=1 m We know,…
Q: You press a piston of cross-sectional area a = 2.0 cm2 to exert a force on an enclosed fluid. A…
A: in this question we use pascal's principle.
Q: If the buoyant force was found to be 1.0 N on the submerged cylinder. What is the volume of the…
A:
Q: A block of wood with density of 0.421 g/cm^3 floats in some liquid of unknown density. It is found…
A: Given, Wood density, ρ=0.421g/cm3 Let the V is the volume of the immersed block,…
Q: A hydraulic system has two pistons of different diameter and uses a liquid of density p=1260 kg/m3.…
A: pressure on side of smaller piston = F1/A1 = (1.3*9.8)/π(0.01)2 = 40552.68 Pascalspressure on side…
Q: The water of a 14’ × 48’ metal frame pool can drain from the pool through an opening at the side of…
A: Part (a) Basic Details The kinetic energy of the water must be equal to the potential energy of the…
Q: Mercury is poured into a U-tube as shown in Figure a. The left arm of the tube has cross-sectional…
A:
Q: A fluid-filled chamber has a piston has with a surface a cross-sectional area of 8.00 cm2 on one…
A:
Q: Mercury is poured into a U-tube as shown in Figure a. The left arm of the tube has cross-sectional…
A: Given: Area A1=10.6 cm2 Area A2 =4.90 cm2 amount of water poured in right arm m…
Q: How do the velocity and the gauge pressure of a fluid flowing through a pipe change when it enters a…
A: initial area = A1initial velocity = v1final area = A2final velocity = v2
Q: Calculate the difference in blood pressure between the feet and top of the head for a person who is…
A:
Q: The figure below shows a fluid inside a cubical container of side 1 m. If the pressures inside and…
A:
Q: Blood is placed in a bottle 1.40 m above a 3.8-cm-long needle, of inside diameter 0.40 mm, from…
A: The pressure inside the bottle is
Q: A block of density 1230.0 kg/m3 floats in an unknown fluid with one-third of its volume below the…
A:
Q: A solid block is attached to a spring scale. The reading on the scale when the block is completely…
A: ..
Q: A jet of water squirts out horizontally from a hole near the bottom of the tank shown in the figure.…
A: Let the height of the pedestal is denoted by H ,the height of the water level inside the tank is…
Q: The water level in identical bowls, A and B, is exactly the same. A contains only water; B contains…
A:
Q: jet of water squirts out horizontally from a hole near the bottom of the tank shown in the figure.…
A: jet of water squirts out horizontally from a hole near the bottom of the tank shown in the figure.…
Q: A container has a large cylindrical lower part with a long thin cylindrical neck open at the top.…
A: Given Volume of water in lower part = 23.8 kg/m3 area of the bottom of the container = 9.50 m2 The…
Q: Water pressure acting on sunk plane at depth is 4×10⁶Pa. What is the magnitude of the force in kN…
A: Pressure, Area,
Q: A spring scale calibrated in kilograms is used to determine the density of a rock specimen. The…
A:
Q: A cylindrical container that is open at the top holds a fluid of density 900 kg/m3. At the bottom of…
A:
Q: A piece of iron of arbitrary shape is immersed in the mixture of mercury and an unknown liquid. It…
A:
Q: Pistons are fitted to two cylindrical chambers connected through a horizontal tube to form a…
A: Given, Two pistons fitted on two cylinder system. fluid is in-compressible.
Q: A round pipe of varying diameter carries petroleum from a wellhead to a refinery. At the wellhead,…
A:
Q: A hot-air balloon has a total weight (balloon, ropes, & basket) of 1.96 x104 N. The density of the…
A: Given:Total Weight, bolloon,Force,F=1.96 x104 Ndensity of the hot air ,ρhot=0.85 kg/m3density of the…
Q: Consider a helium balloon with volume 2.25 L. a) Calculate the magnitude of the buoyant force on…
A: Required magnitude of buoyant force. New force on balloon after releasing.
Q: n a given unknown fluid, the pressure measured (1 m) below the surface is (250,000 Pa). At (2…
A: Pressure is defined as the Force per unit area of a surface. A substance is said to be fluid if it…
Q: A hydraulic brake system in a car connects the brake pedal to the brakes on the wheels. When the…
A:
Q: A block of density 1110.0 kg/m3 floats in an unknown fluid with three-fourths of its volume below…
A:
Q: (a) Determine the length of the water column in the right arm of the U-tube. cm (b) Given that the…
A: Given data The cross-sectional area of the left arm is given as A1=10.9 cm2. The cross-sectional…
Q: Pistons are fitted to two cylindrical chambers connected through a horizontal tube to form a…
A:
Q: A cylindrical container with a cross-sectional area of 65.2 cm² holds a fluid of density 806 kg/m³.…
A: We know the cross sectional area of the cylindrical container is 65.2 cm2. The cylindrical…
Q: A 250 g block of unknown material has dimensions 2cm x 5 cm x 20 cm. What will happen to the block…
A: Given: Dimension of the block Mass of the block Density of water is To find: What will happen…
Q: Air flows through the tube shown at a rate of 1200 cm³/s. Assume that air is an ideal fluid…
A:
Q: The water of a 14’ × 48’ metal frame pool can drain from the pool through an opening at the side of…
A:
Q: A container has a large cylindrical lower part with a long thin cylindrical neck open at the top.…
A:
Step by step
Solved in 3 steps with 2 images