A cow is tethered by a perfectly smooth rope, a slip nose in the rope being thrown over a large square post. If the cow pulls the rope taut in the direction shown in figure, at what angle will the rope leave the post?
Q: A uniform ladder 8.30m long and weighing 235.8N rests against a smooth wall. The coefficient of…
A:
Q: Assuming the magnitude of the force vectors are proportional to their drawn length (see attached…
A: The answer to this question is explained as follows Explanation:Step 1: Step 2: Step 3: Step 4:
Q: A 5.00 m, uniform 20 kg ladder rests on a wall, making an angle of 55◦to the ground. There is no…
A:
Q: The system in the figure is in equilibrium. A concrete block of mass 174 kg hangs from the end of…
A:
Q: A 9.00-m-long uniformbeam is hinged to a vertical walland held horizontally by a 5.00-mlongcable…
A: Part (a) Given: The total length of the beam is l=9.00 m. The length of cable is d=5.00 m. The…
Q: A spade is modelled as a uniform rod, of mass 2kg and length 90cm, attached to a uniform square…
A: Gardener is holding the spade horizontally. This shows that weight of spade = force by gardner’s…
Q: Knee Extension. Consider a person wearing a cast on their foot of weight W.-1ON with their knee in…
A: Center of mass of the cast is at =C2=8×0.22=0.8 m=4A That center of mass of cast and leg are at same…
Q: The sian Shown in Fia 7.48 is 4.00m long weighs 155ON, and is made of uniform materiale A weight of…
A:
Q: O A Elniform horizontal bean 3.om long and oeighing 3.0x. 1ON is attached to auoall by Pin…
A: Given data: Weight of beam, WB=3×102 N Weight of the person, Wp=6×102 N The distance of the person…
Q: A bolt has required of being tightened to 38 Nm. You pull on the end of a 25cm wrench at an angle if…
A: Given : Torque τ=38 Nm r=25 cm=25×10-2 m Angle θ=120°
Q: A 187.8N tightrope walker stands at the center of the rope such that each half of the rope makes an…
A:
Q: A person exerts a horizontal force of 46N on the end of a door 97cm wide. What is the magnitude of…
A:
Q: A stationary 3.0-m board of mass 7.0 kg is hinged at one end. A force F is applied vertically at the…
A: First we draw the Freebody diagram, From the diagram it is clear that torque is zero, so,
Q: A 560 N uniform rectangular sign 4.00 m wide and 3.00 m high is suspended from a horizontal,…
A: Apply the condition of equilibrium. The summation of moments about the hinge.ΣM = 0560(4) + 80(3) -…
Q: 1
A:
Q: A 14.0 uniform ladder Leghins 510N rests against a frictionless wall. The ladder makes 55.0 angle…
A:
Q: Draw shear force and bending moment diagram of the beam shown in figure 1 for the gives loadino.…
A: The objective of the question is to draw the shear force and bending moment diagram for the given…
Q: Problem 5: Suppose a 875-kg car is on the bridge in the figure with its center of mass haltway…
A: Concept: In order to determine the tension and the magnitude of the Force, we will use the free body…
Q: A painter whose mass is 60.0 kg stands on a 20.0 kg uniform horizontal beam that is held in…
A:
Q: A mass m is attached at one end of a masslesss rigid rod of length 'l'. The rod is suspended at…
A: Given: As shown below Mass m is attached at one end of a massless rigid rod rigid rod of length 'l'…
Q: Assuming the magnitude of the force vectors are proportional to their drawn length (see attached…
A: The objective of the question is to determine which force vector would result in the largest plantar…
Q: If the required clamping force at the board A is to be 2.50 kN, determine the torque M that must be…
A:
Q: B C D. 40 etermine the tension in the cable at B, ven that the uniform cylinder weighs 350 . Neglect…
A: We have to find the tension in the cable at B
Q: ladder 4m long is leaning against a frictionless wall with its lower end 1.6m away from the wall. If…
A:
Q: A 15,000 N crane pivotsaround a friction-free axle atits base and is supported by acable making a…
A: Ans.(a) Find the moments around the axle. Take clockwise as positive. For the system to be in…
Q: A uniform ladder 8m long and weighing 350N restsagainst a smooth vertical wallat an angle of 30 ̊ to…
A: Let us consider the ladder is kept fixed about its top A reaction force on the ladder due to the…
Q: uniform 200. N beam (light grey) is 5.00 m long and makes an angle of 30° with the horizontal. It is…
A:
Q: 45 300mm 60mm Notch 60 Uniform pole of mass 400g and 350mm length being hoisted into position by…
A:
Q: Two individual apply force to opposite sides of a frictionless swinging door. If A applies a 30 N…
A:
Q: 10kg rigid beam that is 3mlong is supported at each end. An8kg block is placed 2m fromsupport 1. How…
A: The objective of the question is to find the upward force exerted by each support to ensure zero…
Q: A 1260 N uniform beam is attached to a vertical wall at one end and supported by a cable on th other…
A: Given Weight of the beam is Wb =1260N Weight of the crate is Wc=1960N Given diagram:
Q: A 1220N uniform boom is supported by a cable perpendicular to the boom, as seen in the figure below.…
A:
Q: The fishing pole in the figure makes an angle of 20.0o with the horizontal. What is the torque…
A:
Q: A horizontal wire holds a sólid um ona tilted ramp that rises 35.0° above the horizontal. the…
A:
Q: Jack and Rose are carrying a uniform rod that is 3.00m long and weighs 160.N. If Rose lifts at one…
A: Given:- The jack and rose are carrying a uniform rod of length L = 3 m The weight of the rod is…
Q: Arigid body sa uniform square and nas ts center of gravity at the center. If the length and width of…
A: A rigid body is a uniform square and its center of gravity at the center. If the length and width of…
Q: 10kg rigid beam that is 3mlong is supported at each end. An8kg block is placed 2m fromsupport 1. How…
A: The objective of the question is to find the upward force exerted by each support on the beam to…
Q: A UNIFORM ROD OF LENGTH 3M AND WEIGHT 100N WITH ENDS A AND B RESTING ON TWO BRACKETS, BEARS 50N…
A: The diagram is drawn below.
Q: A bolt has a requirement of being tightened to 38Nm. You pull on the end of a 25cm wrench at an…
A: Torque is the amount of force required to turn from the distance of radius. It is a vector quantity.…
Q: A uniform drawbridge must be held at a 37° angle abovethe horizontal to allow ships to pass…
A: Under equilibrium condition,∑Fy=0⇒-W7mCos37°+TSin 37°3.5m=0
Q: A uniform ladder of mass (m = 13.5 kg) and length (L) leans against a frictionless wall. If the…
A:
Q: A uniform ladder 15 ft long is leaning. against a frictionless wall at an angle of 53 \deg above the…
A: The question can be illustrated as follows:The free body diagram of the ladder is: Since the system…
A cow is tethered by a perfectly smooth rope, a slip nose
in the rope being thrown over a large square post. If the
cow pulls the rope taut in the direction shown in figure, at
what angle will the rope leave the post?
Step by step
Solved in 3 steps with 3 images