A control system is to provide a regulation of flow in range of 20gal/min to 100gal/min. A linear flow sensor has a sensitivity of 0.1??/(gal/min) with 4mA   at 20gal/min. The sensor has an uncertainty of ±6%. a) What is the sensor current at 40gal/min? b) What is the range of the output current at 40gal/min? c) A current-voltage signal conditioning circuit with sensitivity of 0.4V/mA ± 5%; what is the output voltage range at 40gal/min?

Q: How would the hysterisis of an instrument affect its uncertainty? Suggest how to reduce the effect…

A: Hysteresis in an instrument is when it doesn't give you the same measurement when you're going up…

Q: A full-wave bridge rectifier produces an output voltage with a ripple factor of 5%. The circuit is…

A: Given data Load power; PL=0.75 W Load current; IL=15 mA Ripple factor; RF=5% To Find out (a) Load…

Q: 0 A single phase half wave controlled rectifier is operated from a 145 V, 50 Hz supply and the load…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Design rectifier circuits to provide an output of 100 VDC using a.) HWR b.) Center-tapped FWR and…

A: Note: As you have mentioned for part b, I am solving part b only.The output voltage of the rectifier…

Q: 6.q4

A: The resolution of an ADC is the smallest change in voltage that will cause a change in the digital…

Q: 2. A full-wave bridge rectifier is operated from a 50 Hz, 220 V rms line. It has a 100 uF filter…

A:

Q: A 4:1 transformer is connected to a bridge rectifier circuit with a lkn load. What is the peak…

A:

Q: (i) (ii) (e) Consider the output of the full bridge rectifier from part (d) (i) If a smoothing…

A: We need to solve the above question related to full bridge rectifier and half wave rectifier and…

Q: Average de voltage, VacVm(1+cosa) (volts) Rms output voltage,Vms-Vm ((n-a)+sin2 a/2)2 (volts) Where,…

A:

Q: (a) The bridge full-wave rectifier with R-L load is designed using such parameters: input voltage =…

A: dear student as per our guidelines we are supposed to solve only one question in which it should…

Q: Using “ends points method” calculate the sensivity and the error of zero (so-called “offset”) of…

A: According to the question,Using “ends points method” calculate the sensivity and the error of zero…

Q: A centre-tap full-wave rectifier (CT-FWR) is operated from a (60 Hz), (110 V,ms) line voltage…

A: Thank you for the question. Your question consist of multiple sub-parts, as per company policy I…

Q: OA single phase half wave controlled rectifier is operated from a 145 V, 50 Hz supply and the load…

A: According to Bartleby guidelines I am supposed to do only first three questions. Kindly post next…

Q: 2. A full-wave bridge rectifier is operated from a 50 Hz, 220 V rms line. It has a 100 uF filter 1…

A: Given Vrms=220VR=2kΩC=100μFf=50HzIdc=V/R=0.11 Form factor-IrmsIavg=Imax/22Imaxπ=1.11Ripple…

Q: A device that reduces input power. a.Inverter b.Attenuator c.Amplifier d.Rectifier

A: Inverter is use to convert DC into AC. As we know DC can be stored. There are different types of…

Q: 4. Add a 100uF filter capacitor. Analyze the filtered rectifier circuit. Find the indicated values.…

A:

Q: a) Explain how an AC Voltage controller can be design using one SCR and diodes. b) Draw and explain…

A:

Q: linear graph is obtained in which temperature sensor.....

A: The thermocouple type characterizes the metals used to make the thermocouple; thusly, it likewise…

Q: Q1: For a single-phase full bridge-controlled rectifier. The input supply voltage 220 V, 50 Hz, the…

A:

Q: What are the values of the dc output voltage and dc output current for a halfwave rectifier that is…

A: Concept: A device that converts an oscillating two-dimensional current into single direction direct…

Q: 1. Design a rectifier as shown below to provide a dc output voltage of 12 V with no more than 0.7…

A: The terminal characteristics of the ideal diode can be interpreted as follows If we apply a…

Q: 6.q4

A: Detailed explanation:(a)Resolution of an ADC is the smallest change in voltage that can be detected;…

Q: 3) Solve the following for a single phase half wave controlled rectifier supplied from a source of…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: The RTD sensor were used to measure the temperature, from zero to 100°C. It connected to the circuit…

A: In the above figure, the instrumentation amplifier should have the difference amplifier(output side)…

Q: a) For a half controlled rectifier with R-load (i) Draw the simple circuit diagram. (ii) Draw the…

A:

Q: The peak inverse voltage or PIV for the bridge rectifier is lower when compared to an identical…

A: The peak inverse voltage or PIV for the bridge rectifier is Vm and peak inverse voltage or PIV for…

Q: Propose a design for a humidity sensor using the principle of capacitance. Will this device be…

A: To design a humidity sensor

Q: A three-phase controlled rectifier is supplied from a 400V, 50HZ line and supplying an RLE load with…

A:

Q: Describe the difference of LCD and OLED displays with their working mechanisms and…

A: In the following section, the difference between LCD and OLED display has been given.

Q: 1. What is Diode?

A: NOTE: “Since you have asked multiple question, we will solve the first question for you. If you want…

Q: In temperature sensing, RTD stands for... a. reverse temperature detectors b. resistance…

A: In temperature sensing system we use RTD to detect the temperature of the system under observation.

Q: Match the diode application to the type of diode Oscillator circuits Choose... Modulating device…

A:

Q: Q) In measurement system, which of the following static characteristics are 7desirable Resolution. O…

A: This is a basic question based on measurement and instunentation subject. In this the basic multiple…

Q: In the voltage limiting devices, for or 12 breakdown voltage we use Oa. Gas-discharge tube O b.…

A: For low breakdown voltage: Parallel silicon diode is used. For moderate breakdown voltage: Back to…

Q: Ql: For a single-phase full bridge-controlled rectifier. The input supply voltage 220 V, 50 Hz, the…

A:

Q: If the peak voltage Vp coming out of a full wave rectifier circuit is 24 volts, and passes through -…

A:

Flow Detection Sensor

A flow detection sensor which is also called a flow meter is an electronic device that measures the flow rate of liquids and gasses. Flow detection sensors can detect leaks, blockage, pipe bursts, and changes in liquid concentration which is occurred due to pollution.