A contractor needs to make a rectangular drain consisting of three sides from a pice of aluminum that is 24 inches wide. Find the length of each side if it needs to carry the maximum capacity of water.

Q: 3. A river intake structure has two sets of intake ports with each port having a width that is 3x…

A:

Q: just simple answer thanks.

A: Step 1: Step 2: Step 3: Step 4:

Q: Describe about the Check-valve bailers.

A: Bailers are used for collecting ground water samples under the water table level.

Q: Q1) Water flows through the sudden pipe expansion shown below at a flow rate of 3 m3/s. the small…

A: There will be minor energy losses in the pipe flow system due to the sudden expansion of the pipe.…

Q: 3. Calculate the depth in a most economical circular section in case of maximum discharge. a) 0.65D…

A:

Q: A pipe has an outside diameter of 3 5/16 inches. The thickness of the wall is 19/64 inches. Find the…

A: Outside diameter = DO = 3516 inches   Thickness of the wall =  DI = 1964 inches

Q: A 10-meter long curved gate has a radius of 6 meters. If theta = 60 degrees, determine the…

A: Hi! Thank you for the question, As per the honor code, we are allowed to answer three sub-parts at a…

Q: Determine the equivalent length pipe with a diameter of 300mm and a C value of 120 that will replace…

A: Required Answer is 2000m(approximately)Explanation:Step 1:The definition of the Equivalent Length of…

Q: A conical water tank has its top at ground level (consider this to be the x-axis) and its base 12 ft…

A: Given:- radius of cone R = 4ft Height of cone H= 12 ft Weight of water γw = 62.4 lb/cu.ft To find:-…

Q: Please give me right answer  Draw a flowchart on how to analyze a tension member, it's gusset…

A: The structural elements that are subjected to direct axial tensile loads and tends to elongate the…

Q: Given all information above Find the flow rate

A: Answer We are given  upstream depth of water y1 = 7 ft downstream depth of water y2 = 0.8 ft width…

Q: A quarter circular gate (BC) is hinged at the point C under water as shown in the sketch below.…

A: Given data  Width of gate (B) = 4m  Radius of gate (R) = 2m  Find force F.

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.