A conducting copper bar is traveling at a constant speed of 1 m/s on conducting rails in uniform magnetic field of 2.5 T, as shown in the figure. A current of 1 A is induced in the loop. (1) Indicate the direction of the current through resistor R on the figure. (2) How much power is dissipated in the resistor R? Assume that the resistance of the moving bar and the rails is negligible compared to R. メ R X X X X メメ

A conducting copper bar is traveling at a constant speed of 1 m/s on conducting rails in uniform magnetic field of 2.5 T, as shown in the figure. A current of 1 A is induced in the loop. (1) Indicate the direction of the current through resistor R on the figure. (2) How much power is dissipated in the resistor R? Assume that the resistance of the moving bar and the rails is negligible compared to R. メ R X X X X メメ

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A thin 50 cm (0.5 m) long metal bar with mass 0.75 kg rests on (but is not attached to) two metallic supports in a uniform 0.45 T magnetic field as shown in the figure. A battery and a 25 Ω resistor in series are connected to the supports.Find the highest voltage the battery can have wihtout breaking the circuit and the initial acceleration of the bar if the resistor decreased resistance to 2 ohms.
A 0.230 m radius, 480 turn coil is rotated one-fourth of a revolution in 4.17 ms, originally having its plane perpendicular to a uniform magnetic field. (This is 60 rev/s.) Find the magnetic field strength needed to induce an average emf of 10,000 V. X T
A circular coil with radius 0.564 m has 50 turns of wire in it. The total resistance of the coil is R and it is sitting in a perpendicular magnetic field of 10 T. As the magnetic field is ramped to zero over a period of 2 s, a 5.0 A current is induced in the coil. What is R? Hig Ο 10 Ω 15 Ω 30 Ω
Sign in to O X Interval Spo X O Apr. 9: Fara X O Faraday.pdf x Faraday.pdf x HW 19 in mechanical X M (no subject) x PDF File | C:/Users/Colin/Downloads/Faraday.pdf 2) A rectangular coil with resistance R has N turns (loops), each of length e and width w as shown in the figure. The coil moves into a uniform magnetic field B with constant velocity v. Find the magnitude and direction of the total magnetic force on the coil (a) as it enters the magnetic field (i.e. partially immersed), and (b) as it moves (totally immersed) within the magnetic field. B. Pexternal 8:08 AM O Type here to search 62% hulu 4/9/2021 7.
The current in a long solenoid of radius 6 cm and 22 turns/cm is varied with time at a rate of 3 A/s. A circular loop of wire of radius 8 cm and resistance 7 0 surrounds the solenoid. Find the electrical current induced in the loop (in HA). HA
The figure shows a uniform magnetic field that is normal to the plane of the conducting loop of resistance R. Note: the area of the non- circular portion of the circuit is negligible compared to that of the loop. B 04 Which entry in the table below correctly pairs the change in the system with the direction of the induced current through R? change in the system direction of current through R decrease the area of the loop rotate loop into the paper decrease the magnitude of B increase the area of the loop pull loop to the right from top toward bottom no induced current from bottom toward top from bottom toward top from top toward bottom
A coil of ten turns of area 0.01 m2 and resistance 5 Q is placed perpendicularly inside a magnetic field whose intensity and direction changes as given in the figure. B(T) 2 0.1 0.3 0.5 0.8 0.9 t(s) -2 QUESTION 5 How much power is dissipated by the coil at time = 0.6 seconds? O 0.2 W O 0.4 W O 0,5 W O None of these
Problem 2. An a by b loop is pulled in the x- direction with the velocity v relative to a straight wire with a constant current I, see figure. Find the force that the wire produces on the loop. I b R пи ν 0 I ४ a x + a
A loop of highly conducting wire is placed in a magnetic field that is increasing out of the page (through the loop) at a rate of 1.80 T/s. If the loop has an area of 0.400m^2, calculate the current flowing in Amps through the 5.00 ohm resistor.
Motional EMF Below is a rectangle that is being pulled into a magnetic field as shown. The rectangle has a height of h = 0.400 m and is being pulled to the right with a velocity of v = 188.0 m/s. This magnetic field starts where shown, so the left most side of the rectangle has no magnetic field. There is 1 loop with a total resistance of R = 15.40 Ohms. The magnetic field has a magnitude of B = 34.0 mT. That means as the loop moves to the right, the magnetic flux inside the loop is increasing. Magnetic Field (out of the page) Direction of velocity What is the induced current within the wire in this system? (Use a negative sign for clockwise current) Make sure to give your answer with appropriate significant figures and remember that you are looking for a magnitude. Your Answer: Answer units Height
Three conductive loops A, B, and C are shown in the figure below. Each loop has a resistance R and moves at a constant velocity v. As the loops enter a static and uniform magnetic field, a current may be induced in them. In which loop(s) will the current have the largest magnitude? A C O A O B O C O The current is the same in each of them. O No current is induced in any of the coils.
A stationary square coil of area 0.1 m2 is brought over time of 2 s into the magnetic field 8.5 T with its plane perpendicular to the magnetic field. The coil has 1523 turns. Calculate the magnetic flux linkage through the coil. Give your answer in SI units.