A compression load of P = 45 kips is applied to a 2 in. by 2 in. square post, as shown. Determine the normal stress o, perpendicular to plane AB and the shear stress Tnt parallel to plane AB. Assume a = 20⁰. a B Calculate the normal force N perpendicular to the plane AB and the shear force V parallel to plane AB. Report both answers as positive numbers.

Q: An axial load P is applied to the rectangular bar shown. The cross-sectional area of the bar is 398…

A: Given   Area, A = 398 mm2    Angle = 90 - 61               = 29o  Load, P = 88 kN Find   Normal…

Q: A rod composed of an aluminum section rigidly attached between steel and bronze section. Axial loads…

A: Given data as per the question  P=3000 lb  Area of rod =0.5 in2

Q: Problem 3: 4.2 m 5.0 m 200 KN 175 KN A (1) B (2) с 200 KN 175 KN A structural steel (E-220 GPa) has…

A:

Q: If a pipe with an inner diameter of 36 mm is subjected to an axial load of 5.20 x 105 N and the…

A: To read quetsion carefully

Q: 4) The bar shown has a cross-sectional are of A and a modulus of elasticity of E. If the axial force…

A:

Q: Determine the maximum stress in the frame of the 100kN punch press as shown in the figure. 15cm 36cm…

A: Maximum stress will be at the centre of the section X-X shown below. We convert all dimensions into…

Q: Problem: Figure shows a frame subjected to a load of 3.4 kN, find the resultant stress at A and B.

A:

Q: circular tube AB is fixed at one end and free at the other end. The tube is subjected to axial force…

A:

Q: 10 kN В B y 6 m

A:

Q: Determine the normal stress perpendicular to plane AB and the shear stress parallel to plane AB

A: Determine the normal stress perpendicular to plane AB and the shear stress parallel to plane AB.

Q: a) The normal stress in bar BD is most nearly b) The shear stress in the pin at D is most nearly…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.