A compound shaft consists of segment (1), which has a diameter of 1.5 in., and segment (2), which has a diameter of 1.9 in.  The shaft is subjected to a tensile axial load of P = 5 kips and torques TA = 12 kip·in. and TB = 34 kip·in., which act in the directions shown.  Determine the

Q: The couple M = 23 kN-m is applied to a beam of the cross sec angle with the vertical. Determine the…

A: Given : M = 23 KNm  and  β =150                           Find :  stress at A, B ,D = ?    Let the…

Q: 75 mm o T=3 kN.m 50 mm T=3 kN.m B Steel Bronze G-35 GN/m2 G=83 GN/m21

A:

Q: Two solid cylindrical rods AB and BC are welded together at B and loaded as shown. Take di = 30 mm,…

A: Determine the average normal stress at the midsection of rod BC.

Q: A solid 1.500-in.-diameter steel shaft is subjected to torques TB = 255 lb-ft and TD= 95 lb-ft,…

A:

Q: The bell crank is in equilibrium for the forces acting in rods (1) and (2). The bell crank is…

A:

Q: Question 2) In the system given in the figure, a distributed load of w=85 kN/m acts on the rod AB of…

A:

Q: The rectangular bar carries a load of P = 127 kN and is connected to the support bracket with a…

A: As said, the pin experiences double shear, Shear stress is given by ;Since, double shear so,…

Q: A compound shaft consists of brass segment (1) and aluminum segment (2). Segment (1) is a solid…

A:

Q: The two bars are used to support load P. When unloaded, joint B has coordinates (0,0). After load P…

A:

Q: A solid 1.500-in.-diameter steel shaft is subjected to torques TB = 205 lb-ft and TD= 135 lb-ft,…

A:

Q: A solid 2.40 in. diameter shaft is subjected to a torque of T = 330 lb-ft and an axial load of P =…

A:

Q: The solid 1.25-in.-diameter rod is subjected to a uniform axial distributed loading along its length…

A:

Q: A compound shaft consists of brass segment (1) and aluminum segment (2). Segment (1) is a solid…

A:

Q: The compound shaft is attached to a rigid wall at each end. For the bronze segment AB, the diameter…

A:

Q: A compound shaft consists of brass segment (1) and aluminum segment (2). Segment (1) is a solid…

A: Following are the given information. Segment 1 =Brass Segment 2 =Aluminum Allowable shear stress of…

Q: The bell crank is in equilibrium for the forces acting in rods (1) and (2). The bell crank is…

A:

Q: For the beam shown: 1. Draw the free-body diagram (FBD) and determine the reactions at the supports.…

A:

Q: Determine the size of square bearing plates A and B' required to support the loading P = 15 kN.…

A: Bearing Stress = 3Mpa

Bars

In civil engineering, bars refer to steel reinforcement bars or rebars. These are structural members primarily used for reinforcement purposes in masonry works. A bar is characterized by its cross-sectional area, which is negligible compared to its length. Bars are usually manufactured by steel which is uniform throughout the length, or by meshing multiple steel wires. Other materials of the bar include carbon steel, glass fiber, carbon fiber, and basalt fiber. The reinforcing bars are coated with epoxy resins and other materials to enhance some of their properties including corrosion resistance.