A coal-fired power plant with effective stack height of 100 m emits 1.2 g/s of SO2 per megawatt of power delivered. If winds are assumed to be 4 m/s at that height, how big could the plant be (MW) without having the ground level SO2 exceeds 365 μg/m3 at 2 km downwind?

A coal-fired power plant with effective stack height of 100 m emits 1.2 g/s of SO2 per megawatt of power delivered. If winds are assumed to be 4 m/s at that height, how big could the plant be (MW) without having the ground level SO2 exceeds 365 μg/m3 at 2 km downwind?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: The watershed at a particular site on a river has 77000 ha. The mean annual precipitation is 950 mm.…

A: Given:- Area of watershed=77000 haAnnual precipitation=950 mm25% precipitation reaches basin…

Q: 3. Estimating CHB wall materials considers the following except; A. Thickness of CHB D. Spacing of…

Q: A rectangular channel 2.0 m wide and 1.0 m deep carries a discharge of 4.0 m3/s. A horizontal datum…

A: Rectangular channel (B) = 2m Depth (y) = 1m Discharge (Q) = 4 m3/sec Datam height below channel bed…

Q: 5.112 What is the maximum possible power output of the hydroelectric turbine in MW (megawatt)? Is…

Q: Can I get a step by step on how to answer? Given the conditions below of a power plant, determine…

A: Plume centerline, y = 0.3 km base height = 388 m SO2 emission = 1,645 g/s wind speed = 3.5 m/s Stack…

Q: Problem 5 An adiabatic gas turbine expands air at 1350 kPa and 525°C to 125 kPa and 130°C. Air…

Q: Estimate the rate of emission of SO2 in g/s that results in a centerline (y=0) concentration at…

A: The concentration of the ground level at one kilometer from the stack = 1.412x10-3g/m3Clear summer…

Q: An oil refinery emits 20 g/s of SO2 at effective stack height of 100 m where the wind speed equals 6…

A: Given:- H=100m u=6m/sQ=20g/sσy=30mσz=20my=0z=0 To find:- SO2 Concentration at center line of…

Q: A standpipe 4 m in diameter and 8 m high is filled with water. Find the potential energy (kPa) of…

Q: A water main is an 18-in-diameter concrete pressure pipe. Calculate the energy loss over a 1-mile…

A: When energy got transferred from one place to another or from one system to another, then there is…

Q: An electrostatic precipitator with 3,500 m2 of collector plate area is 94% efficient in treating 300…

Q: On an afternoon with moderate incoming solar radiation and an average wind speed of 2.5 m/s at a…

A: Afternoon At a height of 10 m above the ground average wind speed = 2.5 m/s Rate of emission of…

Q: 6.24. In Problem 6.6, what is the maximum downwind distance at which the ground level con-…

A: Wind speed (V)= 3 m/s Stability class CEmisson rate (Q) = 1000 g/s Ground level concentration (C)=…

Q: A Mindanao province where a hydroelectric power station is to be constructed has an average annual…

A: Formula used Discharge = volume/ time Average power generated = Density of water * acceleration due…

Q: Define about Time Rate of Consolidation ?

A: The process by releasing water from soil spaces, consolidation is the compression of soil. It…

Q: Calculate the specific energy (m) for a rectangular channel 3 m wide with a depth of flow of 0.8 m…

A: Given data : Flow through rectangular channel (Q)=16.5 m3/sWidth (B)=3 mDepth of flow (Y)=0.8 mTo…

Q: A kalpan turbine develops 2250 kW under a net head of 5.5 m and with overall efficiency 87 percent.…

Q: Please explain all questions

A: Question 1: The goal is to estimate the concentration of NO at various locations relative to the…

Q: Which of the following power plant is an example of Tidal energy

A: A power plant is an industrial plant that produces primary energy electricity. Most plants use one…

Q: Explain different components of small hydroelectric power system

A: Small hydroelectric power system It is a type of development of a hydroelectric power on a scale It…

Q: A jet of water issues from a 5-cm diameter nozzle, held vertically upwards, at a velocity of 20…

Q: In an economical rectangular channel having 5 m width, the water flows at a depth of 2.5 m and…

Q: Q.17 The following is a well known formula for estimating the plume rise: 4h=V₁d₁ Vd u 1.5 +0.0096…

A: Given data- Diameter d=1 m, Heat rise Qh=2000 kJ/s, Wind speed u=4 m/s, Stack gas speed Vs=8 m/s, To…

Q: A ground level contamination source emits 0.45 g/s of a toxic gas into a 2.5 m/s wind. Assuming no…

Q: The air shed over a city can be considered by a completely stirred tank reactor (CSTR) model with…

A: Solution Given Data CSTR model of Side= 2*105m in length Mixing Depth= 500 m Horizontal Wind blows=…

Q: A stack 75 m tall ( as shown) emits a plume at 20 oC. The surrounding air is at 20 oC. Is the…

A: Plume is the path which is taken by the discharge of smoke or gases emitted from a stack. Local air…

Q: An 80 m stack is emitting a plume with a rise of 15 m at an emission rate of 300 mg/s in an…

A: Large chimneys called stacks are used to release and distribute hot air, particulate matter, and…

Question

A coal-fired power plant with effective stack height of 100 m emits 1.2 g/s of SO2 per
megawatt of power delivered. If winds are assumed to be 4 m/s at that height, how big could
the plant be (MW) without having the ground level SO2 exceeds 365 μg/m3 at 2 km downwind?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A piping system supplies 6000 Ipm of water at 25°C through a DN200 Schedule 40 steel pipe. A butterfly valve is placed on this pipeline to regulate the flow. The expected energy loss through this valve is most likely: 0.31 m 0.49 m 0.38 m O O 0.41 m 0.11 m 0.15 m 0.12 m 22 m 0.09 m
Complete answer
A new municipal waste combustor burns 300 tons/day of waste and produces 100 dscf of emissions per lb of waste burned. The plant just meets the NSPS emission standards and has an effective stack height of 100 m and is located in a rural area. Under C stability and a windspeed of 4 m/s measured at 10 m, determine Cmax and xmax for (a) PM, (b) Pb in micrograms per cubic meter, and m, respectively
Four standard concrete cylinders of 6-inchdiameter cross section were tested underuniformly increasing axial compressive loads 28days after casting concrete. The maximummeasured loads were 121,000 lbs, 116,700 lbs,128,800 lbs, and 119,100 lbs. What is the averagecompressive strength of this concrete in ksi?
An industrial plant emits lead at 300 g/s from a 50 m high stack at 300°C with a stack velocity of 12 m/s. The stack diameter is 2 m. The wind speed is 5.0 m/s, the air temperature is 10°C, the atmospheric stability class is C, and the atmospheric pressure of 102 kPa. What is the effective stack height?
A 35 percent-efficient coal-fired power plant with effective height of 100 m emits SO2 at a rate of 0.6 lb/10^6 Btu into the plant. If winds are assumed to be 4 m/s at the stack height and just over 3 m/s at 10 m, how large could the plant be (MW) without having the ground level SO2 exceed 365 micrograms/m^3?
i) The watershed at a particular site on a river has 77000 ha area. The mean annual precipitation is 950 mm. About 25% of precipitation reaches the basin outlet as stream flow. Estimate the mean flow rate Q at this site in m³ s-¹? (ii) If the head available at the site is 150 m and assuming the transmission loss of 10%, what would be the power that can be generated in MW?
Question What is the maximum power available at the downstream end of a pipeline 3 km long, 20 cm in diameter, if water enters at the upstream end at a pressure of 720 m of water, with the taking pipe friction coefficient as 0.03 and gas 10m/s²?
A rough pipe of diameter 600 mm is carrying a flow of 600 litres/second. Determine the power lost per km length of the pipe if roughness of wall is 3 mm.
A 15 m wide rectangular channel carries a discharge of 30 m³/sec under critical conditions. If the width of the channel is increased to 20 m, then the ratio of specific energy at critical depth for 15 m width to 20 m width will be m. (up to two decimal places)
Provide complete answer