A closed traverse has the following data: Course Bearing Distance 1-2 N9.27deg.E 58.7m. 2-3 S 88.43 deg E 27.30m. 3-4 N 88.78deg.E 35.2m. 4-5. S. 5.3deg. E 35.0m. What is the bearing of the line 5-1? Select the correct response: N. 72deg. 07 W O S.72deg. 07 W N. 72 deg. 07' E

A closed traverse has the following data: Course Bearing Distance 1-2 N9.27deg.E 58.7m. 2-3 S 88.43 deg E 27.30m. 3-4 N 88.78deg.E 35.2m. 4-5. S. 5.3deg. E 35.0m. What is the bearing of the line 5-1? Select the correct response: N. 72deg. 07 W O S.72deg. 07 W N. 72 deg. 07' E

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Backward bearing 322030'00" 44°15' Forward bearing 142030'00" 223°15'00" 287°00’00" 12045'00"…

A: Given values- Five lines are given AB, BC, CD, DE & EA with Forward Bearing and Backward…

Q: Moment CD choices: -9.17kN-m -13.39kN-m -15.56kN-m -18.01kN-m Moment at A choices -49.51kN-m…

A: Using slope deflection method In above given structure, there are three unkown ( θB , θc and ∆ )

Q: Direct and reverse directions observed with a total station instrument from A to points B, C, D and…

Q: Problem #4 Compute for the resultant of the given Parallel system and its relative position from…

A: Determine the resultant of the load and it's relative position from point A.

Q: The pin-jointed space truss shown in Fig. P.15.14 is pinned to supports 0, 4, 5 and 9 and is loaded…

A: Considering joint 27 as shown below: Where, u2, v2 = Horizontal and Vertical displacement of point…

Q: A line of levels 15 km is run on a soft ground to check the elevation of BM-2 which has been found…

Q: X8-6. The following deflection angles were measured in a traverse that originates at station A with…

A: Given: Station From To Measured Deflection Angle A R B 86o16' R B A C 26o20' R C B D 46o40'…

Q: Station B.S. 71cm H.I. F.S. Elevation 100 BM1 Remarks TP1 TP2 66cm-72cm 32cm-37cm 185-189.5 291-294…

Q: TRIAL 2: COUNTERCLOCKWISE DIRECTION: No. of Full Partial Tape Length of Line Perimeter Line Length…

A: In surveying, traverse measurement is one of the works that is always done by the chain measurement…

Q: Find Find 300 EN 30 F1= 205KN

Q: Compute the DPD of each lines (AB, BC, CD, DE, EF, FA)

Q: Station BM1 TP1 B.S. H.I. F.S. Elevation Remarks 71cm 66cm-72cm 32cm-37cm 100 185-189.5 ТP2 TP3…

A: HI = ELEVATION +BS ELEVATION = HI - FS

Q: COURSE DISTANCE (m) BEARING AB 105.67 N 30.15° E BC 126.15 N 74.18° E CD S 40.31° E --- DE 127.77 S…

A: A closed traverse ABCDEFA is given in which length of CD and bearing of FA is missing and it has…

Q: Q3) In closed traverse ABCD show below:- 1-Correct the External angles if the instrument accuracy…

A: Given data The bearing of Line AB θAB=120° The external angle at A, θAE=272°47'15" The external…

Q: Station B.S. 71cm Н. F.S. Elevation Remarks BM1 100 TP1 TP2 ТРЗ 66cm-72cm 32cm-37cm 34cm-36cm…

A: We will use Height of instrument method HI = RL of that station +BS of that station RL = HI of…

Q: 4. Convert 150 o to radians 5. Convert 5. 64 rad to degrees G. Convert 2 2. 6 78 ° TO degrees,…

Q: Check all calculations.

A: Calculations are given below

Q: 5. ANGLE то THE RIGHT TRAVERSE. A five- sided closed tra- angle to follows: and E=260° 25'. proceeds…

A: Calculating the sum of angles: Sum of angles=270°45'+268°43'+203°22'+256°20'+260°25'…

Q: Course Adj. Lat. Adj. Dep. AB 490.71 m. 47.27 BC 587.12 608.89 CD -327.41 786.78 DE -1002.76 218.32…

A: Course Adj lat Adj Dep DMD 2A AB 490.71 47.27 47.27 23195.86 BC 587.12 608.89 703.43…

Q: Solve for the bearing of course FA. (answer format: in two decimal places and indicate direction,…

A: Calculation of Bearing of FA###

Q: 13. Standard accuracy for conventional surveying instruments. In triangulation for tertiary control,…

A: 13. maximum triangle closure error in triangulation for tertiary control is 10" . hence (b) is…

Q: STATION DIRECT DOUBLE MEAN REMARKS DEFL. DEFL. DEFL. Azimuth 111 - 112 = 121° 21' 111 147° 01' 293°…

A: Station Direct Double Mean Remark 111 147°1' 293°59' 147° (147°1'+293°59')/3 112 116°11' 232°22'…

Q: Forward Backward Line Bearing Bearing S 37deg. N 37deg. 1-2 30min. 30min. W E 43deg. N 44deg. 2-3…

Q: 1-1f the maghetic quakter dirction (M..Br) For the lines. ABBcocDoDE andEF are N55° 2ó E, S 78° 0ó…

A: As per company's guidelines we can only answer first question. Kindly post other questions as…

Q: Leveling Rod Leveling Rod BS L₂ BS TP BM, Elev. of TP, Difference in Elev. between and BM₂ BM Elev…

Q: STA BS HI FS IFS ELEV BMa 0.95 125.50m 0+ 00 3.0 + 10 2.3 TP1 3.13 0.64 0 + 22 + 30.5 + 34. 2 + 39.3…

Q: Gven: PROBUEM 2. ド: 500 6: 36ON Find: mc MA MB. MF mo ME F 2m

Q: Corners Adj. Lat Adj. Dep АВ 80.20 -40.10 ВС -40.13 -36.82 CD 70.18 50.40 DE -30.14 30.36 EF 60.16…

Q: The top of the tower signal at B 2000 m away from A was sighted through a transit with a recorded…

Q: 7777711

Q: %Y. 36 ull 0 1,0K/s Asiacell 3 Reciprocal ranging is employed when

A: Reciprocal ranging is employed when the ranging rod from one station is not visible from other…

Q: Station B.S. H.I. F.S. Elevation Remarks BM1 71cm 66cm-72cm 32cm-37cm 34cm-36cm 66.5cm-62.4cm 100…

A: Note:- As the values of B.S. and F.S. are given in intervals so, take the values of the B.S. and the…

Q: Use E... b Draw the longitudinal section ( profile) of the leveling process if vou know that the…

A: Longitudinal profile is constructed to understand elevation as well as horizontal distance between…

Q: 2000-8", C = 100 El. 300.0 4000-16 C-100 EL 280.0 S000–10" E C-130 El. 230.0 20,000-12 C- 90 El.…

A: Estimate of pressure head at E = 250' ( other values can also be assumed, based on the assumed…

Q: A line of levels is run from BM1 to BM2, which is 12 km long. Elevation of BM1 was found out to be…

Q: (plus sights) BS (+) Station HI BMA 6.87' 1031.19' TP1 4.98' TP2 7.43' TP3 0.98' TP4 4.57' TP5 8.20'…

Q: Required to find: Tabulate the computed values accordingly. Length, Calculated Bearing LATITUDE…

Q: Replace all force -couple system by single force act at A. 240N/m R- 255. 255.415 MA- - 848.5234.P…

Q: H.W-1 Calculate the interior angels of the following travers: Line Fore bearing (F.B) АВ 130° 14' ВС…

A: Given:- Using the principles of geometry unknown angles have been calculated Alternative interior…

Q: 1. calculate various angles and support reactions. 2. Using method of joints, calculate the forces…

A: Given figure shows the truss Required- to calculate support reactions member forces and to plot the…

Concept explainers

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.

Question

A closed traverse has the following data:
Course Bearing Distance
1-2 N9.27deg.E 58.7m.
2-3 S 88.43 deg.E 27.30m.
3-4 N 88.78deg.E 35.2m.
4-5. S. 5.3deg. E 35.0m.
What is the bearing of the line 5-1?
Select the correct response:
O N. 72deg. 07 W
O S.72deg. 07 W
ON. 72 deg. 07' E

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

I need the answer to the question in surveying Engineering
The instrument used was a transit with an internal focusing telescope and a stadia interval factor of 99,Compute: a) DRAW DIAGRAMb) The Elevation at the turning point.c) The elevation at Point B.d) The gradient from A to B if all the stations are in a straight line.
The instrument used was a transit with an internal focusing telescope and a stadia interval factor of 99, compute for the gradient from A to B if all the stations are in a straight line.
Solve for unknowns. Thank you!
Example Calculate the interior angels of the following travers: Line Fore bearing (F.B) AB 70 30' ВС 132 00 CD 56° 00' DE 215° 30' EA 310 00'
Calculate the vertical index difference and vertical angle in Tab.
Module 03- Coursework Activity 04 A transit with stadia interval factor of 100.8 was set up at point C on the line between points A and B. The following readings were observed: A B ROD VERTICAL ANGLE +15-25 -09-07 1.972 1.330 UPPER HAIR READINGS MIDDLE 1.854 1.175 1.732 1.010 LOWER If the distance from the instrument to the focus is 0.38m, determine the following: a) Horizontal distance between A and B. b) Difference in elevation between A and B.
Draw/ Illustrate the profile leveling The second photo is an example of profile leveling Thank you!
HI PLEASE HELP CAN YOU HELP ME WRITE AN OBJECTIVE, INTRODUCTION AND CONCLUSION (ATTACHED PHOTO ARE THE DATA AND RESULTS). ITS ABOUT MEASUREMENT OF VERTICAL DISTANCES: DIFFERENTIAL LEVELING
A road is 12m wide a transit was set up at point A a stadia rod was setup at point C where it has a bearing of N 30deg E a stadia rod was again setup at point B where the rod reading is N35 deg E. a)What is the length of line AB b) If point C is sighted and it has a vertical angle elevation of -30degrees and point A has an elevation of 100MASL what is the elevation of point C B 12M