A closed tank with air pressure of 9 kPa contains water at a constant head of 3.5m. A jet stream exits the orifice located 0.3 from the bottom of the tank. If the base of the tank is 1.8m from the ground, how far (m) from orifice (Cy = 0.95, C =0.63) will the stream reach the ground? %3D

Q: Parts of Septic tank

A: A home septic tank system consists of underground storage and treatment of wastewater in tanks made…

Q: What is the theoretical quantity of water that flows through the samples? ml/min What will be the…

A:

Q: What is the hydraulic radius of a rectangular air duct 300 mm by 500 mm?

A:

Q: Solve maximum probable flow rate of a building plumbing system necessary for design.

A:

Q: An sewer pipe (n=0.015) is designed to carry a flowrate of 83.5 cfs when the pipe flows 0.90 full.…

A:

Q: ▼ Pump GND GWT ▼ Tank

A:

Q: What is commercial ice pack and heat pack? and how it works?

A: Many instant hot and the cold packs will function by dissolving the salt into water content. As the…

Q: Instruction: Evaluate and find all the requirements with proper, neat, and readable handwriting…

A:

Q: The Dwelling Broad Form policy provides protection for additional perils insured against, which are…

A: Dwelling Broad Form policy provide protection for additional perils insured against which are not…

Q: Identify the two different subsystems with regards to plumbing systems.

A: Answer:- Plumbing System:- For the distribution and use of drinkable or potable water and the…

Q: 6. How and where are the following valves used in the plumbing system? a) Globe b) Gate c) Angle d)…

A: a) Globe valve: The  Globe valves are usually installed when the flow of water needs to be…

Q: Ouestion- What are the three basic steps in an Air Quality Assessment? (120 words) Do not copy paste…

A: Air quality assessment is method of determining the contribution of pollutant at specific receptor…

Q: Environmental engineering- Provide all the major design parameters of a septic tank.

A: Brief concept introduction- Septic Tank- It is a wastewater treatment unit. Raw sewage enters in the…

Q: Urgent Hello please answer this problem as soon as possible. Topic is 'Fluid flow measurement' in…

A: Given data- Diameter of orifice d1 =75 mm = 0.075 mOrifice discharge Q = 23.41…

Q: Enumerate all types of valves used in a plumbing System. Define and list all its uses for each type

A: Types of Valves- 1) Sluice valve 2) Air Relief valve 3) Air Inlet valve  4) Check valve/ Reflux…

Q: ich has a specific gravity of cm. The meter is mercury specific gravity is flow rate at entrance…

A:

Q: Define Hydraulics. Briefly explain minor head losses in pipes.

A: Hydraulics is the science of conveying the motion or force of the liquid and the liquid is confined.…

Q: PERFORM PRESSURE TEST ON POTABLE WATER PIPELINE?.

A: PRESSURE TEST ON POTABLE WATER PIPELINE 1.SUPPLY PRESSURE: The pipelines usually have small…

Q: The main water service is a(n)   a-8"polyvinyl chloride pipe   b-10"round concrete pipe…

A: Polyvinyl chloride (PVC) pipe: - It is a white plastic pipe which is use for plumbing and other…

Q: How an air stripping column works?

A: In air stripping method, moving air is passed through contaminated water through which contaminants…

Q: Suppose you are a group of cadet engineers given by your department manager a "simple" task of…

A: The given data is shown below: Nominal diameter=6 inchesSchedule number=40Material of…

Q: Define the use of Pneumatic-Tired rollers ?

A: Pneumatic rollers : Pneumatic rollers also called as rubber tired rollers used with steel drum…

Q: Make a simple sketch of the septic tank and the advanced processing system (can be handwritten or…

A: As per company's guidelines we can only answer first question  Kindly post other questions as…

Q: You are the engineer supervising the layout of a piping system. In a certain portion of the pipe,…

A:

Q: Identify the type and size (mm diameter) of the Drainage Pipe in the figure. Show your solutions,…

A: Factors Affecting the Usage of Drainage Pipes Drainage of water is done through pipes in a house…

Q: allowable recovery array asymmetric membrane concentrate concentration polarization dense membrane…

A: Brief concept- Water Treatment- Water treatment is done to improve the quality of the water. The…

Q: n your home, give and describe in detail ONE example of a LAMIN

A: The fluid particles in laminar flows can be thought of as flowing in layers or laminae. The velocity…

Q: hoose the letter of the correct answer. Pipe fittings are attached to the end of pipes to allow it…

A: The part which is attached to pipe is known as pipe fitting.

Q: 1. Enumerate and Explain at least 5 types of fittings.

A: Fittings are defined as any pipe part that is used to join two section of pipes. They are detachable…

Q: Domestic Water System

A: it's a broader term describing the overall manufacturing process of breads and buns. It consists of…

Q: Draw Force Flow Diagram for the following pen: Tip Barrel

A: Flow diagrams are diagrams illustrating a flow of information within a system. As a synonym for…

Q: TEST ON PVC SEWER PIPELINE

A: Pressure Pipe:Constant Pressure Test (CPT) or Water loss method This particular test can be used for…

Q: Subject advaced fluid mechanics( bsc civil engineering ) what is drag and lift?

A:

Q: Remaining Time: 1 hour, 08 minutes 38 seconds. Question Completion Status Determine the magnitude…

A: Note: Since you have posted multiple independent questions in the same request, we will solve the…

Q: Plz write an conclusion On the application of pond water

A:

Q: Write a detailed note on following 1. Soil reinforcement 2. Ground anchors and crib walls 3.…

A: 1. The detailed note on soil reinforcement is as follows: Soil reinforcement is a technique employed…

Q: C-4 m- T .G 60° 4.5 m

A:

Q: Flowchart of how to estimate WIND LOADS

A:

Q: Describe the pressure meter test.

A: Pressuremeter:

Q: Compare sand and flow plumbing

A: Given terms- Sand & Flow plumbing, Comparison is required.