A closed tank 2.4 m long , 1.2 m wide and 1.4 m high contains water 1.1 m deep. A small hole is located near the center of the cover. It moves in the direction parallel to the 2.4 m dimension. a) Determine the acceleration needed so that the water surface will just touch the bottom of the Front wall. b) Determine the pressure at the bottom of the rear wall c) Determine the force of water acting on the top of the tank

Q: a. Horizontal component (indicate the direction) of the total hydrostatic force acting on the gate.…

A: Horizontal component (F) of the pressure force is equal to the projection of the curved surface on…

Q: The curved gate AB as shown in the figure is subjected to hydrostatic force. 5 m 3 m 'B Hinge | 15 m…

A: Solution: Given: R = 15 m depth of the projection = 15sin(1o)=0.3 m centroid = 5+d/2 =5.15 m…

Q: An isosceles triangular gate with a horizontal base 3 m long and vertex pointing downward is…

A: Using formula

Q: Problem 3 A 5-m long and 2-m wide gate contains water with a depth of 4 m as shown and is supported…

A:

Q: 1.0 A RECTANGULAR GATE 2.0 M X 5.0 M IS ACTED ON WATER ON ONE SIDE AND IS POSITIONED WITH ITS LONGER…

A:

Q: 4. A vertical semi-circular gate with a diameter of 6 m is vertically submerged in water with its…

A:

Q: 6. A circular door having a diameter of 3 m close a horizontal duct from a small dam a shown in…

A: Unit weight of water = 9.79 KN/m3 Determinea. The hydrostatic force acting on the door. b. Location…

Q: W-S. 45

A:

Q: 114 liters/second of water passes through the 30-degree elbow shaped on the side. The mass (M) of…

A: One of the crucial standards utilized in the examination of uniform stream is known as the…

Q: Each gate of a lock is 5m high and is supported by two hinges placed on the top and bottom of the…

A:

Q: closed rectangular tank measuring 4 m long, 8.89m wide, and 3m high is filled to a depth of 1.8m…

A:

Q: force acting on the gate in cer of gravity to the center

A: Given:- width=1.60m h=2.0m  inclined=8 degree To find:- force acting on gate force needed to open…

Q: For equilibrium, compute the force in part B and its orientation for the given gusset plate. 8 kN…

A: The free body diagram of the given gusset plate is as follows:

Q: a square gate 3ft x 3ft lies in a vertical plane. determine the total pressure force on the gate and…

A: Case 1, when 3ft x 3ft gate is vertically downward from the surface.Case 2, when 3ft x 3ft gate is…

Q: Problem 4 An open-topped tank with square bottom, 0.9 m on a side is 0.60 m high. It floats in…

A:

Q: A rectangular plane surface is 1.9 m wide and 2.5 m deep. It lies in vertical plane in water.…

A: As per guidelines we need to answer only first 3 subparts

Q: 3. A closed cylindrical tank 2m in diameter and 9m deep with axis vertical contains 7m deep of oil…

A:

Q: The section of a gate at the end of a tank is shown below. The length of the gate is 3 m  normal to…

A:

Q: swimming pool has a width of 4 m and a side profile as shown.  Determine the resultant force.…

A:

Q: 45 h Oil 10 cm Hinge 80 cm Water C B F 40 cm Figure Q2 (b)

A:

Q: 3.39 Find the pressure at the center of pipe A. T= 10°C. Oil (S = 0.8). Water. 90 cm 150 cm Water 30…

A:

Q: 300 N 400 N A B 1 m 2 m 2 m

A: To find the forces at b is depends on the equilibrium equations,…

Q: Determine the height of water “h” above the top of the circular 1.24m diameter gate which will cause…

A:

Q: A sliding gate of height 1.4m and width 2.8 lies in vertical plane that weighs 25kN. Determine the…

A: Pressure at a point: The pressure at a point in fluids is defined by pascal's law. Pascal's law…

Q: A rectangular gate 1.2 m by 3 m is inclined 60° with the horizontal. The top of the gate is…

A:

Q: A gate 1.80 m wide and 2.70 m high has a hinge (axis of rotation) at A. The gate separates water on…

A:

Q: A cantilever beam of clear span 2 m is built into a wall of 30 cm thickness. The beam carries a…

A:

Q: . A rectangular gate 1.20 m wide rests against a smooth wall at A. It is hinged at B located at 5.2…

A:

Q: 45° SG = 0.86 | 50 cm A %3D Hinge 10 cm SG = 1.23 80 cm В

A:

Q: A vertical gate of height 5 m and width of 3 m opposes the water at one of its sides. The deep of…

A:

Q: 1. A tank is filled to a depth of 5 feet of water and is 8 wide by 10 feet long. Determine the…

A: Note- For question no 2, kindly repost this question by mentioning which question you want to be…

Q: A 3-m-wide, 8-m-high rectangular gate CD is located at the end of a rectangular passage that is…

A:

Q: Water flows in the bend shown in figure at a rate of 5 m3/s, and the pressure at the inlet is 650…

A: To solve this problem, we will use Bernoulli equation. Therefore, we will calculate all the terms…

Q: The top of a rectangular gate 1.20 m wide rest against a vertical wall at A. The bottom of the gate…

A:

Q: 2. Figure 2 shows a 0.8 m wide of rectangular sluice gate is hinged at point A on the wall of a…

A:

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?